dec final answer please with clear solution!)  If Vb is equal to 114∠141 and Vbc is 197.454∠111, Vab should be

Q: 7. Determine the following quantities for each of the two circuits shown below... а. R1=SA Rot -…

A:

Q: Using mesh analysis, find Vo. Pg. 4 NAME: 6 V 1 kN 1 kN 1 k2 12 V + 2 k2 Vo

A: Brief description : In the above given question they have mentioned an electrical circuit which…

Q: Implement the given notation using multiplexer:   H (K,J,P,O) = π (0,1,3,5,6,10,13,14)  Include…

A: Brief description: For the given maxterms we need to write truth table and the multiplexer…

Q: 6.0N 4.00 12 V 120 3.00 5.0 N 2.0 A. O 2.5 A. 3.0 A. 3.5 A. 4.0 A.

A:

Q: no load test, VNL= 220 V P= 310W INL= 6.2 A load test , V = 220 V P;= 3650 W N = 1710 rpm %3D | =…

A:

Q: (2.2 t + cos 3.2 x(t) = sin TT

A:

Q: Q8) The magnate circuit show in Fig.(5) has an air gap whose length is 2mm. The cross-section of the…

A: It is given that: A=1 cm2lairgap=2mmlpath=5.8cmμr=555I=240mAN=980

Q: c) A 75 MHz uniform plane wave having an electrical field amplitude of 12.5 V.m propagates in a…

A: Electric field: It is a region of around of a charge particle in this region a charge particle feels…

Q: 88. What is the maximum safe current flow in a 47 2, 2 W resistor? (i) 0.42 A (iii) 0.63 A (iv) none…

A: Given, Resistance, R=47 Ω Power rating, P = 2 W

Q: 1. Using a three (3) variable map, draw the simplified logical circuit for the ff; а.) А ВС +…

A: As per the guidelines of Bartley we supposed to answer first question only for solution of remaining…

Q: A 120-km long, 3-phase, 50-Hz, the line supplies load of 60 MW at 0-8 p.f. Lagging at 44 kv at the…

A: In this question we need to find a sending end power factor , regulation and transmission efficiency

Q: 5. A set of independent voltage measurements taken by five observers were recorded as: Set: 217.02…

A:

Q: uestion # 31- 40) For a Fixed-Bias Configuration, if: = 2.2 kQ E= 7.2V = 0.005 lĘ = 3.98 mA Ive for…

A:

Q: 16 T(s) s2 + 3s + 16

A:

Q: The value of inductance per conductor in a three-phase line is time(s) the loop inductance for the…

A: As per the guidelines of Bartley we supposed to answer first question since the remaining question…

Q: For a citizens band receiver using high-side injection with an RF carrier of 27.04 MHz and a 10.645…

A: It is given that: fRF=27.04 MHzfIF=10.645 MHz

Q: For a standard AM receiver with an RFcarrier of 1500 kHz and Q = 150, determine а. Local oscillator…

A:

Q: A coil develops heat of 800 cals/sec, when 20 V is applied across it. The resistance of the coil (1…

A: Relationship between developed heat or energy by resistance is given as E=(V2/R)   j/s Where R=…

Q: Find the transfer function of the second order recursive filter in frequency domain whose impulse…

A: given impulse response is hn=rnsinwon un here we have to determine the transfer function for the…

Q: 8.31 Calculate v,(1) if i,(1) = 7 cos 100t A and i,(1) = 3cos(100r + 45°) in Fig. P8.31. + i1(1) 10…

A:

Q: An AM receiver has 3 cascaded RF amplifiers arranged such that the IFRR successively increased by…

A:

Q: 17. The energy that's lost in a DC motor is rather small. Most of the energy is lost as A. windage…

A:

Q: b) Use Thevenin to determine Vo 12 V A 1 kn ww 1 kn 2 kn 2 kn 1 kN V. 2000 I, B

A: We need to determine Vo using Thevenins theorem.

Q: 5. Given the information provided in figure, determine: (a) Ic. (b) VE. (c) VB. (d) R1. 18 V 4.7 ka…

A:

Q: CR active filters find extensive use in communications and instrumentation measurements. ) By…

A: Filter: It is a circuit that attenuate some signal and pass the other signal. It reduces the noise…

Q: 19.a. The magnets that are used in the field of a quality DC PM motor are made from A. rare-earth…

A: Operation of permanent magnet DC motor depends on the flux and flux is produced by magnets. So the…

Q: Given the first-order system whose transfer function is C(s) 1 R(s) (Ts + 1) Get the temporal…

A: Transfer function is given as, C(s)R(s)=1(Ts+1)For Ramp input R(s)=1s2C(s)=1Ts+1×1s2C(s)=1s2Ts+1

Q: a). Determine RL for maximum power transfer in the circuit below with both an independent and a…

A:

Q: Calculate the bandwidth in kHz Blank 1 and an inductor’s Q Blank 2 at100MHz. It has an inductance of…

A:

Q: 3 An abe-phase-sequence three-phase balanced wye- connected source supplies a balanced…

A:

Q: Explain the operation of the circuit below. Include a description of its output waveform, including…

A: The given circuit diagram is shown below:

Q: 6- Draw the logic cireuit and state dingram ofS-hit ring counter of an initial state 01000. 7-…

A: As per the guidelines of bartleyby I need to answer first question only so kindly repost other…

Q: 8.3 Fixed-Bias Configuration 17. Determine Z, Z, and A, for the network of Fig. 8.71 if Ipss = 10…

A:

Q: QI: Evaluate the current 1 by using mesh analysis method for the circuit in Fig. 1 6n ww -120 Fig.…

A:

Q: Find the transfer functions for the systems shown. G1 (s) G2 (s) C(s) H1 (s) H2(s)

A:

Q: eq" he following circuit. Determine R 5Ω 10 2 10 2 Rea V 8Ω 4Ω

A:

Q: A 3-phase, 400-V, synchronous motor takes 52.5 A at a power factor of 0.8 leading. Calculate the…

A:

Q: A copper conductor has a diameter of 0.6 in and it is 1200 ft long. Assume that it carries a total…

A:

Q: More dense fuels have a longer burning time. True False

A: Solution True

Q: Use graphical method of convolution to find and plot the output of an LTI system with t-3 h(t) =…

A: In this question we need to find and plot the output of the given LTI system.

Q: The input (t) = u(t+2) - u(t- 2) is applied to an LTI system with impulse response h(t) = t. The…

A:

Q: Calculate for damping ratio, natural frequency, delay time, rise time, peak time, settling time and…

A: In this question,  We need to calculate for damping ratio, natural frequency, delay time, rise time,…

Q: Q2 / Answer TWO ONLY of the -: following 1- Numerate () FIVE Advantages of Real-Time Systems 2-…

A: There are the few questions related to the basic understanding of data transmission and networking.…

Q: Q2) Given the transfer function of the system (plant) as follows: B(s) s+6 A(s) 4s2 – 8s + 5 1-…

A:

Q: The transfer function of discrete time system is given by: H[2) =- -:'+0.8z -0.8 2'-1.19 a) Sketch…

A: A discrete-time system is a system whose input as well as output consists of discrete-time…

Q: Q1:- Find i, (t) and i2(t) in the following circuit: 50 0.02 F 250mH 18 cos(20c) 80 mH 12 cos(20r +…

A:

Q: Q8) For the network of Fig.7 a) Find the resonant frequency f». b) Calculate the magnitude of V, at…

A: The given circuit diagram is shown below:

Q: Hat

A:

Q: Solve for the mesh currents in the circuit below. 12 V 9 Ω I3 8 V 10 2 11 2 6 2 4 2 3Ω 20V 10V…

A:

Q: R1 2.2 kQ + R2 30 V 2.7 k Q R4 3.6 k Q R3 3 k N 31 ww ww

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.