Electronics Home Work the circuit shown in figure. Assume the diode to be ideal. :R2 R1 R3 س: جد التيار المار في الديود في الدارة المبينة | Q: Find the current I through the diode in | الشكل التالي. اعتبر الديود مثالي. 41 T٤2 D R1 = 202 R2 = 102 2 = 47

Q: 1kO A Vi Vị -o Vo1 20 V lo V 5.3V 7.3V -20 V

A: Actually this is question is wrong. It contradict KVL for the input voltage range(0<Vi<8V).…

Q: For R1=58, R2-162, R3=243 and 13-5.5 A in the shown circuit, use KCL and KVL to find the following:…

A:

Q: R = 100 R2 = 402 For the circuit with the known values of its elements indicated in the figure and…

A:

Q: 1) Calculate the potential drop across the parallel array composed of R2 and R3 only. 2) How many…

A:

Q: ww R₂ V$1 = 1.5 V R₂ Vs2 = - 3.0 V R₁ = 1.1 [kn] R₁ = 4.7 [KO] R₂ = 150 [0] R₁ = 2.2 [ks] • Write 2…

A:

Q: Determine the value, tolerance, and coefficient of temperature (if applicable) of the following…

A: The color bands in a resistor are split into two sections. The resistance is shown on the left,…

Q: Q12. In center-tapped rectifier, there are more stresses on the diodes compared to half wave single…

A: The peak inverse voltage in center tapped rectifier is 2Vm   The peak inverse voltage in half wave…

Q: Determine the value, tolerance, and coefficient of temperature (if applicable) of the following…

A: 1. Determining the first Band We cannot simply read from right-end or left-end. We need to figure…

Q: Q.8. Prove KVL and KCL by applying it to two loops and two nodes in the given circuit V = 40 V R =…

A: According to Kirchhoff's Voltage Law, the algebraic sum of all the voltages in a closed loop of a…

Q: Complete the table of values for this circuit

A:

Q: A dead battery is charged by connecting it to the live battery of another car with jumper cables…

A: Given:- R = 2.16 ohm  r= 0.08 ohm  R1 = 0.01 ohm  V1 = 12 V V2 = 10 V Find:- a) Determine the…

Q: design aistable multivibrator using multisim by using 555 timer IC and also by using transistor?

A:

Q: A) A transformer for a transistor radio reduces 120 V ac to 9 V ac (Such a device also contains…

A: It is given that,

Q: Three resistors with resistances R1 = 0.35 ohm, R2 = 5.92 ohm, %3D %3D and R3 = 8.26 ohm are is…

A:

Q: What will be the steps to perform the ohm's law experiment in the laboratory?

A: Base : we use breadboard or common insulated wires for making the circuit  Connect the resistor on…

Q: What is the potential of battery in image below? What is the potential drop across resistor in the…

A:

Q: The current in the circuit below is 1 A. The potential at point G is 481 V. Determine the potential…

A:

Q: z = 2A I1 = 7A I3 |14= 3A ЗА %3| A. -8 A B. -2 A C. 2 A D8 A E E. No answer

A: Given Data : The value of current I1 = 7 A. The value of current I2 = 2 A. The value of current I4 =…

Q: Capacitor A has C1=0.25 uF and Capacitor B has C2=0.10 uF. Solve for the following quanties. SERIES…

A:

Q: In the circuit below, find the currents I1, 12, 13. Use the constant voltage drop model. Be sure to…

A: Given: To calculate the current that flows through I1, 12, 13.

Q: A sample of Si is doped with 1016 phosphorus atoms /cm³, find the Hall voltage in a sample with…

A: The data given is as follows: 1. Doping,  n=1016 atoms/cm3   =1016 atoms/10-6 m3n=1022 atoms/m3 2.…

Q: The interaction volumes for a variety of SEM accelerating voltages is shown. Which schematic drawing…

A: Concept used: Accelerating voltage means voltage of a charged particle in a straight line.

Q: R4 = 2N, :V½ = 5 V Rq = 4 N{ EV½ = 12 V R2 = 3 N R3 = 2N 12 13 Solve for the potential differences…

A:

Q: Approximate the current at the midpoint of the incoming data 7.2, 7.3, 7.4, 7.5, 7.6, ... where the…

A: Given two data sets. .... 7.2, 7.3, 7.4, 7.5, 7.6,............. (first data set) 0.00242759 (D1)…

Q: Given the circuit below: R1 = 100 2 R2 = 200 2 E R5 = 300 2 R3 = 1002 R4 = 150 2 %3D R6 = 1002 What…

A:

Q: 3. Figure 3 shows a section of a circuit. The resistances are R1 = 2.0 N R2 = 4.0 N, and R3 = 6.0 N,…

A: Combination of resistances in a circuit:

Q: CB Electronix must buy a piece of equipment to place electronic components on the printed circuit…

A: Least first cost is for 2nd option is zero. Next least first cost is for option 3 =170,000 Comparing…

Q: If the diode opens in Figure 16-1(b), the voltage across the diode is Figure 16-1 OOV 0.7 V 01v 4.3…

A: This question is from diodes chapter

Q: a) determine the potential difference across each resistor in terms of E b) determine the current in…

A:

Q: A: 5 volts R1= 1 I2 R2=2 I3 R3 = 4 B: 8 volts find I,,12,13 Select one: a. I, =2,1,=2,1,=1 b. I,…

A:

Q: a) I, b) Vp y Vs c) Vcs 12 V 3 kn 4 V Ves 8-3 V

A: Solution:   Given Values, VDS= 4 V VSS=-3 VVDD=12 VRD=3 KΩRS=2 KΩ

Q: A circuit is constructed with five capacitors and a battery as shown. The values for the capacitors…

A:

Q: For the following circuit in the figure below. Determine V,-V, ( in units of V) for a = 45.7 V a 22…

A: TO SOLVE THIS PROBLEM WE ARE GOING TO USE KIRCHOFF VOLTAGE LAW

Q: I, 20V I3 20 V 2 S 32 40V 40 V De termine flow ing current in lout junction A.

A:

Q: + 12 V

A: Common emitter current gain=100 The biasing is feedback bias or collector bias.

Q: R = 40 R2=40 h=4 A 24 V WWMW R3= 82 R=10 2 As = ? The total current in this circuit is 4 amps. the…

A:

Q: using the transfer function Vo(s)/V:(s) using Simulink and matlab For C= 1.4 mF, L= 0.06 H, R1 = 120…

A:

Q: In the circuit below, V. = 8 V, V = 43 V, R = 7 2, & R2 = 2 2. Determine the current through R1, R2,…

A:

Q: The total current for the circuit below is 8 Amps. The first and third bulb both have a current of 2…

A: By junction law current is conserved.