Answered: Derive the formula for admittance and…

Engineering

Electrical Engineering

Derive the formula for admittance and draw the current triangle and admittance triangle for parallel RL circuit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.6MCQ

See similar textbooks

Related questions

Q: A capacitance of 50microfarad and an inductance of 0.2025 Henry are connected in series. If the…

A: The resonance will occur only if the impedance of the capacitor is equal to the impedance of the…

Q: draw single line diagram of 66 kv substation with explanation and not copied from anywhere

A: 66 kV substation Important function of substation is to collect energy transmitted at high voltage…

Q: compare between electrification of residential and commercial installationf

A: Compare between electrification of residential and commercial installation 1. Typically, commercial…

Q: 9. Which of the following equation represents mass semiconductors in electronic circuits? action law…

A: The solution is provided in the following section.

Q: 84. What is the equivalent area in square inch for a conductor 336,400 circular mil? a. 0.428 b.…

A: This problem is mainly depends on unit conversions. The relation between mil and inch is given as…

Q: 5. For the following circuit, complete the timing diagram for the output (Y). Neglect hold time and…

A: A D Flip Flop is a type of digital electrical circuit that delays the state change of its output…

Q: (II) (a) If the resistance of the resistor in Fig. 21–60 is slowly increased, what is the direction…

A: The given figure is shown below:

Q: 5. Determine the time constant, in seconds, for an inductor coil with an inductance of 0.5 H and…

A: TIME CONSTANT:- It is the time required to reach the response to 63.2% of of final value while…

Q: R 1. Reduce the block diagram below into single transfer function. G₁ G₁ G₂ H₁ H₂ G₂ +

Q: 15-10. Determine the effective radiated power for an antenna with directivity = 400 efficiency…

A: It is given that: D=400η=0.60Pin=50 W

Q: R(s) K (s+ 2) (s+5) s² (s+ 6) (s+14) (s +55) C(s) use Routh-Hurwitz criterion method to determine…

A: Given data : The given block diagram is,

Q: The above diagram represents a balanced Y-impedance load with the neutral grounded through some…

A: For star connected load, we have to draw Positive, negative and zero sequence network diagram when…

Q: A pulse code modulated system has 8 bits per sample. What is the number of levels present in the…

A: Given information: The number of bits transmitted per sample is 8. The number of levels present in…

Q: Implement the following Boolean function: * F(A, B, C, D) = E ( 0, 2, 3, 6, 7, 9, 11, 15 ) + d ( 1,…

A: The required circuit can be designed by using the Boolean expression obtained from k-map and also by…

Q: The 32×6 ROM, together with the 20 line, as shown in Fig.P7.17, converts a six-bit binary number to…

A: Given Data, A 32×6 ROM

Q: Explain the types of insulator used in overhead transmission and distribution lines and mention…

A: As overhead insulation, transmission lines can utilize one of five different types of insulators: 1.…

Q: Consider a CMOS inverter, which the following nMOS VTO, n = 0.8 V PMOS VTO, p = -1.0V unCox = 50…

A: NMOS: VT0,nμnCOX==0.8V50 μAV2 PMOS: VT0,pμpCOX==0.8V20 μAV2 VDD=5VLn=Lp=1μmCout=2 pF…

Q: A single phase voltage controller is employed for controlling the power flow from 230 V, 50 Hz…

Q: (b) A single-phase transformer has 2000 turns on the primary winding and 500 turns on the secondary…

Q: recommended the testing of wiring installations for domestic load

A: A

Q: analyse the rating of wires/ cables and mcb used for different types of loads

A: A small circuit breaker called an MCB is used to trip when home appliances experience overcurrent…

Q: Assume Q = 0 initially and determine the waveform of Q for the NOR SR latch with the following…

Q: Design a clamper to perform the function indicated Vi 20 V -20 V + Ideal diodes Design 0 Vo +16 V -…

Q: Implement the Boolean function F = xy + x ′ y ′ + y ′ z. With NAND and inverter gates.

A: The given Boolean expression can be implemented by converting the expression into NAND based…

Q: 4. Which of the following is the correct relationship between temperature (T) and mobility (u) of…

A: The correct option along with the explanation is provided in the following section.

Q: 4. A 1000 KVA transformer has a reactance of 5%. Its reactance at 2000 kVA base is (1) 5% (iii) 20%…

A: Given: Rated kVA = 1000 kVA Base kVA = 200 kVA Reactance of rated kVA = 5 %

Q: Use mesh analysis on the circuit of figure below to find I₁ j5 2 3Ω CHC 15/90° V 2020 V -j4

A: According to KVL(Kirchoffs voltage law) the algebraic sum of voltage drops (or potential…

Q: (a) List the octal and hexadecimal numbers from 1410 to 3210. Using A and B for the last two digits,…

A: It is given that: (14)10 to (32)10 (8)10 to (28)10

Q: circuit has a pushbutton switch connected to pin PC0 and a 7-segment LED display to port A of AVR…

A: #include<avr/io.h> #include<utill/delay.h> int main(void) { DDRC=0x01;…

Q: Prove that the exponential signal shown in Fig. is non-periodic

Q: In the system shown in Fig. 6.12, two functions of time x₁(f) and (t) are multiplied together and…

Q: For the circuit described by the state diagram of Fig. 5.16 ,1. (a)* Determine the state transitions…

A: (a) Input: 010110111011110 Output: 00100100010001 (b) Equivalent circuit:

Q: write various methods of earthing and explain any one method with sketch with detailed explanation

A: Earthing:- The term "earthing" refers to the immediate discharge of electrical energy that occurs…

Q: problems. Show your complete solution in separate sheet of paper (with graph if possible). 1. Three…

A: Electric field is force per unit charge. Gauss law states that total outward flux in closed surface…

Q: conditions

A: So the correct option is option "A"...

Q: -7. Determine the reflection coefficient for a transmission line with incident voltage E; = 0.2 V…

A: Reflection coefficient RC = Reflected Voltage/Incident voltage…

Q: 1 μF C₁ 100μF www www.l R₁ 56 k Voc +10 V Ⓡ R₂ 12 k Rc 2.2 k 2N3904 Vout HE 1 μF RE 10 ΚΩ beta = 250

Q: For each of the transfer functions shown below, find the locations of the poles and zeros, plot them…

A: The location of pole and zero can be obtained by equating the numerator and denominator part to zero…

Q: 15-13. Determine the efficiency for an antenna with radiated power Prad = 44 W, dissipated power…

Q: Convert the following pairs of decimal numbers to 6-bit, signed 1's-complement binary numbers and…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 12.a. Section ___ requires seals to be installed in a raceway system whenever the raceway changes…

Q: 10 μF 120 k 68 102 0.01 μF 12 V + 310 10 uF %10 Z 8-140, 7-30 k

A: In transistor configuration the dc collector feedback configuration is used to increase the…

Q: 5. Find x[n] for each DTFT given below: (a) Xa(w) = 1+e-jw3 (b) Xa(w) = e-jw1.5, WE [-π, π) ㅠ, (c)…

Q: Estimate the requirement of materials and their I phase overhead Service Connection Cost for giving…

A: single phase service connection to building Length of service main =15 m Total load of installation…

Q: Q3:-Using superposition, determine the current through the (6 2) resistor for network of Fig.2. 82…

Q: circuit. Use the nodal analysis to find the branch current i₁, and node voltages, v₁, and v₂ in the…

A: The required parameters can be calculated by applying kirchhoff's current law to the circuit.

Q: A 2MVA, 2.3kV 3-phase Y-connected alternator operates at rated kVA at a power factor of 80%. The DC…

Q: Using TDR, a transmission-line impairment

A: Velocity factor- When electromagnetic signal passes through any medium then the speed of…

Q: For a 16 ary PSK signals having bit rate equal to 250 kbps the BW efficiency will be?

A: Given, A 16 ary PSK signals having bit rate equal to 250 kbps. M = 16

Q: Oa. 0.09 O b. 0.2 O c. 1.1 O d. 0.01 Oe. 10 RB Q4 + RC ģ Stage 1 a Cm c RC V02 Q2 M R₁ R4 R3 -R3…

A: R1=0.1K R2=1K

Question

Derive the formula for admittance and draw the current triangle and admittance triangle for parallel RL circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Each conductor of a 3-0 overhead line is suspended from a cross arm of a steel tower by a string of 4 suspension insulators. The voltage across the third 33 kV. The shunt capacitance between each insulator and the earth is 1/8th of the capacitance of the insulator itself. Find the voltage across string and string efficiency. D-128 Lod Fa
Using the mesh analysis equation for loop 2 what are the steps for conversion for the division of imaginary numbers with phasors?
Add the VGS = 3.5 V and VGS = 4.5 V curves tothe i-v characteristic . What are thevalues of iDSAT and vDSAT for these new curves?
write all possible KCL and KVL equations. simplify all and in ascending order, with contsant at the right side of the equation.
Draw three transformers for each of the different three-phase connections. That is, draw three transformers and then make the connection, eg star-star, then redraw three transformers and make another three-phase connection, and so on until all four combinations of three-phase connections are made.
Capacitance is ___ proportional with A and ___ proportional with d. directly, indirectly directly, directly indirectly, indirectly indirectly, directly
Question 1.) Fill in the blanks with proper wording a.) For a purely resistive circuit, the voltage and current phasors are b.) For a purely inductive circuit, the voltage and current phasors are c.) For a purely capacitive circuit, the voltage and current phasors are
Develop the mathematical relationships for the design of the inductance and capacitance of a three-phase double circuit line. A three-phase double circuit line consists of two identical three-phase parallel circuits as shown in the figure below. The circuits are operated with a1-a2, b1-b2, and c1-c2 in parallel.
Which of the following statements is/are true? A In purely resistive circuit, the current lags voltage. (B In purely capacitive circuit, the voltage lags current. In purely resistive circuit, the current is in phase with voltage. D In purely inductive circuit, the current leads voltage.
Source Transformation method I=? V50ohm=? P50ohm=?
determine the voltage across (8ohm) by using kirchhoffs law
Schering Bridge is used to find ____________. a. capacitance b. pressure c. inductance d. frequency