d. Suppose that the cylindrical tank in the accompanying figure is filled to a depth of 4 feet at time t = 0 and that the water discharges from a hole at the bottom of the tank at the rate shown below. How many minutes will it take for the tank to drain completely? discharge flowrate = 0.025 √h, ft³/sec 4 ft 1 ft

d. Suppose that the cylindrical tank in the accompanying figure is filled to a depth of 4 feet at time t = 0 and that the water discharges from a hole at the bottom of the tank at the rate shown below. How many minutes will it take for the tank to drain completely? discharge flowrate = 0.025 √h, ft³/sec 4 ft 1 ft

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 89P: A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be...

See similar textbooks

Similar questions

The flow of blood through a 2.00106 m -radius capillary is 3.80109cm3/s . (a) What is the speed of be blood now? (b) Assuming all the blood in the body passes through capillaries, how many of them must there be to carry a total flow of 90.0 cm3/s?
A rock with a mass of 540 g in air is found to have an apparent mass of 342 g when submerged in water. (a) What mass of water is displaced? (b) What is the volume of the rock? (c) What is its average density? Is this consistent with the value for granite?
What is the fluid speed a hose a 9.00-cm diameter 80.0 L of water per second? (b) What is the flow rate in cubic meters per second? (c) Would your answers be different if salt water replaced the fresh water in the fire hose?
(a) Using Bernoulli's equation, show that be measured fluid speed v for a pitot tube, like the one in figure 14.32(b), is given by v=( 2gh)1/h , where h is be height of be manometer fluid, p' is the density of the manometer fluid, p is the density of the moving fluid, and g is be acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in text) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
Archimedes' principle can be used to calculate the density of a fluid as well as that of a solid. Suppose a chunk of iron with a mass of 390.0 g in air is found to have an apparent mass of 350.5 g when completely submerged in an unknown liquid. (a) What mass of fluid does the iron displace? (b) What is the volume of iron, using its density as given Table 14.1? (c) Calculate the fluid's density and identify it.
A cylindrical tank with a large diameter is filled with water to a depth D = 0.30 m. A hole of cross-sectional area A = 6.5 cm2in the bottom of the tank allows water to drain out. What is the drainage rate in cubic meters per second?
Suppose you want to fill up a swimming pool that has a capacity of 80500 L. a. Calculate how many hours it would take to fill this pool using a garden hose delivering 59 L/min. b. How many seconds would it take to fill this pool if you could divert a moderate size river, flowing at 5000 m^3/s, into it?
Gasoline leaks out on the hole ½ inch in diameter at thebottom of the tank at the rate of 10 gal/min. How high isthe gasoline in the tank.
31. A Ferry boat has 5000 kg mass with a total volume of 30 cubic meters. For safety reason, the maximum load is reached when 75 % volume of the boat is submerged under water. Find the maximum load (excluding the mass of the boat.) a. 6667 kg b. 22500 kg c. 20000 kg mg Mg FB = Sfluid Vfluid g T /// d. 17500 kg Hint: Vfluid V 20.75
Problem: A 1-m diameter and 1.6-m height cylindrical drum is filled with a fluid whose density is 850 kgm/m3. Determine the following: a) Volume of the fluid in ft3. b) Mass of the fluid in Ibm. c) Specific volume in ft3/lbm- d) Specific weight in Ibf/ft.
Cater would happ -h, if the water water with a density A. Ir. I'V ase e sam hin Dalm Problems from "The MCAT Physics Book" A pipe with a circular cross section has water flowing in it from A to B. The radius of the pipe at A is 6 cm, while the radius at B is 3 cm. At end A the flow rate is 0.06 m/s. 20. What is the flow rate at end B? A. 0.03 m/s B. 0.06 m/s C.0.12 m/s D. 0.24 m/s 21. A tiny propeller is inserted at point B in order to measure the velocity of the water. What does it read? A. 21 m/s B. 67 m/s C. 85 m/s D. 96 m/s while 22. A pipe has a circular cross section, such that the radius of the pipe at point A is r the radius at B is B. An incompressible fluid is flowing through the pipe at flow rate f. The velocity of the fluid particles at point A is VA Which expression gives the velocity of the fluid particles at point B? A.frB B.fr C.firB D. VA 2 2 FB A tank of water has a hose coming out of the top. The hose is filled with water and the other end is below the tank, so that…
A right conical tank with the point oriented down, a height of 17 feet, and a radius of 5 feet has sprung a leak. How fast is the volume of water in the tank changing when the water is 6 feet high and the water level changes at a rate of 2 inches per minute?