Design a logic circuit with input signal A, control input B, and outputs X and Y to operate as follows: When B = 1, output X will follow input A, and output Y will be 0. When B = 0, output X will be 0, and output Y will follow input A.

digital logic computer

= 0, Design a sequential circuit with two D flip-flops A and B, and one input x_in. When x_in the state of the circuit remains the same. When x in = 1, the circuit goes through the state transitions from 00 to 01, to 11, to 10, back to 00, and repeats.

• Design a sequential circuit with two T Flip Flops, A and B, and two inputs, E and x. If E=0, the circuit remains in the same state regardless of the value of x. When E=1 and x=1, the circuit goes through the state transitions from 00 to 01 to 10 to 11 back to 00, and repeats. When E=1 and x=0, the circuit goes through the state transition from 00 to 11 to 10 to 01 back to 00, and repeats

3. A logic circuit has four inputs (x3X₂X₁Xo) representing an unsigned binary integer. The single output P is required to be 1 if the input is a prime number (zero may be taken as not being prime). Design the required logic.

Design an asynchronous sequential logic circuit which has inputs (X1 and X2) and one output (Z) the output (z) must go to (1) when at the end of the input sequence (00,10), This output must be maintained (unchanged) for all inputs change until the sequence (11,10) occurs, then the output must go to zero (0). and The output flips when the input is (01,10)