Determine the power required to drive compressor

Alert for not submit AI generated answer. I need unique and correct answer. Don't try to copy from anywhere. Do not give answer in image formet and hand writing

Industrial Main.   What are two reasons gears are used for?

The turbine is connected to generator which converts mechanical energy to electrical energy. A. True B. False

After circulating through the engine, the oil falls back to the oil sump to cool. Select one: True O False

Answer must be correct to get upvote. Thanks

Draw the circuit of counterbalance valve and state the steps of operation. Note: The answer will be attached to the drawing of the circuit, indicating the steps to operate the circuit

This is Mechanical Engineering Pneumatics.   Draw the schematic diagram of the block diagram shown - pneumatic door open close system. Example of schematic diagram is shown below.

A lawnmower stops running after a short period of time. The fuel tank filler cap is removed and an almost fuel tank of fuel is found, so the cap is reinstalled and the engine restarted. The engine runs again for a short time and then dies so the cap is removed again and the process repeats. Tech a says the problem may be due to a clogged vent in the fuel cap. The b says that the intake mainfold gasket may be defective. Who is correct?

What size of receiver tank (gal) for a compressor is required if the pneumatic system is used to drive 5 linear cylinders which collectively consume 12 SCFM for 5 minutes? The compressor pressure switch operates between 90 and 110 psi. Add your answer Integer, decimal, or E notation allowed