Answered: El 2 m Liquid A (s.g = 0.72) Figure 1…

Engineering

Civil Engineering

El 2 m Liquid A (s.g = 0.72) Figure 1 %3D El 0.3 m Liquid B (s.g 2.36) El %3D .0m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Calculate the surface tension of the fluid (SG = 8.6) in the capillary tube below: Зтт h = 2mm e =…

Q: Aliquid of density 900 kg/m³ rises to a height of 7 mm in a capillary tube of 2 mm Internal…

A: Density of the liquid, The angle of contact of the liquid in the glass, The diameter of the…

Q: This is an open-top cylindrical tank* height of tank = 4 meters diameter of tank = 2 meters The…

Q: A gate is submerged under two fluids as shown and is hinged at A. On the other hand, B is a H20 3m…

Q: For the pressure vessel containing glycerin, with piezometer attached as shown, what is the…

A: Note:- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: Oil of sp.gr. of 0.750 flows through the nozzle shown and deflects the mercury in the U-tube gage.…

A: The given data is shown below: Specific gravity=0.75Pressure at A=142 kPa

Q: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom, A 2.0 m…

A: Given: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom,…

Q: a. Celerity of the pressure wave b. Equivalent bulk modulus of water c. Pressure on the pipe after…

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

Q: A rigid, insulated vessel is divided into two compartments connected by a valve. Initially, one…

Q: weight of the liquid. 4. The absolute pressure in water at a depth of 8m is read to be 175 kPa.…

Q: A cylindrical tank of oil (sg 0.8) is 8m in diameter and 15mm thick. If the tank is to be completely…

A: D=8m t=15mm

Q: find the force ate.

A: To find : Force exerted by oil upon gate Given: pipe line which is 6 m in diameter contains a gate…

Q: Water is pumped from an elevated pool to a tank that is initially empty. The height from the water…

A: Given: Water is pumped from an elevated pool to a tank that is empty. The height from the water…

Q: Air is drawn into a wind tunnel used for testing automobiles as shown in the figure below. (a)…

Q: Water has a surface te the liquid rises 6 mm a contact angle.

Q: Find the value of pressure at dpeth of 12.5 m from free surface of water Tale density of water 10…

A: To Determine Value of pressure, P Correction in question Value of Density given in question is the…

Q: 8.8 The spherical gas tank is made of steel (E = 29 × 106 psi, v = 0.3). The inner radius of the…

A: Data is as given

Q: a.) Determine the pressure difference between the two vessels when the difference in the levels of…

Q: Determine the number of fins and overall fin efficiency using Figure 2.7. (c) Determine the total…

Q: Find the capillarity rise in the tube shown in the figure (below) for a water-air-glass interface…

A: Given data : Tube radius (r)=1 mmAngle of contact (θ)=0∘Density of water (ρ)=1000 kg/m3Assume…

Q: The triangular valve (AB) which weighs 1500 Newtons closed at point A and is free at point B. What…

A: Length of the gate t=2sin50o=2.6108 m Depth of center of gravity from surface of water…

Q: A spherical pressure vessel has an inside diameter of 6 m and a wall thickness of 15 mm. The vessel…

A: Given: Spherical pressure vessel Inside diameter Thickness Internal pressure Yield strength

Q: stion 24 The initial pressures at A and B are the same at 103 kPa. If the pressure at the liquid at…

Q: Regarding the Bernoulli effect in the pump, select the correct statement. O As water flows past…

Q: The gage pressure in a liquid at a depth of 2.5 m is read to be 26 kPa. Determine the gage pressure…

A: Given Data Gauge pressure at depth of 2.5m (P2.5) = 26 kPa Determihe the gauge pressure in the same…

Q: The open tank with piezometers attached on the side, contains two different liquids. Find the…

A: As the liquid in piezometer A and liquid in tank above the installation point of piezometer A is…

Q: Q1: A pressure of 10 kPa, gage, is applied to th surface of water in an enclosed tank as showi in…

A: to find actual discharge

Q: open tank contains 5.7 m of water covered with 2.8 m of kerosene with unit weight of 8.0 kN/m³. Find…

Q: A 3m Oil: 2m S.g. = 0.9 %3D (F), B 2m Water (F,

Q: The absolute pressure in a closed gas tank is 260 KPa. Compute the pressure head in meters of water.…

Q: An open tank contains water at a height of 3.6m. If the water is to be replaced by a liquid whose…

Q: Q2// Consider a special ball made of steel (p- 5000 kg/m', Cp- 300 J/kg. k, A= 60 m²). The initial…

A: Heat transfer is a thermal engineering subject that deals with the generation, consumption,…

Q: What is the gage pressure at A? in

A: To find pressure at point A

Q: he liquid is 900 kg/m'. You may assume atmospheric pressure is 10

A: Writing pressure equation:PA+γliq0.1=Patm

Q: Question Calculate the depth of centre of pressure from the bottom of the tank. Refer the figure…

A: Given data- A tank as shown in figure is given, Depth of tank = 4 m, Radius of circle inside tank =…

Q: a pipe has a pressure of 4000 pascal and is connected to a 36 degree inclined single column…

A: We will take pressure at top level of mercury in reservoir same from both left and right side.

Q: Water has a surface tension of 0.4 N/m. In a 3 mm diameter vertical tube if the liquid rises 6 mm…

A: Given data : Diameter (d)=3 mmHeight of capillary rise (h)=6 mmSurface tension (σ)=0.4 N/mDensity of…

Q: In fig. if H= 88 inches, the difference in pressure =---?(the fluid is water) Piezometer (static)…

Q: If the work done 10000 cal, and the initial pressure 100 atm, when the ideal gas | expand…

A: Introduction : The general gas equation, commonly known as the ideal gas law, is the state equation…

Q: A gas is contained in a vertical cylinder with a heavy piston. The mass of the piston is 85 kg and…

A: Given data in question Mass of piston Area Acceleration due to gravity To find out Inside…

Question

For the open tank, with piezometers attached on the side, containing two different immiscible liquids, as shown in Figure 1, find the total pressure at the bottom of the tank. (answer in kPa)

El
2 m
Liquid A
(s.g = 0.72)
Figure 1
E!
0.3 m
Liquid B
(s.g 2.36)
%3D
El
0m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Heavy fuel oil flows at Q = 10 gallons per minute (gpm) in a horizontal steel pipe that connects two storage tanks. The diameter of the pipe is D = 1.5 inches. The length of the pipe is L = 100 feet. The depth of oil in the supply tank is 30 feet above the pipe entrance. The temperature of the oil is 60°F, the specific gravity of the oil is s.g.oin = 0.90, the specific weight of the oil is 56.13 lb/ft', and the kinematic viscosity of the oil is 0.00175 ft2/s. The pipe discharges into the bottom of the receiving tank. Neglect minor losses. a) Determine the pressure p at the pipe entrance in pounds per square foot (psf). b) Determine the velocity v in feet per second (fps). c) Determine the Reynolds number Re. d) Classify the flow based on the Reynolds number Re. e) Determine the Darcy-Weisbach friction factor f. f) Determine the friction head loss hfac in feet in the pipe between the two storage tanks. 8) Determine the depth of oil in feet above the exit from the pipe into the second…
Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It has an absoluteviscosity of 1.50 Pa-s and a specific gravity of glycerin = 1.26.3. Solve for the coefficient of pipe friction
(a) The speed of an aircraft flying at an altitude of 11 km is measured by a pitot-staticprobe. If the differential pressure reading is 12.9 kPa, determine the speed of theaircraft in km/h. Take the density of air to be 0.4135 kg/m3
i need the answer quickly
tank contains water upto a height of 1 m above the base. An immiscible liquid of sp. gr. 0.8 is filled on the top of water upto 1.5 m height. Calculate : () total pressure on one side of the tank, () the positiom of centre of pressure for one side of the tank, which is 3 m wide.
7. What is the pressure value (PA) needed to achieve equilibrium for the figure shown (kPa)? a. 0.59 c. 1.02 b. 1.02 d. None of all these PA S.G=0.87 30 120 mm
The initial pressures at A and B are the same at 109 kPa. If the pressure at the liquid at A (SG1 = 2.65) is increased to 134 kPa while keeping the pressure at B constant, determine the new position (Ah, in mm.) of the mercury meniscus inside the tube as shown. Assume no change in the liquid densities. The connecting tube is a 1-cm in diameter, Y1 = 0.69 cm., and the inclination of the tube is 16° with respect to the horizontal. Assume unit weight of air to be negligible. Round off to three decimal places. SG B Air Yı Δh Ah Mercury
The initial pressures at A and B are the same at 105 kPa. If the pressure at the liquid at A (SG1 = 1.96) is increased to 132 kPa while keeping the pressure at B constant, determine the new position (Δh, in mm.) of the mercury meniscus inside the tube as shown. Assume no change in the liquid densities. The connecting tube is a 1-cm in diameter, Y1 = 0.58 cm., and the inclination of the tube is 11° with respect to the horizontal. Assume unit weight of air to be negligible. Round off to three decimal places.
I need the answer as soon as possible
. The ratio of pressures between two points A and Blocated respectively at depths 0.5 m and 2 m below a constant level of water in a tank is:
A suspended gate that’s able to pivot from the top seperates two liquids. There is a stopper that prevents the gate opening anti-clockwise. The gate has a height of 0.5m. The liquid on the right is three times as dense as the liquid on the left. The liquid on the left has a depth of 0.3m. 1) What is the minimum depth of liquid on the right for the gate to open. 2) Comment on the ability to solve this question if the liquid on the left was 0.5m (filled to the top)