Draw the circuit diagrams for an integrator and for a differentiator. Also give an expression for the output voltage in terms of the input voltage and component values.

For the summing Op-Amp, find the output voltage Vout?

i. The saturation voltage an op-amp is primarily controlled by(i) power supply (+Vcc and -Vcc)(ii) open-loop gain of the op-amp(iii) common mode gain (iv) slew rate

A certain op-amp has two internal amplifier stages with the following gains and critical frequencies; Av1 = 50 dB, Av2 = 25 dB, fc1 = 1500 Hz, and fc2 = 3000 Hz. Determine the open loop midrange gain in decibels and total phase lag when f = fc1....

What are the problems in an ordinary op-amp integrator? Why op-amp integrator output is linear? What are the problems in an ordinary op-amp differentiator? What are the advantages of integrator and differentiator circuits?

Could you please go further into how to apply nodal analysis to an op-amp circuit? Thank you

A positive-feedback amplifier circuit (inverting Schmitt trigger) is shown in the following figure. In each of the situations below, determine output voltage given the applied trigger signal verigger, initial output vout and power supply rails ±Vcc, where Vcc = 15 V. The first three questions start the circuit in the positive stable state, the next three start the circuit in the negative stable state. 3 k. 2 k. レナ Vout OV O Vrigger

What are the advantages of integrator and differentiator circuits?

please do question 2 and 3