Answered: Describe vibrocompaction process to…

Engineering

Civil Engineering

Describe vibrocompaction process to densify loose granular soil zones.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: State the soils suitable to be stabilized by: )Thermal stabilization i1)Electrical stabilization

A: Soil stabilization comprises gluing soil particles collectively, moisture protecting the granules,…

Q: In a borrow pit, the natural soil was found to have a moist unit weight of 112 pcf. The in- situ…

A: Given, Moist unit weight of borrow soil, γmb = 112 pcf Specific gravity of soil, Gs = 2.7 Dry unit…

Q: Why is it expected that the maximum height of capillary rise is greater for fine-grained soils than…

A: Capillary rise is defined as the rise of water through the voids of soil.

Q: Why does the Surcharging for improvement most commonly applied for cohesive and organic soil?

A: - The problem involve in construction over cohesive and organic soil is low shear strength and high…

Q: 1. A fine-grained soil is found to have a liquid limit of 70 % and a plastic limit of 38%. (a) On…

A: From Unified Soil Classification system Chart

Q: Find the area of a piece of land FGH, knowing that FH=150 m. Left hand face Right hand face Occupied…

A: To Determine Area of triangle FGH

Q: List the soil types included in the coarse-grain category and the fine-grain category and the reason…

A: Classification of soil is the division of soil into groups with similar characteristics and probably…

Q: Soil (a) USDA Soil Clasification: F G F G Soil 2.0 mm 100 77 1- Based on USDA Clasification Soil "F"…

A: a) 1. Based on USDA Classification soil "F" is Sand 2. Based on USDA Classification soil "G" is…

Q: Q1-2/ If the apparent specific gravity of a porous soil, G, is 1.25 and its porosity, n, is 40%.…

A: Given data,apparent specific gravity of porous soil is G=1.25porosity FINDreal specific gravitydry…

Q: What are the various combinations of the stress state variables that can be used for an unsaturated…

Q: Using the AASHTO soild classification system, classify a fine-grained soil (75% passing #200 sieve)…

A: given datafine-grained soil75% passing #200 sieveliquid limit of 70plastic limit of 20FINDclassify…

Q: Are flow nets to study subsurface flow appropriate only to coarse-grained soil with a high…

A: Flow nets are the graphical representation of the flow of water through soil mass. It is a…

Q: True or false

A: Residual soil are soil formed at site where parent rock is weathered . Residual soil example : Black…

Q: c) Suppose you are investigating a soil source for possible use as a compacted clay liner. What…

A: Compacter Clay liner: The soils used for constructing compacted permeability barriers such as…

Q: To be non-frost susceptible, what does a well-graded granular soil should contain and uniform…

A: The most critical soil factor influencing the heavy frost tends to be grain size Grain size is being…

Q: Assuming the fill soil does not change properties, how can the compated soil density exceed 100%…

A: Given data.,Question given related to geotechnical enhineeringLet's discuss the correct answer for…

Q: A soil has a specific gravity of 2.65, and a water content of 0.35. The void ratio is 1.2. Determine…

A: Given data : Specific gravity (G)=2.65Void ratio (e)=1.2Water content (w)=0.35

Q: The suitability of these soil for densification using vibroflotation method. What are these soil?

A: This is a technique used generally for improving ground bearing capacity and reducing the…

Q: How to determine the modulus of sub-grade reaction (K) of the sub-grade soil ?

A: Modulus of Subgrade Reaction The modulus of subgrade reaction K is a function of the contact…

Q: A silt clay soil has a plastic limit of 25 and a plasticity index of 30. 70 60 CH of 아 SO PIOLL-…

A: given Plastic limit (PL) = 25, Plasticity Index (Ip) = 30, Water content percent (W) = 35, a)…

Q: What is the effect of various physical properties on the coefficient of permeability for granular…

A: To determine the effect of various physical properties on the coefficient of permeability for…

Q: Explain the difference between primary and secondary consolidation of soil.

A: Primary and secondary soil consolidation are different phases that happen over time when soil is…

Q: Although this soil has only 6% nonplastic silty fines, it has everything else! It has gravel content…

A: We need to find whether the soil is coarse or fine Fines =6% <50% so Coarse grained soil

Q: Explain in detailed the maximum dry density and optimum moisture content of soil

A: In the question, it has been asked to explain optimum moisture content and maximum dry density in…

Q: 12. Fill in the blanks considering the cohesive and cohesionless soils.…

A: Cohesion and cohesionless soils.

Q: Why Thawed soil in the active zone is usually weak and compressible

A: The thaw depth, in soil science, is the immediate point below to which the surface has warmed to…

Q: With the aid of diagram, briefly explain the saturated, unsaturated and dry soil condition of the…

A: Saturated, unsaturated, and dry soil condition are below:

Q: Q1. Draw phase diagram of soil and what is formula of water content?

A: Asked: To draw the phase diagram of soil and give the formula for water content. The phase diagram…

Q: i. Desirable properties of subgrade soil ii. Group Index Method for evaluation of soil iii. Frost…

A: i) Subgrade Soil In transport engineering subgrade is the native material underneath a constructed…

Q: A saturated soil has a moisture content of 33% and a specific gravity of 2.77. Compute the porosity.

Q: Assume a deep deposit of normally consolidated clay. Which of the following processes or actions…

A: Normally consolidated clay has experienced sufficient time and pressure to attain a stable state.…

Q: Define Flow Nets for Nonisotropic Soils.

A: Flow-net construction is exacerbated by the fact that equipotential lines and flowlines are not…

Q: A very thick soft clay layer is encountered at site. Which soil improvement technique would you…

A: Importance ground improvement: To increase bearing capacity To reduce settlement and permeability…

Q: A strata of clean, light-colored quartz sand located below the groundwater table has a moisture…

A: moisture content, w= 25.6%minimum void ratio, emin = 0.38maximum void ratio, emax = 1.109

Q: Define Drained Modulus of Cohesionless Soils

A: Cohesion less soils are defined as any free running type whose strength depends on friction between…

Q: Describe the type and condition of soil required and occurrences responsible in the phenomenon of…

A: Liquefaction:

Q: Define Cohesive Versus Cohesionless Soils

A: Cohesive Soils : It is a type of soil where there is a inter particular attraction, this adds to the…

Q: Define Drained modulus of cohesive soils

A: Cohesive soil is defined as the soil that has fine-grained, less strength, and low deformable soils.…

Q: Following are factors may influence the permeability of soils except : - Soil degree of saturation…

A: Question being asked here is what are the factors affecting permeability

Q: What is the seepage equation for flow through the non-isotropic soil?

A: The quantity of seepage can be determined using the flow net. The flow net is a combination of flow…

Q: Improving soft soil characteristics using vacuum consolidation Potential New technical advances

A: Brief Concept Introduction: Soft soil: Those soils which have very low bearing capacity are called…

Q: How are soils classified on the basis of shear strength? Draw the Mohr-Coulomb strength envelope…

A: Shear strength of soil is defined as the capacity of soil to resist shearing stress. It depends on…

Question

Describe vibrocompaction process to densify loose granular soil zones.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Problem 3. Part A. Explain the role of optimum moisture content in resilient modulus of soil.
3- Ninety-five percent of a soil passes through the No. 200 sieve and has a liquid limit of 60 and plasticity index of 40. Classify the soil by the AASHTO system.
need fast
(a) Soil is a stable product that resulted from the weathering process of rocks. Classify THREE (3) major types of soil that commonly found in most countries in the world.
You have a soil with a CEC of 12 cmolc/Kg and a base saturation of 50%. How many kg/HFS of a 100% CCE CaCO3lime would you need to add to this soil to increase the base saturation to 80%.
differentiate between saturated and unsaturated flow in soils
- Once answered correctly will UPVOTE!!
A geotextile is used as a filter behind a genet drain in a reinforced slope. The grain size distribution of the retained natural soil is shown in Figure 8.22. The soil's permeability is measured to be 4.8×10-4 cm/sec. Select a geotextile that meets the soil retention, drainage, clogging resistance, and survivability criteria and its type (woven or nonwoven).
Classify the soil according to the AASHTO Classification System. Your answer
Given : F3" = 100, F4 = 82, F200 = 36, LL = 40, PL = 28, Cu = 5.5 and Cc = 1.5, then the %3D soil classification according to the USCS is :
Quick
Need solution for this…….