decimal.places. step by step solution when two resistors A and B are connected in seriesthe total resistanfe is 50 ohms. When connected in parallel the total resistance is 8 ohms. what are the values of the two resistors?

Q: The following circuit contains 2 A KCL independent equations to fully analyze the circuit. 1K 2K…

A:

Q: thermocouple operates on the principle of temperature difference between the measuring and reference…

A: The working of thermocouple is based on seeback effect.

Q: Draw the energy band diagram of the solar cell following the solar cell diagram below. Indicate the…

A: According to the question, we need to draw the energy band diagram of the solar cell shown below,

Q: 5. Eight rows of lighting fixtures with 7 fixtures in each row, and with each fixture rated for 1.5…

A: The electrical resistance of the conductor material, the frequency of the current, and the…

Q: Given the circuit in the figure below, find the current in the loop: Assume R₂50R₂-120R,…

A:

Q: If we assume the peak voltage Vmax across the capacitor is 16V and the capacitor discharges into the…

A:

Q: Transient (Pulsed) Response of an RC Circuit: Consider the RC circuit shown in Figure 1, where the…

A:

Q: Find V, using Superposition Theorem.

A:

Q: The complex impedance of the series load shown below at a frequency of 60Hz is OHM. 80 μF 10022

A:

Q: Simplify each of the following expressions: (c) xy' + z + (x + y)z'

A:

Q: Convert the diagrams to circuit diagrams

A: It is given that:

Q: Question : Given the period T = 8.16 sec, find the frequency in Hz. Provide your answer in Hz to the…

A:

Q: 5. The Norton's equivalent impedance in the circuit shown below. S 2520°V 3

A:

Q: 3.8. Three identical 9-MVA, 7.2-kV/4.16-kV, single-phase transformers are con- nected in wye on the…

A: The above problem is solved by using per unit system. The detailed solution is given in the next…

Q: HIH V1 12V Q1. V2 1kHz 5V 1 D1 R1 -1k0 L1 1mH XMM1

A: Mode of operation of diode Forward biased mode (Diode ON and  Forward current flow through it)…

Q: Problem 5. Find i₁ in the circuit of Figure 5 if the dependent voltage source is labeled: a. 2v2 b.…

A: We need to find out the current for given circuit with different value of dependent source , we will…

Q: * Assuming vin(t)=2sin(1000ft) volts and using simplified (2nd) diode approximation, the waveforms…

A:

Q: (c) xy' + z + (x + y)z'

A: We need to simplify the given Boolean expression by using of Boolean algebra

Q: 2. For the circuit, find R such that maximum power is dissipated in R, 6 V 150 R 100 ww 2V

A: Given data, Circuit diagram is given as,

Q: An 8-bit ADC has a 25.00 V reference. A) Find the output for inputs of 13.1 v.

A: Given data, Number of bits n = 8. Reference voltage Vref=25 V.

Q: Two transformers are to be operated in parallel such that they share load in proportion to their KVA…

A: Given, Two transformers are to be operated in parallel such that Load ∝ kVA rating The rating of the…

Q: 1. (a) Identify the parts labelled A, B, C, D, E, and F for the motor shown in Figure 12. (b)…

A: dggggggggggggggggg

Q: An SCR having a turn ON time of 5 use, latching current of 50 mA and holding current of 40 mA is…

A:

Q: QUESTION 3 The abbreviations NO and NC represent Normally Open and Normally Closed when used to…

A: Switches: Switch is a most common used electronic device. A electrical switch can normally connect…

Q: In EELE 201 we are learning how to use a set of tools to solve for voltage and currents in linear…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: What are some good reasons to use high-tech lighting

A: Lighting:- Lighting or illumination is the purposeful application of light to produce functional or…

Q: 10. Determine the value of a resistor marked as R22G.

A:

Q: PROBLEMS 3.1. A three-phase, 318.75-kVA, 2300-V alternator has an armature resistance of 0.35…

A:

Q: What color code is used for electric utilities? Red Orange Yellow Blue

A: What colour code is used for electrical utilities

Q: 5. a. Calculate the total capacitance of the follow capacitors connected in series: C₁ -2.5 µF, C;…

A: We need to find out equivalent capacitance for given series combination of capacitor .

Q: 4. The field windings of a series motor has a resistance of 120 ohms at 15°C. After running for two…

A:

Q: v ( + Ika R1 24 2 R2 R5 5 кл R3 3k R4 ?

A: We need to find out the voltage across the given resistor in the given circuit

Q: Vmax, पीप

A:

Q: 1. A galvanometer is to be used as a multi-range dc voltmeter. If the full scale current deflection…

A:

Q: Describe the state-of-charge (SOC) of a battery, and a method of estimating SOC.

A: We need to discuss the state-of-charge (SOC) of a battery, and a method of estimating SOC.

Q: given- W=4 1 and 2-2 + 14 (054+ where XL L=24 {622 2X4=8₂2 1 = ux% 8 find the steady state current…

A: Given question is: Here we need to find The steady-state current and the source power factor. The…

Q: Use Superposition to find the Thevenin's equivalent circuit for finding VR5 and PR5

A:

Q: Find the resistor RT1 and RT2 in Fig 4 in term of resistors. R₁ RT1 M P R₂ www 22 www 2,0 RT2

A:

Q: current at resonance in a series L– C–R circuit is 100µA. If the applied voltage is 2 mV at a…

A: We need to find out the capacitor and resistance for given circuit .

Q: a. Calculate the total capacitance of the follow capacitors connected in series: C₁ -2.5 µF, C: -2.5…

A: It is given that: C1=2.5 μFC2=2.5 μFC3=2.5 μF

Q: 5. Solve for I1, I2 and 13.

A: Given- Source voltages = 16 V, 9 V and 6 V To find Current values I1 I2 and I3 =?

Q: What is the resolution of a 0-5 V 8-bit DAC? 0.0196 0.0039 0.0078 0.0156

A: In this question  We need to choose the correct option We need resolution of the DAC = Vr /2n  Where…

Q: - 8coszt 8400 ain TH m VICE) 3A 2.2 8 Cosat 8L0° : 3 H in F: -2³0

A: Given circuit,

Q: Describe the architects of series and parallel hybrids, and plot how the power is delivered from the…

A: In the parallel hybrid mode, both the engine and the electric motor are coupled to the wheels to…

Q: A 3 phase, 10 kW, 400 V, 4 pole, 50 Hz, star connected induction motor draws 20 A on full load. Its…

A: Given data, No load test=400 V 6A 1002 WBlocked rotor test=90 V 15 A 62 W Output Power P0=10 kW Full…

Q: teristic modes, and impulse response h(t) for each of the following real LTIC systems. Since the…

A:

Q: a www R₁ = 19 ε = 12V b R₂ = 20 d R₂ = 30 e f Use Kirchhoff's Law to solve for the current, voltage,…

A:

Q: simplex lap wound dc dynamo has 800 conductors on its armature, a rated armature current of 1000 A…

A: The basic problem on dc motor is solved as below.

Q: Use the nodal analysis method to find the steady-state expression for vo in the circuit in the…

A: Given: Vg1 = 20cos(ωt-36.87∘)Vg2 = 50sin(ωt-16.26∘) Find: Steady state expression V∘= Vocos(ωt+θ)=?

Q: ) Calculate input resistance and cut-off frequency for open-loop and close loop.

A: The circuit is given as Now the overall gain of the amplifier will be Af=A0L1+βA0L,Here A0L→Open…

Stator and Rotor Magnetic Field

The stator and rotor magnetic field is the resulting magnetic field generated by a system of coils that are symmetrically aligned. They are supplied with polyphase currents. The magnetic field is generated by poly-phase (two or more phases) current or single-phase current. In the latter case, two field stator windings are supplied and two resulting electromagnetic fields are generated beyond the stage.