Create a chemical equation based on this procedure below depicting the reaction being conducted. It should include ALL starting materials, catalysts, and solvents, as well as the product, but omit sulfur dioxide. Make sure the product has a proper name, along with molar mass Mix 2.5 g of sulfolene, 5 mL of xylene, and 1.25 g of maleic anhydride in a 50 mL round bottom flask. Fit the flask with a water‐cooled reflux condenser. Heat the contents of the flask using the thermowell until the xylene begins to gently reflux, and then maintain the reflux for 45 minutes. Once the reaction mixture has refluxed for 45 minutes, turn off and lower the thermowell, allowing the flask and solution to cool to room temperature. After the flask has reached room temperature, cool in an ice bath. Collect the crude product by vacuum filtration. To purify the crude product, recrystallize in 2:1 v/v1 xylene : hexane. Wash the crystals with hexane and allow the recrystallized product to air dry in the funnel for 10 minutes.

Based on your research and observations, write the balanced chemical equation/s of the sample/s that will give positive test for Baeyer's reagent.   Samples: hexane, cyclohexene, tert-butyl chloride, toluene, water

Please answer the question at the bottom, Thanks. LAB NOTES FOR PREPARATION OF BUTYL MAGNESIUM BROMIDEAND ITS SUBSEQUENT CONVERSION TO AN ALCOHOL To the reaction flask were added 2.5967 gram of magnesium turnings, about 20 mlof diglyme, and a solution of 13.5942 gram of butyl bromide in about 25 mldiglyme.The procedure as per the lab manual was initiated. After the required heating timewas completed the reaction mixture was allowed to cool to room temperature.Then a solution of 6.1123 gram of acetone in about 15 ml of diglyme was addeddropwise as per the lab manual.The rest of the lab manual procedure was completed, ultimately affording 2.5532gram of an oily, clear and slightly yellow liquid, presumed to be 2-methyl-2-hexanol. Boiling point as measured by distillation was 138 – 141 deg C.About 0.8 ml of the presumed 2-methyl-2-hexanol was placed in an NMR tube towhich was added 2 drops of TMS. The tube was capped, then inverted and righted20 times to thoroughly mix the product and…

Draw the synthesis setup for Ni(dppf)Cl2, make sure to include the round-bottom flask, reflux condenser, hotplate, and the connections to the vacuum and water-cooling systems. Design an experiment remove separate Ca2+ and herbicide Atrazin (organochloride) from aqueous salt solution.