he figure shows a 3-phase balanced positive sequence electrical system. The current Ipg%3DBalanced(+) sequence230/20 vmsSelect one:O a.23 /195 Armsb. 23 /75 ArmsC.23 /-45 Armsd. 23 /45 Armse.39.84 -75 ArmsOOO0

e figure shows a 3-phase balanced positive sequence electrical system. The current Ipg = a A Balanced (+) sequence 230/20 vms Select one: a. 23 /195 Arms b. 23 /75 Arms C. 23 /-45 Arms d. 23 /45 Arms e. 39.84 L-75 Arms

e figure shows a 3-phase balanced positive sequence electrical system. The current Ipg = a A Balanced (+) sequence 230/20 vms Select one: a. 23 /195 Arms b. 23 /75 Arms C. 23 /-45 Arms d. 23 /45 Arms e. 39.84 L-75 Arms

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Determine the possible flows in the network shown in figure below.And solve a system of linear…

A: possible flows in the network shown in the figure below are determined

Q: Using 24v AC source design a 24v unregulated power supply circuit that will power a 1kohms load with…

A: Given: C=480μFR=1kΩVm=24VRipple voltage=50 mVT=1ms

Q: (c) If a 1:10 step-up transformer is placed at the output of the generator and a 10:1 transformer is…

A: (c)Given dataThe turns ratio at the output of the generator is .The turns ratio at the load side of…

Q: two 60 cycle current i1=2cos(wt - 15°) and i2=-3 sin(wt - 60°) amp. Flow into common wire. Determine…

A: We need to find phase angle between given current

Q: fngure are as fol Generator G 160 kVA 22 KV X= 9% Line Z- 2 + j5 S2 22 KV Transformer T 200 kVA…

A: Given base values are 160 KVA, 20 KV

Q: 11 kV at a power factor of 0.867lagging. Each machine supplies half the total power. The synchronous…

Q: From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri…

A: Secondary voltage = primary voltage ×(secondary winding turns /primary winding turns) I.e Vsec=…

Q: 2 LOAD1 Sy= 75 MVA cosp=0.95 back XH = j 144,4 ohm 125 MVA LOAD2 Sy= 25 MVA cosp=0.9 back 150 MVA…

Q: Based on the phasor diagram of a voltage and a current shown below, which of the following statement…

Q: Q/ 16 pole nine slot per pole 500 rpm Turns/phase 360 Flux per pole 0.0534 web Tow slot Find :- Kd…

Q: find the eguivalent vesistance Reg for the circuit and total Current supplied by Source and power…

A: the given circuit consist of the three parallel connected resistors and the one voltage source.

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

A: Step-1->

Q: In matlab, To obtain voltage and current waveforms from transmission line which tool can be used O…

Q: Problem: For the cct shown find the equation of current and draw the phaser 202 diagram. 402 VR VL…

A: We need to find out current for given circuit

Q: TOPIC: Ohm's Law, Power and Generating Direct Current Direct Current Circuit Analysis Inductor,…

Q: a. Write the nodal equations for the eircuit shown; and solue for the nodal voltages. b. Determine…

Q: KIRCHOFFS METHOD, KVL, SOLVE FOr I, FOR LO0P KLMNK2 K. T02 305h 40V 5V N30V 50 IOV M. Σ

Q: For the mutual electric circuit shown in figure beside, find the set values of mesh currents 11 &12?…

A: According to question: The figure is drawn as The mutual inductive reactance between coils 1 &…

Q: The incremental cost characteristics of t generators delivering 200 MW are as follows: dF2 dP ah =…

Q: Three single-phase transformers are connected into a three-phase bank. The primary is connected as a…

A: In this question we need to find a phase voltage of primary.

Q: What is the difference between load and delta?

A: Delta is a type of connection in which we connect the load or source on delta .

Q: Design a short circuit shunt stub that will match a 50 ohm line into a 100 + j100 ohm load.

A: We need to design a short circuit stub that with match a 50 ohm line into a 100+j100 ohm load.

Q: I 40KVA, 2000/250 V, 5o HZ Single Pase txusforrer has Following Rarameters O Primary and Secondery…

A: Given S = 40 KVA V1 =2000 VV2 =250 VR1 =0.8ΏR2 =0.012Ώ X1 =4 ΏX2 =0.04 ΏRC,H =6006 ΏXM,H = 1666.7 Ώ…

Q: Use phasor diagram of alternator in leading p.f. (figure 2-b in this lecture) to derive the fomula…

A: An alternator/Synchronous generator is a type of electrical machine that converts mechanical energy…

Q: what is the kilowatt rating of a three-phase 975-KVA generator at. a. unity power factor ? b. 80…

Q: İR İL ic is (1 R = 1,2Ω XL =D 2Ω Xc = 5Ω +

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of the Question at a time, so only Q.(a),…

Q: ) For the circuit shown in figure beside, if V-480Cos400t Volt. Find the: 1. Average power delivered…

Q: Determine the branch currents in figure B using Kirchhoff’s laws: -formulate 5 equations

A: In this question we will find branch currents..

Q: Write a matrix equation that determines the loop currents. Also solve the system For loop currents…

A: From the circuit we can see that there are 5 meshes and we will apply KVL equation in each mesh by…

Q: 5. Obtain the symmetrical components of a set of unbalanced currents I,-1.3225º, I,-0.86z180º and…

Q: 63 G5 K

A: Definition: Short circuit MVA is equal to its MVA rating divided by its own per unit impedance or…

Q: b) A power station has the following daily load cycle as Figure Q1(b) below: 16-20 20-24 20 Time in…

Q: Busbar 1 Busbar 3 P11 & Q11 = ? %3D Z = 0.0062 + j0.0632 p.u V = 1.00 p.u 6, = 0 P = 500W Qa =…

A: Load flow study is the steady-state analysis of the power system network. Load flow study determines…

Q: Two 300-VA parallel-connected transformers can supply a maximum load of a. 150 VA b. 300 VA C. 450…

A: Two 300 VA parallel connected transformer can supply a maximum load of, equal to the sum of their…

Q: The circuit in Figure 1 is a balanced three phase system which has the following parameters:…

A: Line VoltageVab=Va-VbVbc=Vb-VcVca=Vc-Va

Q: 1 BLou sườn Ban ja Us! Uz 2 (0) - 28 4 4 0

Q: Efficiency Calcuate the load power out in MW. POUT = MW Calcuate the input power to the generator in…

A: In this question we need to find the following Load power Power input to generator Efficiency of…

Q: 9. What is the maximum power if the impedance draws a current of i= 10cos(wt-30o ) from a voltage…

A: Power is rate of change of energy. Its SI unit is watt. Given:R.M.S Values:V=220VI=10∠-30°A

Q: lA = ID- 2kn 4kO Ic= lo = lA- 3kn lE IF 1ko L10 V 5kQ- 6kN. IG = IG 20 V ww ww ww %3D II

Q: |The data of the power system shown in the figure: X= 1.2 p.u. X= 0.15 p.u. G1, G2, G3: T1, T2, T3:…

A: The answer as given below;;

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

100%

he figure shows a 3-phase balanced positive sequence electrical system. The current Ipg
%3D
Balanced
(+) sequence
230/20 vms
Select one:
O a.
23 /195 Arms
b. 23 /75 Arms
C.
23 /-45 Arms
d. 23 /45 Arms
e.
39.84 -75 Arms
OOO0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The figure shows a 3-phase bala Time left 1:06:30 200 /00 Vrms. sequence electrical system. Vcn Vbn %3D al Balanced (-) sequence 100 so a 2000 Vms Select one: O a. 200 /-120 Vrms O b. 200 v2 /0 Vrms O C. 200 /0 Vrms O d. 200 v2/-120 Vrms e. 200/120 Vrms
Determine the output waveform for the network of figure below and calculate the output dc level. Si D1 + 220 V + 2.7kn V. 60 Hz{ ru ODeg TS POWER_10_TO_1 Fsi D2
Match the following for each sentences
please write your Introduction about this topic , and answer please in print font do not write in hand writing ? beceuse I want to copy it ?
In a delta connected load Select one: O a. Phase and line currents are not equal O b. Phase current is zero Oc. Phase and line voltages are equal O d. Phase and line voltages are not equal
What is effect of reverse polarity of a DC generator if it is paralleling with other generator? T T T T Paragraph 3 (12pt) E - T- / Arial
An impedance coil takes 10A and absorbs 250 W when connected across a 220V, 60Hz source. What power will it absorb when connected across 110 V, 25 Hz mains? a. 539 W b. 239 W c. 439 W d. 339 W
Assume that the voltage applied to a load is V = 2082-30° V and the current flow- ing through the load is I = 5Z15° A. (a) Calculate the complex power S consumed by this load. (b) Is this load inductive or capacitive?
Problem: Given wye connected source: La Ven Van Von 6-1892 A 6-j802 N 6-j8Q2 I₂ Von = 120-120° V = 120 <-240° bn where V = 1200° an a) Find the line-to-line voltage phasors for the wye connected source. b) Find the line current phasors in each of the three phases of the resistive load. c) Find the current flowing in the neutral.
Question No.33 A single phase half bridge VSI has load R = 1.8 Q and DC source voltage 130 – 0 – 130 V. Find the power delivered to the load due to fundamental current.
No Handwriten please