Determine the size of a high rate trickling filter for the following data: BOD concentration in the effluent (i) Sewage flow = 4.5 Mld; (ii) Recirculation ratio = 1.5; (iii) BOD of raw sewage = 250 mg/l; (iv) BOD removal in primary tank = 30%; (iv) BOD removal in primary tank = 30%;

Determine the size of a high rate trickling filter for the following data: BOD concentration in the effluent (i) Sewage flow = 4.5 Mld; (ii) Recirculation ratio = 1.5; (iii) BOD of raw sewage = 250 mg/l; (iv) BOD removal in primary tank = 30%; (iv) BOD removal in primary tank = 30%;

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A untreated waste water enters a stream as shown in figure. The concentration of sodium in the stream at point A is 15 mg/1 and the flow rate is 20 m/sec. The concentration of sodium in the waste stream is 250 mg/1 and the flow rate is 172.8 MLD. The concentration of sodium at point B, assuming the complete mixing has occurred is mg/1. River A Waste water C5A Cs. = 15 mg/1 C = 250 mg/1 = 20 m'/s Qsa Q =172.8 MLD
QUESTION: An aerated lagoon wastewater treatment is to be designed for a municipal wastewater. The design population is 5000 persons, and the aerated lagoon is to provide secondary treatment. Pertinent data are: flow = 380 L/cap-d, influent BOD5 = 255 mg/L; effluent BOD5 = 20 mg/L, K = 2.18 d-1 oxygen required 1.6 kg O2/kg BOD5 applied to the lagoons, and the primary clarifier removes 33 % of the influent BOD5. Calculate the total lagoon volume (m3)
Determine the 5-day BOD for a wastewater sample when 15 ml of wastewater is diluted up to the mark in a 300mL BOD bottle with phosphate buffer. Initial concentration of dissolved O2 = 15 mg/L; Concentration of dissolved O2 on Day 5 = 5 mg/L. BOD5 = (D1 - D5)/p 0.033 mg/L 0.67 mg/L 200 mg/L 100 mg/L
A sewage treatment plant contains fourteen standard rate tricking filters with diameter 37.8m filters, and two secondary Jarifiers with diameter 18.2m. Calculate the maximum allowable output capacity of the treatment plant using the following data: . BOD of raw sewage 300 mg/L. . BOD removal in primary sedimentation 30% . BOD effluent 35 mg/L • Overall efficiency of BOD removal 90%
• An average operating data for conventional activated sludge treatment plant is as follow:- • Wastewater flow =35000m³/d, volume of aeration tank =10900m2, influent BOD to aeration tank=162.5mg/l, effluent BOD=20mg/I, mixed liquor suspended solids32500mg/l. Based on the information above determine: - Aeration period, F/M, BOD load ,Percentage efficiency of BOD removal.
A municipal wastewater treatment plant processes an average of 14,000 m3 / day. The peak flow is 1.75 times the average. The wastewater contains 190mg/L BOD and 210 mg/L suspended solids at an average flow and 225 mg/L BOD and 365 mg/L suspended solids at peak flow. Determine the following for a primary clarifier with a 20-m diameter. Assume eff. BOD of 20 mg/L and effluent TSS of 30mg/L for average and peak flows. 1. Surface overflow rate and the approximate removal efficiency for BOD 5 and suspended solids @ average flow. 2. Surface overflow rate and the approximate removal efficiency for BOD 5 and suspended solids @ peak flow. 3. Mass of solids (kg/day) that is removed as sludge from average and peak flow conditions.
Consider a rectangular wastewater treatment pond having a length of 100 ft,width of 20 ft, and depth of 20 ft. Assume the discharge from a wastewater treatment plant has aflow of 30 MGD with a solids concentration of 5 mg/L.a) Determine the mass flow rate of solids discharged in ton per day?b) Calculate the residence time of the pond in minutes?
An activated sludge system is being used to treat 2000 m³/d of wastewater containing 250 mg/L BOD5. The measured parameters for the system are as follows: K; = 40 mg BOD5/L; ka = 0.01 d1; Y = 0.6 mg VSS/mg BOD5; µmax = 2.0 dª. MLVSS = 2000 mg/L. Calculate the aeration basin volume (m³) to achieve 99 % BOD5 removal.
Calculate the diameter and depth of filters for the following data, if two trickling filters in series are designed to treat the wastewater: Influent rate = 4 MLD BOD of the influent = 200 mg/L Efficiency of BOD removal by the roughing filter is 50% Hydraulic loading rate (HLR) = 1.80 m3/m2.d Organic loading rate (OLR) = 0.2 kg/m3.d Group of answer choices 53.2 m and 0.9 m 26.6 m and 0.9 m 26.6 m and 0.45 m 53.2 m and 0.45 m Please answer very soon will give rating surely Show your work
The treated domestic sewage of a town is to be discharged in a natural stream with following data given: (i) Population = 50,000 (ii) BOD contribution per capita = 0.07 kg/day (iii) BOD of stream on u/s side = 3 mg/It. (iv) Permissible maximum BOD of stream on d/s side = 51 (v) Dry weather flow of sewage = 140 litres per capita per day 5 mg/lt. (vi) Minimum flow of stream = 0.13 m3/sec Choose the correct statement(s): BOD of treated sewage should be 8.21 gm/lt. Total BOD produced per day is 35000 kg/day C BOD of untreated sewage is 500 mg/It. Correct Option D Percentage treatment required is 98.358% Correct Option
Sketch a typical Streeter-Phelps oxygen-sag curve and state the limitations of the Streeter-Phelps equation shown below: k, Lo -kt D= k2 – k -e (b) Wastewater discharges through an outfall into a slow moving river that has a mean velocity of 3 cm/s. After initial mixing, the dissolved oxygen concentration in the river is 9.5 mg/L, and the temperature is 20°C. The ultimate BOD of the mixed river water is 30 mg/L, the rate constant for BOD at 20°C is 0.48 di and the re-aeration constant at the same temperature is 0.72 d. The saturation concentration of oxygen is 10.2 mg/L at 15°C. i. Estimate the critical time, to, and location, X., with reference to dissolved oxygen concentration. ii. Estimate the minimum dissolved oxygen at the critical location, and comment on the ecological implication of the same.
Given the following information for wastewater plant, the plant is an activated sludge system with an aeration tank that has a volume of 7500m3. efficiency of aeration tank 85% ,SVI is 88ml/gm., volume of settled solids after 30min, is 220ml, Q=60000 m3/d, effluent BOD from aeration tank = 20mg/l. Calculate the values of BOD load, F/M, and efficiency of plant. %3D