Exhaust steam from an engine passes into a condenser at a pressure of 0.12 bar and dryness 0.88. The temperature of the condensate from the condenser is 40°C. The circulating water enters the condenser at 12°C and leaves at 29°C. Calculate the mass of circulating water per kg steam condensed. Steam Properties: Steam at 0.12 bar (0.012 MPa) he = 207 kJ/kg hfg hg = 2383 kJ/kg Water Properties Water at 40°C Water at 29°C Water at 12°C h = 167.5 kJ/kg h = 121.5 kJ/kg h = 50.4 kJ/kg A. 26.71 kg B. 28.05 kg C. 30.04 kg D. 32.86 kg

Exhaust steam from an engine passes into a condenser at a pressure of 0.12 bar and dryness 0.88. The temperature of the condensate from the condenser is 40°C. The circulating water enters the condenser at 12°C and leaves at 29°C. Calculate the mass of circulating water per kg steam condensed. Steam Properties: Steam at 0.12 bar (0.012 MPa) he = 207 kJ/kg hfg hg = 2383 kJ/kg Water Properties Water at 40°C Water at 29°C Water at 12°C h = 167.5 kJ/kg h = 121.5 kJ/kg h = 50.4 kJ/kg A. 26.71 kg B. 28.05 kg C. 30.04 kg D. 32.86 kg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In the condenser of the power plant, Ammonia is isobarically condensed to saturated liquid state with 615.2kPa and x = 0.9, the mass flow rate is 4 t/h. The heat rejected from the condensing ammonia is added to heat water, which is heated from 277K to 281K. What is the mass flow rate of water in t/h. Also sketch the T-s and P-v diagrams.
Atmospheric air at 40°C dbt and 55% RH is passed over a cooling coil at the rate of 600 m'/mint. At exit from coil the air is saturated and its temperature is 8°C. The condensate also leaves at 8°C. Determine the amount of condensate leaving coil per minute and refrigeration in kW, The specific heat of superheated steam may be assumed to be 1.88 kJ/kg-K. Solve the problem without psychromatic chart.
Steam at a rate of 200 kg/min enters a turbine at 350°C and 40 bar through a 7.5-cm internal diameter pipe. The turbine operation is adiabatic, and the effluent leaves as saturated water at 5 bar through a 5-cm diameter pipe. 1. Calculate the work produced by the turbine in kW. 2. What is the enthalpyand phase of the effluent stream? 21 If it leaves the turbine at 75C and 5 bar 22 If it leaves the turbine at 30C and 5 bar 7.5
A reheat cycle with two stages of reheating is executed with steam expanding initially from 25 MPa and 600 °C. The two reheater pressures are 4 MPa and 1 MPa, and the steam leaves each reheater at 600 °C. Condensation occurs at 40°C. What is hi in kJ/kg?
1. A refrigeration system using R-22 has a capacity of 320 kW of refrigeration. The evaporating temperature is -10°C and the condensing temperature is 40°C. Calculate the fraction of vapor in the mixture before the evaporator. Properties of R-22: At -10°C; hg = 401.60 kJ/kg, hf = 188.43 kJ/kg At 40°C; hf 249.69 kJ/kg
Atmospheric air at 40°C dbt and 55% RH is passed over a cooling coll at the rate of 600 m/mint. At exit from coil the air is saturated and its temperature is 8°C. The condensate also leaves at 8°C. Determine the amount of condensate leaving coll per minute and refrigeration in kW. The specific heat of superheated steam may be assumed to be 1.88 kJ/kg-K. Solve the problem without psychromatic chart.
4. The refrigerant 134-a enters the compressor of a refrigeration machine as superheated vapor at a flow rate of 0.12 kg/s, a pressure of 0.14 MPa, and a temperature of -10 °C. It exits at a pressure of 0.7 MPa and a temperature of 50 °C. The refrigerant exits the condenser at a temperature of 24 °C and a pressure of 0.65 MPa and is then throttled to a pressure of 0.15 MPa. Show the cycle on a T-s diagram, including the saturated liquid and saturated vapor lines. Also, a) Calculate the heat extracted from the environment per unit time and the power required to operate the compressor, b) The isentropic efficiency of the compressor, c) The coefficient of performance of the refrigeration machine. Note: This is a question from the thermodynamics course. Please provide a clear and prompt solution.
The condensing pressure for a Rankine engine is 1 bar (hf= 417.4 kJ/kg). Calculate the net work for 1 kg/s of steam and the thermal efficiency when the steam at the beginning of expansion is at 50 bar and (a) saturated (b) 350°C and (c) 640°C. Note the variation of efficiency and the quality at the end of the expansion.
Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam is extracted for feed water heating at 0.6 MPa. The turbine exhaust is 60 degree C. the required values of some state point properties are tabulated below. 7. Determine the quality of steam at the condenser inlet.
Problem (8.1) The steam at 100 bar and 500°C is supplied to a steam turbine of 30 MW capacity. The vacuum maintained in the condenser is 71 cm of Hg when the barometer reads 76 cm of Hg. The steam coming out of the turbine is condensed in a surface condenser using river water for cooling. The rise in temperature of the cooling water is limited to 10°C. The temperature of the water at the inlet of the condenser is 20°C. The condensate comes out of condenser as saturated liquid. Find (a) the mass of steam supplied to the turbine per hour, (b) Capacity of the pump to circulate water, (c) the heat transfer area of the condenser if the overall heat transfer coefficient is 400 W/m²°C.
A jet condenser discharge water at 37°C with inlet cooling water at 8°C, condenser pressure is 0.01 MPa. Calculate the kg of condensing water per kg of exhaust steam with a quality of 88%. Steam and water properties:h2 = 2297.49 KJ/kg, h at 0.01 MPa and 88% qualityh1 = 33.06 KJ/kg, hf at 8°Ch3 = 155 KJ/kg hf at 37°C
Problem (8.1) The steam at 100 bar and 500°C is supplied to a steam turbine of 30 MW capacity. The vacuum maintained in the condenser is 71 cm of Hg when the barometer reads 76 cm of Hg. The steam coming out of the turbine is condensed in a surface condenser using river water for cooling. The rise in temperature of the cooling water is limited to 10°C. The temperature of the water at the inlet of the condenser is 20°C. The condensate comes out of condenser as saturated liquid. Find (a) the mass of steam supplied to the turbine per hour, (b) Capacity of the pump to circulate water, (c) the heat transfer area of the condenser if the overall heat transfer coefficient is 400 W/m²°C. Ans.[(a) 22.5kg/s, (b) 926.6 kg/s, (c) 7,135 m²|