Determine the accelerations of bodies A and B and the tension in the cable due to the application of the 60-lb force. Neglect all friction and the masses of the pulleys. 150 lb 75 lb P= 60 lb B

What is FB in N? What is the angle FB in degrees? What is FA in N?

Knowing that P is 30 kN, applied to both sides of the bar at B and Q is 28 kN, applied to the bar at C as shown.  What is the internal normal force acting on a vertical cross-section passing through the bar between points B and C?  Express your answer in Newtons (not kN), to the nearest whole Newton, taking tension as positive and compression as negative.

2/88 If the resultant of the forces shown passes through point A, determine the magnitude of the unknown tension T which acts on the braked pulley. 1600 N 275 N 0.5 1.8 m 1.5 m Im 300 N 1.25 m B 50 0.6 m T2 650 N

Please solve this question in hand writting setp by step .

A III [ 2 m d 300N B 3m 307 M=1500Nm For the above diagram, given that F₁-800 N, w = 400 N/m and d = 4 m, calculate the following (neglect the depth of the beam). Note that there is a pin support at A and a roller support at B. 1. The magnitude of the resultant of the applied forces, FR. Please provide the answer in kilo Newtons and report the answer to three significant figures. Please include the unit ("kN") within your answer. 2. The angle of the resultant forces, FR measured counter-clockwise from the negative x axis. Please provide the answer in degrees and report the answer to three significant figures. 3. Locate the resultant forces, FR so that it is equivalent to the system of applied forces. Calculate the offset distance of the resultant force, FR measured from point A. Please provide the answer in metres and report the answer to three significant figures.

A 5 kg uniform square plate is supported by two identical 1.5 kg uniform slender rods AD and BE. It is held in the position shown by rope CF. Determine immediately after rope CF has been cut a. The acceleration of the plate. b. The force exerted on the plate at B. D 45° 240 mm 45% -240 mm 200 mm c

Give me right solution with clear calculations

Determine the moment of the two forces about  X, Y and Z axes shown in the figure

A solid 30.0-mm-diameter steel [E = 290 GPa] shaft supports two pulleys as shown. Determine the shaft deflection at point C. Assume that the bearing at point A can be idealized as a pin support and the bearing at point E can be idealized as a roller support. ... A B D E C 300 mm 200 mm 300 mm 200 mm 750 N 500 N (A -1.101 mm -0.936 mm -0.876 mm D) -1.586 mm E) -0.697 mm