Determine the detention time, overflow rate and weir loading for a primary sedimentation tank with the following design data. Flow = 0.150 m³/s Length = 40 m (effective) • Width = 10.0 m Liquid depth = 2.0 m • Weir length = 75.0 m %D %3D %3D

Refer to Figure 18.9. A cantilever sheet pile is driven into a granular soil where the water table is 2 m (L1) below the top of the sand. The properties of the sand are =40, =17.5kN/m3, and sat=19kN/m3. It is proposed to excavate to a depth of 6 m (L) below the ground level. Determine the actual depth to which the sheet pile must be driven (L + D), using the net lateral pressure diagram. Note: Dactual=1.3(L3+L4)theory

Redo Problem 12.30 assuming that the water table coincides with the top of the fill and that sat(fill) = 19.8 kN/m3. If the other quantities remain the same, what would be the downward drag force on the pile? Assume ' = 0.5fill. 12.30 Figure 12.49a shows a pile. Let L = 15 m, D (pile diameter) 305 mm, Hf = 3 m, fill = 17.5 kN/m3, and fill = 25°. Determine the total downward drag force on the pile. Assume that the fill is located above the water table and that = 0.5fill.

A concrete pile 16 in. 16 in. in cross section is shown in Figure P12.13. Calculate the ultimate skin friction resistance by using the a. method [use Eq. (12.61) and Table 12.11] b. method c. method Use R=20 for all clays, which are normally consolidated.

Solve Problem 12.13 using Eqs. (12.59) and (12.60). 12.13 A concrete pile 16 in. × 16 in. in cross section is shown in Figure P12.13. Calculate the ultimate skin friction resistance by using the α method [use Eq. (12.61) and Table 12.11] λ method β method Use for all clays, which are normally consolidated.

Refer to Figure 18.26b. Let L = 15.24 m, fill = 17.29 kN/m3, sat(clay) = 19.49 kN/m3, clay = 20, Hf = 3.05 m, and D = 0.406 m. The water table coincides with the top of the clay layer. Determine the total downward drag on the pile. Assume that = 0.6 clay. FIG. 18.26 Negative skin friction