Determine the Height of a chimney with a static draft of 12 mm if the losses total draft is 4 mm, the ambient air temperature is 35 ° C and the exhaust gas temperature is 450 ° C. The fuel consumption of the boiler is 600 kg / h, the mass of the exhaust gas is 16 kg, also determine the air mass ma, the diameter of the chimney and the velocity of the exhaust gases.

Determine the Height of a chimney with a static draft of 12 mm if the losses total draft is 4 mm, the ambient air temperature is 35 ° C and the exhaust gas temperature is 450 ° C. The fuel consumption of the boiler is 600 kg / h, the mass of the exhaust gas is 16 kg, also determine the air mass ma, the diameter of the chimney and the velocity of the exhaust gases.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter6: Forced Convection Over Exterior Surfaces

Section: Chapter Questions

Problem 6.21P

See similar textbooks

Similar questions

Question :- A chimney of 16 m high is used for discharging maximum exhaust gases. (i) Find the draught produced by the chimney in mm of water. (ii) If the maximum temperature of the gases available is 350 degrees * C find the mass of air supplied per kg of fuel if the discharge mass is maximum. The atmospheric temperature = 20°C.
8. A coal fired steam boiler uses 3000 kg of coal per hour. Air required for combustion is 15.5 kg ofcoal at barometric pressure of 98.2 KPa. The flue gas has temperature of 285 degree Celsiusand an average molecular weight of 30. Assuming an ash loss of 11% and allowable gas velocityof 7.5 meters per second. Find the diameter of the chimney 9. The gas density is 0.75 kg per cubic meters and air density is of 1.15 kg per cubic meter. If thedriving pressure is 0.25 KPA. Determine the height of the chimney. 10. A powerplant situated at an altitude having an ambient air of 96.53 KPa and 23.88 degreeCelsius. Flue gases at a rate of 5.0 kg per second enter the stack at 200 degree Celsius andleaves at 160 degree Celsius. The flue gases gravimetric analysis are 18% CO2, 7% O2 and 75%N2. Calculate the height of the stack necessary for a driving pressure of 0.20 KPaKindly answer all please. Thank you
The man shown in (Figure 1) blows air through the 3-mm diameter straw with a velocity of 2.8 m/s. Assume fully developed flow occurs along the straw. The temperature of the air is 20°C. Figure -225 mm- 1 of 1 > T Part A Determine the force his lips exert on the straw to hold it in place. Express your answer using three significant figures and include the appropriate units. P-6.673 HA Provide Feedback N ? ubmit Previous Answers Request Answer X Incorrect; Try Again; 3 attempts remaining
A small-scale Compressed Air Energy Storage (CAES) system uses a rigid tank, whichhas been sized to 1m3. The air storage helps support various fluid power (pneumatics)requirements, but also serves for energy storage (when fully charged).The tank sits in a plant room having a temperature of 25oC at 1 atmosphere (101.325kPa).When delivered new and installed the tank (and the ambient air it contains) is assumedinitially at the same steady state conditions in the plant room. The tank can be filled with(dry) air to a maximum pressure of 300bar. When left in the plant room, the pressurised airtank eventually attains the plant room temperature.You may assume:> Steady state conditions apply> Negligible changes in kinetic and potential energy> Thermal mass of the tank (metal) is negligible Apply the ideal gas equation and calculate the mass of 25oC air (units: kg) in the fullypressurised tank.
What is the friction loss in cm of water in a 2.44m diameter chimney 61m high up which gas is flowing at 9.14 m/sec? Gas density is 0.6776 kg/m3.
How much air is used per kg of coal burnt in a boiler having a chimney of 31.1 m height to create a draught of 19 mm of the water column when the temperature of the flue gases in the chimney is 361 o C and the temperature of the boiler house is 28.4 o C. Also find the equivalent gas head of the chimney.
Calculate the height of chimney required in a boiler in which natural draught is 25 mm of water. The flue gases are at temperature of 600K , atmospheric air temperature is 25 C and 15 kg air per kg of fuel is required in boiler.
A small petrol engine produces 15 KW of power under the following conditions;Fuel intake 0.05 kg/minCalorific value of fuel 40000 KJ/kgAir intake for combustion 0.70 kg/minSpecific air enthalpy 300 kJ/kgHeat loss from the engineBy radiation and convection 2700 KJ/hrDetermine the specific enthalpy of the exhaust gases from the engine.
Air flows from a 10cm pipe in which the temperature and pressure are 4-C and 280kpa, respectively, into a 5cm pipe in which the pressure is 147kpa gage. Calculate the velocity and discharge in each pipe, assuming isothermal conditions, standard atmospheric pressure and no losses. The gas constant for air is 280N-m/kg-K.
Solve for the latent heat of water at Tw = 28C(and. λw = 2435 kJ/kg)
air at a dry ball temperature of 95 degrees Celsius and RH 5% is passed over the cooling coil so that the temperature of the air dry ball becomes 50 degrees Celsius. how much heat is released from the air in the process? = (kj / kg)
48. Water is flowing in a smooth pipe of diameter D. A section of this pipe hav- ing a length of L is heated. Water at the inlet to the heated section has a tempera- ture of Tŋ. Water temperature at the exit of the heated section is Tp. The heated section of the pipe wall is maintained at a constant heat flux so that a constant temperature difference of AT, = T, – T, exists between the wall and the bulk wa- ter temperature. Show that for turbulent flow in the pipe and a specified heated length and pipe diameter, water temperature at the exit of the heated section is given by: 402 0.6 Pr T52 =Tf +0.0876 L AT DO.8 0.2 m