Design a Bridge FWR to supply a load of (1002) with the waveform shown in figure from the main power supply of (220 Vrms). Find: - 1- The transformer turns ratio (a). 2- The ripple voltage. Vovet Vm 12 V 3- The Vdc value. 4- The RMS value of the output voltage. 5- The ripple factor. 6- The value of capacitor filter. (assume ideal diodes) -0.1 V T=0.01 sec.

I need the answer as soon as possible

What does determining the line of best fit give us? and what can we do about it in the context of measuring unknown non-ohmic resistors?

1. Which of the following statements is true?a. Terminal A is negative with respect to terminal D.b. Terminal D is negative with respect to terminal A.c. A voltmeter connected between terminals A and C would measure 40Vdc.d. Terminal A is positive with respect to terminal D.2. Which of the following statements is true?a. ES = ER1 – ER2 – ER3b. ER1 – ER2 – ER3 = 100Vdcc. ES = ER1 + ER2 + 30 Vdcd. ER1 + ER2 + ER3 = ES3. What is the value of resistor R1?a. 5000 Ωb. 1500 Ωc. 3000 Ωd. 10 000 Ω 4. What is the voltage drop between points A and B?a. 45 Vdcb. 15 Vdcc. 10 Vdcd. 60 Vdc 5. What is the voltage drop between points B and C?a. 5 Vdcb. 15 Vdcc. 10 Vdcd. 7.5 Vdc6. What is the value of resistor R2?a. 500 Ωb. 1000 Ωc. 1500 Ωd. 3000 Ω7. Refer to TLO 4, Fig. 4-3 and Exercise Procedure 4. What is the approximatedresistance of DS1 when lighted?a. 35 Ωb. 75 Ωc. 42 Ωd. 100 Ω 5. What is the voltage drop between points B and C?a. 5 Vdcb. 15 Vdcc. 10 Vdcd. 7.5 Vdc6. What is the value of resistor…