Design Armstrong indirect FM modulator to generate an FM signal with f = 400 MHz and Af = 97.2KHz. A NBFM generator of fc1 = 100KHz and Af₁ 25Hz. Fifth frequency tipplers can be used as multipliers, any number of frequency doublers and a local oscillator with tuning range (400-1500) KHz is readily available for frequency mixing. =

Design Armstrong indirect FM modulator to generate an FM signal with f = 400 MHz and Af = 97.2KHz. A NBFM generator of fc1 = 100KHz and Af₁ 25Hz. Fifth frequency tipplers can be used as multipliers, any number of frequency doublers and a local oscillator with tuning range (400-1500) KHz is readily available for frequency mixing. =

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

12- A DVM measure... a- peak value. b- RMS value. Average value. d- peak to peak value. 13 The study of energy distribution across the frequency spectrum of a given electrical signal is done by a Distortion meter b-wave analyzer.
What is the graph of the FM and PM magnitude spectrum with sine modulation?
Find the resonance point and the half-width of the speed versus frequency curve for the damped harmonic oscillator, under the action of a sinusoidal driving force. *It is all the data
in FM , the maximum allowable frequency deviation is 4kHz and the frequency deviation by noise is 156.42HZ? then the signal to noise ratio is .......
How to calculate the efficiency in frequency modulation and what is the highest value for efficiency in frequency modulation
Draw a block diagram of a PM demodulator using frequency discriminator method.
2. Briefly explain the process of indirect FM generation using a phase modulator.
What is Frequency Modulation? Draw the waveforms.
If a positive change in modulation signal level of 200 mV will cause a positive frequency deviation of 10 kHz, what I be the frequency deviation for a negative change of 100 mV in the level of the modulating signals? (Ans:-5kHz)
One input to a conventional AM modulator is a 600 kHz carrier with amplitude of 22 V. The second input is a 20 kHz modulating signal that is of sufficient amplitude to cause a change in the output wave of +9 V. Determine: a. Upper and lower side frequencies. b. Percent modulation. c. Peak amplitude of the modulated carrier and the upper and lower side frequency voltages. d. Maximum and minimum amplitudes of the envelope. e. Expression for the modulated wave. Then, f. Draw the output spectrum. g. Sketch the output envelope.
Discuss the advantages and disadvantages of using amplitude modulation
How it is generated Single Sideband Modulator Using Filter Method