can you explain this question? > Ex. 3-2Determine the tension in cable BC and BA necessary toSupport the 60 kg cylinder shown in the figure?450B Ex. 3-4Determine the required length of the cord AC,So that the 8 kg lamp can be suspended in theposition shown. The unreformed length ofSpring AB is l'AB = 0.4m , and the spring has astiffness of kaR = 300N/m ?-2 mkAn = 300 N/mАВ%3DABwww

When three forces are in static equilibrium , the net external force acting on it is equal to zero.…

Answered: Ex. 3-2 Determine the tension in cable…

Engineering

Mechanical Engineering

Ex. 3-2 Determine the tension in cable BC and BA necessary to Support the 60 kg cylinder shown in the figure? B

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The given truss structure is loaded by a force F at the joint D and is to examine their buckling…

A: Sin 30=xL x=12×L tanθ=LL+L2 tanθ=⊻32⊻ θ=tan-123…

Q: 4- The minimum force required to slide a body of weight W on a rough horizontal plane is A. W sing…

A: Given: Weight of the block, W. Let the force acting on the block be P. Consider the angle made by…

Q: 6-79 Bar AB is used to support an 850-lb load as shown in Fig. and-socket joint. End B of the bar is…

A: Given that,

Q: The system in the figure is in equilibrium. A concrete block of mass 230 kg hangs from the end of…

Q: - Ex. 3-2 Determine the tension in cable BC and BA necessary to support the 60 kg cylinder shown in…

A: When a given system is in equilibrium, then the net external force acting on the system is equal to…

Q: A 363.8N horizontal steel shaft is suspended by a vertical cable from A and by a second cable BC…

A: Consider the free body diagram shown below for the given system.

Q: The simple truss is loaded by a system of forces as shown in the figure. The truss is supported by a…

A: (1) Given-

Q: 4-10. The dimensions of a jib crane are given in the figure. The crane has a mass of 800 kg and a…

A: Given data: Maximum resultant load at A, RA = 24 kN Maximum resultant load at B, RB = 34 Kn Mass of…

Q: The system in the figure is in equilibrium. A concrete block of mass 243 kg hangs from the end of…

A: (a) Tension in wire, T = 1686.73 N. (b) Horizontal reaction at hinge, Rx = 1466.6 N→. (c) Vertical…

Q: The tower crane of Fig. is rigidly attached to the building at F. A cable is attached at D and…

A: The free body diagram explains the problem

Q: 6-41 A 30-lb force P is applied to the brake pedal of an automobile as shown in Fig. applied to the…

A: Draw the free body diagram of the given brake pedal: Here, AX is the horizontal force at A, and AY…

Q: P4-6. Determine the force P to move block B. W = 100 N A,-02 W = 100 N H,- 0.2 w = 200 N 4.-0.1

A: Given data as per the question Weight of block A = 100 N Weight of block B =100 N Weight of block C…

Q: 3-31. If the bucket weighs 50 lb, determine the tension developed in each of the wires.

Q: 4-42. Determine the horizontal and vertical compo- nents of the pin reaction at B of Fig. P4-42 on…

A: Given: The frame is shown below:

Q: 3.18. A block with a mass of 150-kg is supported by a cable which passes over a 150-mm diameter…

A: Given Data Mass of the block is : m=150 kg Diameter of pulley is :d=150 mm Now from the free body…

Q: 3-34. Each cord can sustain a maximum tension of 20 lb. Determine the largest weight of the lamp…

Q: A force of 150 Ib acts on the end of the beam shown in Fig. 5-16a. Determine the magnitude and…

A: givenbeam rope system as shown below

Q: Ex. 3-2 etermine the tension in cable BC and BA necessary to upport the 60 kg cylinder shown in the…

A: Given:mass of the cylinder, m=60 kg

Q: 4-18. A boy stands out at the end of the diving board, which is supported by two springs A and B,…

A: Weight can be calculated as W=mg W=40*9.81 W=392.4 N Free body diagram of board.

Q: Determine the coordinates of D in the YZ plane so that the force in CD will be a minimum.

Q: B 45° 30° 60° E D

Q: 3-23. Determine the unstretched length of spring AC if a force P 80 lb causes the angle 6 60° for…

Q: is being 6-66 The garage door ABCE shown in Fig. raised by a cable DE. The one-piece door is a…

A: Given data

Q: Q3: The man is applying a force of 100N to the box. A mass of 300N is placed on an inclined plane as…

Q: 3-31. The springs on the rope assembly are originally stretched 1 ft when 0 = 0°. Determine the…

Q: The truss in the figure is loaded by four external forces as shown below. Knowing that P1= 3 kN,…

Q: · 400 mm- 1. A block with a mass of 150-kg is supported by a cable which passes over a 150-mm…

A: Given data: - The mass of the block is m = 150 kg. The distance between AB is h = 450 mm. The…

Q: 4-53 The supporting structure of the billboard is attached to the ground by a pin at B, and its rear…

A: Given Data: The combined weight of the billboard and structure is, W=2800 lb. The weight placed…

Q: The simple truss is loaded by a system of forces as shown in the figure. The truss is supported by a…

Q: 4-76 The bars AB and AC are joined by a pin at A and a horizontal cable. The vertical cable carrying…

Q: 3-23. Determine the unstretched length of spring AC if a force P 80 lb causes the angle 0 = 60° for…

Q: The truss in the figure is loaded by four external forces as shown below. Knowing that P1= 30 kN,…

A: Note: As per the policy, we can solve the first 3 subparts. Please resubmit the remaining parts.

Q: •3-49. Determine the maximum weight of the crate so that the tension developed in any cable does not…

A: Given Data: The maximum tension in the cable should be Tmax=450 lb. The coordinate of point…

Q: a). A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is 5. held in place…

A: Given:- Mass of crane (m) = 1000 kg Mass of crate (M) = 2400 kg To Find:- Draw free body diagram…

Q: Ex. 3-2 Determine the tension in cable BC and BA necessary to Support the 60 kg cylinder shown in…

A: When a given system is in equilibrium, then the net external force acting on the system is equal to…

Q: 3. Figure Q1 shows a device that is used to hold an elevator door open. If the spring has a…

Q: Q1 -A- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a…

Q: 3-13 Two flower pots a supparted with cables as shown in Fig. P3-13. If pot A weighe 10 lb and pot B…

A: The given problem will be solved by using lamies theorem. The complete solution is attached.

Q: 4-74 For the frame shown, determine the magnitude of the pin reaction at B. Neglect the weight of…

Q: *3-12. The concrete pipe elbow has a weight of 400 lb and the center of gravity is located at point…

A: Given, W = 400 lb Consider below FBD for elbow: Here, TBCh = TBC cos 45TBDh = TBD cos 45TBCv =…

Q: *3-48) Determine the tension in the cables in order to support the 100-kg crate in the equilibrium…

Q: 3-32. Determine the forces in all the members of the complex truss. State if the members are in…

Q: (Q3] (a) Support A is ball and socket while at Z there exists a frictionless slot as shown in the…

Q: The steel cable is hoisting a 2,000N weight. Assume the weight is not accelerating and the cable is…

A: A pin support will exert both horizontal and vertical components of reaction. The support B is pin…

Q: 1. The system in the figure is in equilibrium. A mass of 225 kg hangs from the end of the uniform…

Q: Select the distance a between 2 m and 5 m and the force P between 15 kN and 35 kN in the cage system…

Q: The uniform rod AB has a mass of 140-kg and it is supported as shown in the figure. If the applied…

A: given data: mass of rod=140kg weight of rod(W)=mg=140*9.81=1.37KN force(F)=1.4KN reaction at A=??

Q: 3-5.6. The weight of the trapezoidal block is hown in Fig. P-3-5.6. The ground reaction varies…

Q: The uniform plank ABC weighs 400 N. It is supported by a pin at A and a cable that runs around the…

Question

can you explain this question?

> Ex. 3-2
Determine the tension in cable BC and BA necessary to
Support the 60 kg cylinder shown in the figure?
450
B

Ex. 3-4
Determine the required length of the cord AC,
So that the 8 kg lamp can be suspended in the
position shown. The unreformed length of
Spring AB is l'AB = 0.4m , and the spring has a
stiffness of kaR = 300N/m ?
-2 m
kAn = 300 N/m
АВ
%3D
AB
www

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The rigid body is supported by a hinge at A and a cable at C. The hinge resists 5.5m translation in all three coordinate directions and rotation in the x and y directions. The 260 N force is in the -x direction and acts at the center of the 3m body. Find the tension in the cable and the components of the support C 2.5m 260N reactions at A. Your answer should include a properly Ilm annotated FBD. B 3.Im
3. Determine the tension in cables BA and BC necessary to support the 75-kg cylinder in the figure below. 30 degrees
PROBLEM 2 For the figure shown, determine the following if the mass of the person is 50kg and the tension in Cable C is half of the tension in Cable A. The tension in Cable B is 1.5 times the tension in Cable A. 10-12. Tension in Cable A A 13-15. Tension in Cable B 1m 3m 2m 2m 16-18. Tension in Cable C W 19-21. Weight of Block W PROBLEM 3 The 4.0m strut is supported by a hinge at A and a Tension cable 3m from the left end at an angle of 30°. Determine the following if W=75N and weight of the strut is 45N. 22-24. Tension in the Cable 3m 1m 25-27. Horizontal Reaction at Hinge A 28-30. Vertical Reaction at Hinge A. W
The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B.A force P is applied at B where P= 20i - 14j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Calculate the magnitude of the reaction force at A in kN. of stion 2m 4 m. 6 m Answer: 5 Calculate the magnitude of the tension in cable BD in kN. of Answer:
The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B. A force P is applied at B where P = 19i - 10j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Calculate the magnitude of the reaction force at A in kN. 2 m 4 m 6 m B y Answer: Calculate the magnitude of the tension in cable BD in kN. Answer: Calculate the magnitude of the force in member BC in kN. Answer: Determine the magnitude of the moment of P about the x-axis in Nm. Answer: Determine the magnitude of the moment of P about the y-axis in Nm. Answer: Determine the magnitude of the moment of P about the z-axis in Nm. Answer: Determine the magnitude of the moment of P about the origin (point O) in Nm. Answer: (2 m
The boom AC in the figure rests in a ball and socket joint at A and is held in equilibrium by the cables BE and CD. The load applied at C. Determine the coordinates of D in the YZ plane so that the force in CD will be a minimum. Neglect the weight of the boom and cables. Answers: y = 16ft ; z = -34.7ft ( Please i need the solution)
A bar AE is in equilibrium under the action of the five forces shown in Figure. Determine T, P, and R.
4. The access door in Fig. P6-13 is held in the position by cable AB. If the magnitude of tension T in the cable is 50 pound force, find the rectangular components of T acting at A. 10 in. B 10 in. 12 in. 6 in. 20° FIGURE P6-13
The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B. A force P is applied at B where P = 14i - 15j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Calculate the magnitude of the reaction force at A in kN.
The cylinder C in the figure below weighs 1000lbs. Determine the tension in the cable , and the reactions A and F
Determine the tension in the rope at point A and the reactions at the pin support at point B. (The 600 lb force points downward to the left on the figure.)
3-7 The collar A shown in Fig. P3-7 is free to slide on the smooth rod BC. Determine the forces exerted on the collar by the cable and by the rod when the force F = 900 Ib is ap- plied to the collar. 30 20 Cable F= 900 lb