Determine the current that flows through an 8n resistor connected to a voltage source v 110 cos 377t V.

Q: Suppose x is an integer where 0 ≤ x ≤ 9, and F(x, y) = y sin(πx/10). Assuming fractions are truncate...

A: Given that, x is an integer where 0 ≤ x ≤ 9, and F(x, y) = y sin(πx/10).     

Q: For the circuit below calculate Zin in rectangular form if w = 100 rad/s L=0.04H R=10 V out C=0.25F

A:

Q: 1. Determine the total resistance and the total current. 202 152 lon 180V 18.22 36n

A:

Q: Describe in your own words with proper diagram and characteristics curve : why the application of a ...

A: MOSFET- MOSFET is electronic device which mainly used as switch and amplifier. It has four port as m...

Q: 18.) Determine the effective resistance between points A and B in the given network below. Express i...

A:

Q: Given: (DC.1)Hex - (11001.1)Bin. What is its difference in Octal form?

A: Binary code is defined as the code having only 0 and 1 digit for any number. This code is used by co...

Q: Question No. 2: Let z1 = 2 + jand z2 = -3 + j6. (a) Compute the polar form of z1 and z2. (b) Compute...

A:

Q: Rg = 330 kn Rc = 1.5 k2 Cin Bdc = 150 Cout R = 1.5 kN Vin = 50 mVeP

A:

Q: Q1. Determine the Q-point values of Ic and VCE for the circuit in Figure 1, Assume VE = 8 V, R= 350 ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Find i and Vo in the circuit below:

A:

Q: certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing positi...

A: We need to find out phase angle between current and voltage and time for current become zero and rea...

Q: wR-6 ocument.docx M... E answer 38.) Using Cramer's rule, solve for the value of the determinant of ...

A: The solution is given below

Q: A 5 MHz carrier is modulated by a 5 kHz sine wave. Sketch the result in both the time and frequency ...

A: We will first calculate the upper side band frequency. Then, we will first calculate the lower side ...

Q: series circuit composed of a 0.20 henry inductor and a 74microFarad Capacitor is connected to a 60 V...

A: For the given circuit we have to find the value of frequency 

Q: A2 3:2 220V 1k What is PLave? 66mW 21.5W 147mW 132mW

A:

Q: ): Apply Mesh analysis method to find the current i in figure (2 20 2 8 V 8Ω 2Ω 6Ω iz 16 V

A:

Q: A 3.5 2 ww B 3. 4.1 N F A ータ -i3→ 13 V D 3.5 N ww + i2 - Find the current i3. Answer in units of A.

A:

Q: 2. (a) Derive the common-mude rojection ratio (-ADACH OM) of the stages in Fig. 4. For simplicity, n...

A: Given: Consider the circuit below: To find: Derive the common-mode rejection ratio (=ADM/ACM-DM) of...

Q: 1. A series circuit consisting of a 40-ohms resistor, a 100-μf capacitor, and a variable inductor is...

A:

Q: A coil having an inductance of 50 mH and resistance 10 ohms connected in series with a 25 microfarad...

A: At resonance imaginary part of impedance is zero I.e, XL=Xc. Current at resonance =voltage/resistanc...

Q: In a series RL circuit, if cos 0 = 0.707, the voltage the current by

A:

Q: 4. Obtain the power factor and the apparent power of a load whose impedance is Z=60+J40 OHMS when th...

A:

Q: 7. A 50 uFarad is connected in series with a coil having 50 ohms resistance and a 150 mH inductance....

A:

Q: Question No. 2: Let z1 = 2 + j2 and z2 = -2 + j6. (a) Compute the polar form of z1 and z2. (b) Compu...

A: Note:  As per the  guide lines of the bartleby we are supposed to solve 3 questions, when they are i...

Q: 4. Calculate the output voltage of an op-amp summing amplifier with the following values: R; 1.5MN, ...

A: An operational amplifier is termed as an op-amp. Two inputs, a negative and a positive input is pres...

Q: You have a collection of 100 , 102, and 5 resistors. Desıgn a resistor that has an req of 265 N usim...

A:

Q: Perfendicada 3. a. For the capacitors shown, find the potential difference across each of the capaci...

A: The answer of the questions are

Q: dc power shall be supplied by a listed dc power supply with a maximum output of ____ volts

A: A DC supply of power is a form of electrical source that provides a device with direct current (DC) ...

Q: [12] Materials in electrical engineering may be classified into: conducting materials insulating mat...

A: From electrical engineering point of view the materials are classified as: 1) Conductors 2) Insulato...

Q: A 50 V range voltmeter is connected across the terminals "A" and "B" of the circuit shown in figure ...

A:

Q: Question # 01: Apply the knowledge gained from the ac analysis of BJT to construct the AC equivalent...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: A 50 and 100 microfarad capacitors are connected in series and across 100sin(w+30) voltage. Write th...

A:

Q: : The plates of a parallel-plate capacitor in vacuum are Smm apart and 2 m2 in area. A10.0-kV potent...

A:

Q: Q1: A wire warped around the following ring with 100 turns. the diameter of ring is 10 cm.the curren...

A:

Q: 20 kQ 60 kQ ww 20 kΩ + Vx 20 kQ 100 kQ 20 kQ Vz 60 k2 Vy 20 kQ Vw 20 kQ 20 k2

A: The solution is given below 

Q: B1 A single-phase, 50 Hz transformer has 30 primary turns and 420 secondary turns. The cross- sectio...

A:

Q: Two impedances Za = 4 – j7 W and Zb = 6+ j 9 W are connected in parallel connected to a 60 hz source...

A: In the question, Two impedances Za = 4 – j7 W and Zb = 6+ j 9 W are connected in parallel connected ...

Q: An impedance of 12 – j7W, an inductor having a susceptance of 0.225 mho, a capacitor having a suscep...

A: In this question,  impedance of 12 – j7W, an inductor having a susceptance of 0.225 mho, a capacitor...

Q: 7. The equation of motion for a rotational mechanical system is jë + bò + k® = T(t) +G(t) 0(0) = 5, ...

A:

Q: Question No. 4: For the below circuit, assume that: V:(t) = 20 cos(wt+30°) V2(t) = 10 sin(wt+60°) V3...

A: In this question,  We need to write the polar representation.  Polar form is representation by rms v...

Q: S, 2-to-4 Z2 G Y YO A 00 0 0 0 0 1 0 0 1 0 1 1 0 0 0 100 10 1 1 1 0 1 1 1 Decoder z, YO 2 Priority B...

A: The solution is given below

Q: [18] the current flows through the conductor from O the negative end to the positive one. the positi...

A: the current flows through the conductor from

Q: Q2) A lossless transmission line is terminated with a 1002 load. If VSWR on the line is 1.5, fined t...

A: Given data, Load impedance, ZL=100 Ω VSWR=1.5  

Q: 13.) Given the star connection, convert into equivalent delta connection 1 p and solve for resistanc...

A: The solution is given below 

Q: S. Use k-map method to derive the simplified POS expression for the given: F= (X+Z')(Z+WY)'+ (VZ+WX'...

A: Firstly lets expand the expansion as shown below

Q: [15] Two negatives charges will ----- each other. repel attract о

A:

Q: to the primary side. Question # 3 The coils of the magnetic circuit shown in the figure are connecte...

A:

Q: Determine each statement if it is TRUE or FALSE. A1.  The system response when the initial conditio...

A: As we know that a system has two input response that are zero state response and zero input response...

Q: Derive the TRUTH TABLE of a majority gate circuit with four inputs (A,B,C,D). The circuit will outpu...

A: Majority of input is high means Out of 4 input either 4 or 3 inputs should be high Let High means lo...

Q: A PV module has been tested using a steady-state solar simulator, and the following I-V and P-V curv...

A: To extract the maximum power from the PV, there are multiple MPPT controllers are used nowadays P &...

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.