Each of the two slender rods shown is 0.75 [m] long and has a mass of 6 [kg]. If the system is released from rest with B = 60°, determine (a) the angular velocity of rod AB when B = 20°, b) the velocity of point D at the same instant.
Q: A wire 60.0 cm long is held parallel to and 100 cm above a long wire carrying 100 A and resting on t...
A: Whenever a conductor falls through a magnetic field the flux passing through the conductor changes a...
Q: A car travels in a straight line along a road. The car’s distance x from a stop sign is given as a f...
A: (a) Given: The equation of position is xt=αt2-βt3 where α=1.50 ms2 and β=0.0500 ms3. Introduction: T...
Q: 3. A 12-V battery and a 12-ohm resistor are connected as shown in circuit X below. Two 12-ohm resist...
A: The flow of current in a circuit depends on two parameters: a) the total emf used in the circuit and...
Q: Consider the curve - = (e', e-†, 4t) . r = The component, in the direction of the vector (-1,1,2), o...
A: Given data, Curve : r→=et,e-t,4t=eti^+etj^+4tk^ Given vector : -1,1,2=-i^+j^+2k^ Time t = 0
Q: A car is moving in a circular road ( radius of 55.4 m) with a speed of 10.8 m/s. Find the minimum st...
A: Given: Radius of road r=55.4 m Speed of car v=10.8 m/s To find: Static friction coefficien...
Q: Answer question d)
A: Given: The resistor value is given as Rc = 6.2 kΩ ; RE = 1.5 kΩ ; RB = 470 kΩ + 220 kΩ The source vo...
Q: A 60.0-cm length of wire carries a current of 10.0 A. It is bent into an equilateral triangle loop a...
A: The torque on a current carrying loop with current I and area A is given by, τ=iAB (1) The ar...
Q: A circular plate with radius r = 0.785 m lies next to a rectangular plate with base br = 0.948 m and...
A: Given, r=0.785m hr=0.770m br=0.948m The center of gravity of the rectangular plate in the y-directio...
Q: LEE’S DISC Experiment I want Analysis for this graph about the relation between Time and Temperatu...
A: Given, Temperature Vs time graph
Q: Write the mathematical expression for the radial probability function. The radial probability functi...
A: Let P(r) denote the radial probability function. The chances of finding the electron from distance r...
Q: A wire 60.0 cm long is held parallel to and 100 cm above a long wire carrying 100 A and resting on t...
A: Given that,The length of wire (L) = 60 cm = 0.60 mThe speed of the wire = v (m/sec)The current (I) =...
Q: 5.59 ... A solid uniform 45.0-kg ball of diameter 32.0 cm is supported against a vertical, frictionl...
A: The free-body diagram is shown in the figure given below
Q: Please help with the following :)
A: tanθ=1.21θ=tan-1(1.2)θ=50.190ϕ=39.8050FBD at joint B,FABsinϕ=13.5kNFAB=21.08kNFABcosϕ=FBCFBC=16.19kN...
Q: A 0.50-kg block slides across a table top with an initial speed of 20 cm/s and comes to rest on a di...
A: v^2-u^2=2as u=20 cm/s=0.2 m/s m=0.5 kg s=0.7 m v=0 0-(0.2^2)=2*a*0.7 a=- 0.285714286 m/s^2
Q: Two long straight aluminum wires, each of diameter 0.40 mm, carry the same current but in opposite d...
A: The magnetic field between two parallel wires are given by, B=μ0I2πrT..................................
Q: a solenoid composed of 500 turns with a length of L = 10 cm and a diameter of 2 cm, flowing with a c...
A: n=500 L=10 cm= 0.1 m diameter=2 cm r=1 cm= 0.01 m I=2A a. B=nμ0I2cos θ1-cosθ2 cos θ1=7.57.57=0.99co...
Q: A femur bone of length 30 cm and diameter 2.5 cm is subjected to a compressive tress of 1.5 *10 N/m²...
A: Given: Stress σ=1.5×108N/m2Young's modulus (Y)=1.5×1010N/mLength L=30cmDiameter d=2.5cm
Q: Give what is ask
A: 1. The magnetic field strength inside a solenoid is given by the equation: B=μonI here n is the num...
Q: determine the magnitude and direction of the magnetic field B at point P (see picture), if I1 = 10A,...
A: Given I1 = 10 AI2 = 5 AI3 = 10 A
Q: A metal rod 30 cm long expands by 0.075 cm when its temperature is raised from 0°C to 100°C. A rod o...
A: Solution: Consider that the third rod to be made of fractions ‘’ and ‘’ of the original rods as fo...
Q: Block A and Block B is connected by a rigid rod along an inclined plane as shown. Block A weighs 18 ...
A: Given: Weight of block A (WA)= 18 lb Weight of block B (WB)= 7.5 lb Coefficient of kinetic friction ...
Q: Advanced Physics Question
A: Given Current, I=5 A Length of one side, L=5 cm=0.05 m The magnetic fields vector on A are:
Q: A 5.1 kg box is slid across the floor at constant speed by a force of 25 N (40o above horizontal) as...
A:
Q: Three long, parallel, straight wires each carrying a 8.0 A current pass through the vertices of an e...
A: Given, Current through each wire, I=8 A Length of the equilateral triangle, L=8 cm=0.8 m The magneti...
Q: A charged particle moves into a region of uniform magnetic field, goes through half a circle, and th...
A: Given data, Time spent by the charge particle in the magnetic field = 130 ns mp = 1.67x10-27 kg me =...
Q: asap pls
A: The first order energy can be calculated by using the formula En1=<ψn|H'|ψn> --(eq-1) The equ...
Q: e. The radial function for the 3s orbital in the hydrogen atom is given below: R3s = 27 /2 (27 – 180...
A: For 3s orbital l=0angular node=0radial node=2For radial node:R3s=0So, R3s=227Z3a03/227-18σ+2σ2e-σ3=0...
Q: μ_0 = 4π×10^(−7) T.m/A
A: Given : d=0.4×10-3m x=1m θ=4° ρ=2.7g/cm3=2700kg/m3 ...
Q: Explain the concept of Radiation heat transfer and how they occur in our daily lives
A: The radiation is transfer of heat through electromagnetic radiation, this doesn't require any intera...
Q: Discuss with the help of any two practical examples how Navier–Stokes equations are used to calculat...
A: Navier-Stokes equation are a set of partial differential equation which describes the motion of the ...
Q: The figure below is a cross-sectional view of a coaxial cable. The center conductor is surrounded by...
A:
Q: How to derive the equation of the density(p): P(x)=Ae^(-x/l) for the below question. Thanks.
A: Given:- The rod is extended to infinity and the density may vary Let, p= Ae-xl ...
Q: A student is performing measurements with a hockey puck on a large merry go-roundwith a smooth horiz...
A: Part (a) The formula to calculate the net position vector of hockey puck is, r=r'+rr Here, r is the ...
Q: Problem 1 An object of mass m = 0.2 kg is hung from a spring whose spring constant is 80 Nm-1. The b...
A: Given,mass m=0.2kgspring constant k= 80N/mb=4N/m
Q: Determine E at A (2,3,5) m in empty space if a point charge of 8 μC is located at (0,1,1) m, a linea...
A: The electric field at A(2,3,5) due to point charge 8µC at (0,1,1) is given by, E→=14πε0qx-x'2+y-y'2+...
Q: Experiment : LEE’S DISC I want the Analysis for this graph
A: The thermal conductivity of the material's property can be defined as the amount of heat that flows ...
Q: 1. A bulb with a long filament is placed in front of a black piece of paper cut into the shape shown...
A: Let's consider a single light source casting a shadow of a small paper cut onto a screen. The place...
Q: Use the Hamiltonian method to find the equation of motion of a particle of mass m constrained to mov...
A: Given Force (F) = -k r Cylinder defined by x2 + y2 = R2
Q: about the y ax xis, What is t ах
A: Given: To find the torque in the magnetic field if emf is maximum as,
Q: Find the Absolute Error (A.E) and relative error (R.E). Also, determine the number of significant di...
A: The quantities are i) a=5.6543612 , a'=5.5543612Absolute error=a'-a=5.6543612-5.5543612=0.1000000Re...
Q: The base of an automobile jackstand forms an equilateral triangle of side length 13 in. and is cente...
A: Given Force (F) = 780 lb Length (b) = 13 in Height (h) = 20 in
Q: A 27 kg box is dragged 4.0 meters across the floor by a rope that is angled at 25o above horizontal...
A: Given, Mass,m=27kgDistance,s=4mTension,T=85NCoefficient of friction,f=0.20 We have to calculate the ...
Q: A converging lens of focal length fi is placed beside another converging lens of focal length f2, sh...
A: Here, we use the lens formula to get the required.
Q: Explain the working of Chart type recorder with a neat diagram.
A: A chart recorder is an electromechanical device that records an electrical or mechanical input trend...
Q: 2. Complete the table. Work Function Work Function Frequenc Maximum KE of Metal Solids y Ejected ele...
A: The relation between energy and frequency is, E=hf metal solids work function (eV) work functio...
Q: A+20 nC point charge is placed on the x axis at x = 2.0 m, and a -25 nC point charge is placed on th...
A: This question can be solved using the parallelogram law of vector addition. We have to first find th...
Q: Man is standing 5 meters away from machine creating noise of 90 dBA, the man is walking away from th...
A: Given: The initial position of the man from the machine is, A1=5 m. The noise from the machine at a...
Q: An alpha particle (charge +2e) and an electron move in opposite directions from the same point, each...
A: The motion of the charged particle in the magnetic field: Let q is the charge moving with the veloci...
Q: The disk shown in the figure has a mass of 15 kg and is supported on point C of its periphery. The d...
A: Given: The mass of disk is m=15 kg. The angle made by disk is θ=30∘. The distance of point G is d=1...
Q: A horizontal circular disc with radius r = 0.8129 m rotates around its own axis. How long does it ta...
A: Given: The radius of the circular disc is, r=0.8129 m. The number of revolutions is, n=1.99. The an...
Please!..
![Each of the two slender rods shown is 0.75 [m] long and has a mass of 6 [kg]. If the
system is released from rest with B = 60°, determine (a) the angular velocity of rod AB
when B = 20°, b) the velocity of point D at the same instant.
В
F1 = 0.75 m
-1=D0.75 m
Sol.
[rad
WAB = 3.90
A
D
VD = 2](/v2/_next/image?url=https%3A%2F%2Fcontent.bartleby.com%2Fqna-images%2Fquestion%2Fc37b0233-e0f8-4c44-a19e-f31dfbb59524%2Fdc73d537-96a8-479e-be16-9c7580d61d4f%2Fcpwkuo_processed.jpeg&w=3840&q=75)
Trending now
This is a popular solution!
Step by step
Solved in 3 steps with 1 images
