During a weather storm, an atmospheric discharge hits a lightning pole that is grounded through a hemisphere. The maximum value of the lightning current through the rod is 14776 A. The soil resistivity is 100 ohm.m. A manis playing golf 41 m away from the center of the hemisphere. At the moment of the lightning strike, the distance between his two feet is 0.4 m. Compute the Thevenin's voltage in volt (Vab or Vth).Answer:

Given that , ra=41 mrb=41m+0.4 m=41.40 mI=14776 Aρsoil=100 ohm-m Although, for given system…

During a weather storm, an atmospheric discharge hits a lightning pole that is grounded through a hemisphere. The maximum value of the lightning current through the rod is 14776 A. The soil resistivity is 100 ohm.m. Amar is playing golf 41 m away from the center of the hemisphere. At the moment of the lightning strike, the distance between his two feet is 0.4 m. Compute the Thevenin's voltage in volt (Vab or Vth). Answer:

During a weather storm, an atmospheric discharge hits a lightning pole that is grounded through a hemisphere. The maximum value of the lightning current through the rod is 14776 A. The soil resistivity is 100 ohm.m. Amar is playing golf 41 m away from the center of the hemisphere. At the moment of the lightning strike, the distance between his two feet is 0.4 m. Compute the Thevenin's voltage in volt (Vab or Vth). Answer:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A voltage waveform is shown below, please find its RMS voltage value. Choose the value that is closest to the answer. NEED A NEAT HAND WRITING ONLY OTHERWISE WILL LEAVE A DOWNVOTE NO CHAT GPT MINIMUM3 STEPS WITH EXPLANATION
Draw the inductance and resistance voltages on an oscilloscope screen in accordance with their polarity. In the drawing, it should start with voltage changes and values and should be stable. Write the Time/Div and Volt/Div steps made on the oscilloscope during the measurement on the oscilloscope screen drawing. Specify the voltage labels in the drawing. The current through the circuit has the same variation as the resistor voltage measured from the equation V=I/R, but is 1/47 times the value.
(c)[ device needs to connect to a Diesel generator which generates sinusoidal AC power at 16.67 Hz. The amplitude or RMS value of the generator output voltage is adjustable. The area of cross-section of the core is 0.035 m². What constraints, if any, must be imposed on the The magnetic device of the figure is designed to operate with 240 V(rms) at 50HZ. For operation in a remote mining site, the use of this device, or the generator, if the device must be connected to the generator. You may assume that the peak B field in the core must be limited to 1.1 T to prevent magnetic saturation.
A coil has a resistance of 18 when it mean temp is from 20o C to 50o C. Find its mean temp rise when its resistance is 21 and the surrounding temp is 15o C. A potential difference of 250 V is applied to a copper field coil at a temp of 15o C and the current is 5A. What will be the mean temp of the coil when the current has fallen to 3.91 A, the applied voltage being the same as before.
7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mH inductor. To what angle is the current lag or lead? A. 46.7 deg. lag B. 43.3 deg. lag C. 46.7 deg. lead D. 43.3 deg. Lead
A 70-Vac source has the following waveform. Determine:a. equation of the waveform (in time domain)b. the instantaneous voltage when t = 120 msc. the angle (1st occurrence) after t = 0 when the voltage is +80 Vd. the time (2nd occurrence) after t = 0 when the voltage is –10 V
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
QA) The apparent power for an electric network was measured and found to be 360.6VAZ-56.34% 1. Determine the power factor of the network and sketch the power triangle. 2. Identify the elements of the network and provide a reason justifying your answer. B) Define the permeability (ur) of the material. If you are required to design IH and I uH inductors, what type of core will you use in your design and why? support your answer by equations.
The electricity in a U.S. house is called alternating current (AC) because the voltage and current vary sinusoidally with time. Assume that the frequency is 60 cycles/second and that the voltage range is [-170, +170] volts. Assume voltage is at its maximum when time a.) b.) t = 0.005556 second. Write a sinusoidal function V(t) to model that voltage, where It is in seconds. Use your function to determine the voltage at t = 0.008 sec.
Q6/ Charge is: * is the rate of change of the charge, measured in Amper (A). an electrical property of the atomic particles of which matter consists, measured in coulombs (C). 5/ Direct current (DC): * It is a current that remains constant with time. Alternating current is that varies sinusoidally with time. 9:25 AM
Show all work please and thank you :)
alculate the voltage Vs and the current Is. Calculate the phase difference between Vr1 and Vs.