ENGINEERING DATA ANALYSIS SHOW SOLUTION A developer of a new subdivision offers a prospective home buyer a choice of 5 designs, 3 ditterent air conditioning systems, a garage or a carport, and a patio or screened porch. How many plans are available to this buyer? Answer: 60 plans

Q: A thin 6-ft-wide, right-angle gate with negligible mass is free to pivot about. portion of the gate…

A:

Q: A field measures 40 hectares. When 8 cumecs of water was supplied for 6 hours, 30 cm of water was…

A:

Q: 3. Using the geometric method, determine the amount of excavation required for a 24-foot by 50-foot…

A: Basement dimension: 24 ft x 50 ft Excavation depth = 7 ftExtended footing = 1 ftSpacing = 3 ft

Q: In a 12cm diameter pipe, the major losses are equal to 5.0v²/2g. Find The equivalent length of pipe…

A: Diameter of pipe = 12 cmMajor losses = 5 v2 / 2gf = 0.04 To Find :THe equivalent length of pipe ?

Q: A cast iron pipe having a diameter of 100 mm is used to fill the cylindrical tank with water at T =…

A:

Q: Determine the thickness of the boundary layer at the trailing edge of a smooth plate of length 4m…

A:

Q: determine the capacity of the details shown below. A992: Fy=50ksi, Fu=65ksi A36: Fy=36ksi, Fu=58ksi…

A:

Q: The reinforced concrete element will support the floor of a swine barn over a manure pit. The column…

A:

Q: 3) Solve for the support reactions of the beam shown below using MDM. Assume beam is prismatic and…

A: To Analyse the given beam by MDM and to draw the Shear and Moment Diagram

Q: 4. A crawler hoe having a 2 %-cy bucket and whose cost per hour, including the wages to an operator,…

A: Bucket capacity (V) = 2.25 cy Cost per hour = $67/hr Depth of the digging = 20 ftIt is asked to…

Q: SAMPLE PROBLEM The 2225-N block is in contact with 45° incline. The coefficient of static friction…

A:

Q: The channel is made of unfinished concrete. (Figure 1) Figure -5 ft- 1 of 1 > Part A Determine the…

A: Volumetric flow, Bottom width of channel, SlopeTo find: The critical depth of the channel.

Q: - x²). dy = 80 mm. dy Part A Determine the moment of inertia of the are Express your answer to…

A: The moment of inertia of an object is the changes to the resistance in the rotation. The maximum…

Q: An inclined tank contains three different liquids A, B, and C with specific gravities of 0.40, 1.25,…

A: An inclined tank contains three different liquids A, B, and C with specific gravities of 0.40, 1.25,…

Q: QUESTION:Draw the shear and moment diagram for each member. Include computations for support…

A: Draw the shear force and bending moment diagram of the frame.

Q: Determine the x, y, z components of reaction acting on the ball-and-socket at A, the reaction at the…

A: Uniformly distributed load acting on portion ABCouple moment acting along x-axisTo find:Components…

Q: Calculate the service load capacity in tension for an L6x4x1/2 of A36 Grade 36 steel connected with…

A: L6x4x1/2 sectionA36 steel grade: Fu = 58 ksi, Fy = 36 ksibolt, bolt hole,  The live load to dead…

Q: Q2) Determine the angle 0 where the moment about point B is equal to zero for the given force below.…

A:

Q: Design a 17-ft tall rectangular tied column A-B in a braced frame to support an unfactored axial…

A:

Q: A cantilever beam caries a varying load over a span of 9 meters. If the load increases from 0 kN/m…

A:

Q: A horizontal beam AB with dimensions of its cross section (b = 19 mm) x (h = 200 mm) is supported by…

A:

Q: When movement of a wall under the earth pressures from the backfill was prevented the coefficient of…

A: We have to find the ratio of the coefficient of passive and active earth pressure

Q: Draw the shear and moment diagram of the beam. Include computations for support reactions.

A: Given:Required:Shear and moment diagram

Q: A public school holds its flag ceremonies every Monday from 7:00 AM to 7:15 AM. During the singing…

A: q= 1800 vphv= 30 kphk= 80 veh/km and v= 0 kphk= 40 veh/km and q =1000 vphTo find:Characteristic of…

Q: A single pile, 50 cm in diameter and 16 m long, is driven in clay having an average unconfined…

A:

Q: The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 11 mm².…

A:

Q: Locate the centroid of the area shown belo 12" Y-axis 4" 6" 1" 9" 2" X-axis

A:

Q: Determine the efficiency of removing particles of size 50 μm and density 1,100 kg/m², settling in a…

A: Particles size, d = 50 μm or 50 x 10-6 m Density of particle,  = 1,100 kg/m²Length = 10 m .Flowrate,…

Q: A single dueling house has interior columns that are spaced 4.2 m apart in two perpendicular…

A: S = 4.2 mLL = 1.2 kN/m2

Q: Determine the minimum radius of gyration for the column cross and find the slenderness ratio of the…

A: E = 72 GPaa) The minimum radius of gyration for the column crosses the slenderness ratio of the…

Q: A normally consolidated clay layer settles 1 cm when the pressure increases from 1 kg/cm² to 2…

A:

Q: ntilever beam caries a varying load over a span of 10 meters. If the load increases from 0 kN/m at…

A:

Q: O 50 mm 50 O 100 mm O 75 mm 100 100 50 75 e 9 75 For a failure through the staggered line abfcd,…

A:

Q: Using this problem for 9-10. The casting has a mass of 3 Mg. Suspended in a vertical position und…

A: The mass of casting m= 3 Mg = 3000 kgThe upward velocity of casting, v= 200 mm/stime, t= 0.3s

Q: Solution is done neatly, using same solution what would happen If the slope is increased to 0.001,…

A: Data from the follow-up:b = 12.5 ftZ = 1.1Area = 17.34 ft2Perimeter = 16.216 ftHydraulic depth =…

Q: Which of the following best represents the concept of redundancy gain? A yellow warning sign adds…

A: The concept of redundancy gain is best represented by "A fire department adds another set of…

Q: QUESTION 1 The galvanized iron system has two pipe diameters, BC at 6 in and CE at 3 in The gate…

A: Diameter of pipe BC, Diameter of pipe BC, Kinematic viscosity, To find: The type of flow in pipe BC.

Q: Problem 2: Water at 20°C flows through the elbow shown in Fig. 1 and exits to the atmosphere. The…

A:

Q: Determine the reaction at A in kN. W = 80 kN/m P = 1100 KN L1 = 6 m L2= 2 m A B L1 W a D L2 E

A: The vertical reactions acting on the beam are considered.Vertical forces = downward forcesReaction…

Q: A square pile of section 30 cm x 30 cm and length 10 m penetrates a deposit of clay having c = 5…

A: Now We have to determine the load

Q: Use the graphical method to construct the shear-force and bending-moment diagrams for the beam…

A: To draw SFD and BMD using grpahical method

Q: Problem No.1: Determine the maximum factored load Wu (use unit weight of concrete = 24kN/m³) for the…

A:

Q: 3-4. Determine the force in each member of the truss. State if the members are in tension or…

A: Determine the force on each member of the truss. Let's solve using method of joints

Q: QUESTION 4 The flow rate out of B is 0.03 m³/s Pipe 1 has a filter 9810 N/m³ and v=1 (106) m²/s A 50…

A:

Q: Q5\\ What is the type of flowrate of particles 400 um diameter floating in flowing liquid giving the…

A: D = 400 micro meter or 40 x 10-6 m V = 2 m/s  = 128000 kg/m3 = 500 kg/m3

Q: Lake Mead near Hoover Dam in Nevada is the largest manmade lake in the U.S.  It contains 28,537,000…

A: Water coverage = 28,537,000 acre-ftObjective:To find the volume of water in gallons and m3.

Q: Determine the maximum flow for a section of road with the relationship given as u= 53-0.43k where u…

A:

Q: What is the area under the shear diagram between B and C for the beam shown? Use the method of…

A: We will use method of consistent deformation to find reaction at point A and using that reaction to…

Q: A dead load of 3 kips and a live load of 9 kips make up the load at each of the points A, C, D, and…

A: To find the gross sectional area of the member A-H.Fy = 36 ksi

Q: Design a spiral round short column to carry 250 kip of dead load (including self-weight) and 500 kip…

A: Dead load, Live load, Eccentricity, Main bar , StirrupClear cover, Yield strength of steel,…