Directions: Solve the following problems and show your solution. 1. Consider the circuit below. Solve for the following, (in a simple way of solving) a. Total Resistance b. Voltage between point A & B. c. Current Total d. Current Il and I2 e. Power across R1, R2 and R3 f. Power delivered by the source R, = 2.2 kn A V, = 15 V R = 3.3 kn R= 680 N

Please help asaop.

What are the functions of capacitors C1 and C2 shown?

Please could you use Matlab to solve this question and You must submit the Matlab Simulink blocks you used as well as resulting outputs/plots in your answers. Please view the images attached for the question

definition of Superposition Analysis, in which cases of circuits types it can be used, list two examples about its application in electrical engineering and show an electrical circuit “figure only” with no calculation, that can be solved using Superposition Analysis and explain theoretically how it would be solved.

What is Thevenin equivalent circuit.?

R3-50 Q UTM b) Figure Q4(b) is referred. By using nodal analysis, solve for: 5 UTM i) the values of voltage V, and V; in 5 UTM & UTM ii) the values of current, Ij in phasor domain and time domain UTM MS UTM 5 UTS 5 UTM 5 UTM 5 UTM & UTM 8 UTM 8 UTM 8 UTM 5 UTM 8 UTM 8 UTM R=10 Q UTM & UTM 8 UTM 8 UTM 8 U U XL=j5 Q 8 UTMSN 10020° v A 5 UTM 6 UTM R-20 Q R;=10 Q UTM 5 UTM M 8 UTM JUTM 8 UT 8 UTM 5 UM 8 UTM 5 UTM UTM UTM 8 UTM I-520° A UTM TM 8 UTM UTM 5 UT

Two Voltage Sources, V1 with internal resistance R1 and V2 with internal resistance R2, are placed in parallel. The polarities of V1 and V2 are in the same direction. Chose values for V1 ≠ V2,R1 ≠ R2 and obtain the RTH, and VTH using Source Conversion.

The obtained total power dissipation is too high for a specific application. Design a circuit, by adding a single external component, to reduce the total power dissipation by 20 %. Justify your choice and state any assumption.

Find the transfer function and the dynamical-equation description of the network in Figure P3-23. Do you think the transfer function is a good description of this system? Also answer why you think the transfer function is/is not a good description; how would your answer change if the active resistor of resistance -1 ohm is replaced by a passive resistor of resistance +1 ohm? 1 F -1 S2 Current source I F Figure P3-23