) Determine RincM = VCM/IincM for the above circuit.

Q1) You are asked to use the Arduino UNO development board to control different brightness of the LED.a) Sketch a simplified schematic diagram and draw wires to show how Arduino (UNO), LED, potentiometer, and (220ohms) resistor connect to perform LED brightness control. The circuit should be able to:1.Read the voltage passed through the potentiometer (in analog means); 2. Monitor the input voltage level and convert to the output voltage level accordingly;3.Print the analog input level to the serial monitor; All components listed in the table must be used. components list:1x 220ohms resistor1x poteniometer1x LED 1x Arduino UNO

How exactly does one go about clearing an EPROM for the very first time?

7. When the automatic gain control voltage of a radio receiver is measured with a vacuum tube voltmeter whose input resistance is 10 M-ohm, it reads 4.5 V. When an ordinary voltmeter whose input resistance is 10 k-ohm is also connected across the AGC voltage source, both meters read 0.40. What is the internal resistance of the AGC voltage source?