Draw the orthographic view of the following component mention top view ,side view,front view

23. The programmer used three-point method to set up an accurate UF[3] on the part reference surface by sequentially recording points 1, 2, and 3 that are specified on the part reference surface for the three-points method in the robot system. If the programmer recorded three points used by the three-point method in the sequence of points 1, 3, 2 rather than point 1, 2, 3, then (a) the direction of x-axis is not changed (b) the direction of z-axis of UF[3] is changed (c) UF[3] setup is not accurate relative to the part reference surface (d) the origin of UF[3] is changed 24. The programmer preciously recorded all robot points P[n] for a robot task program. However, it is found that during the execution of the robot program, the robot TCP can't always precisely reach to each recorded point. Which of the following statements is correct: (a) The robot has poor accuracy (b) the robot has poor repeatability

This problem comes from Introduction to Graphics Communications for Engineers 4th Edition page 64 #8 could you help me sketch the isometric view given the 3 standard views

How do you interpret a continuously rising or falling angular position output in Simulink

Using AutoCAD, draw the following image using object snap modes step by step

46 20 30 30 R15 45 70 St

Which datum has size? Please refer to image attached.