Answered: Consider the system defined by i = Ax +…

Consider the system defined by i = Ax + Bu y = Cx 1 where, A = 1 -6 -11 -6| B = |0| and C =[10 5 1] Check the system for complete state controllability

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The input power to a three-phase motor was measured by two wattmeter method. The readings were 10.4 ...

Q: Y(s RO) Et

A: Given Signal flow diagram shown

Q: Express the Boolean function, F(X, Y, Z) = Z' + XY', as a) a sum of Minterms b) a product of Maxt...

A: The given boolean function is shown below: FX,Y,Z=Z+XY¯

Q: Determine the commutator pitches Y. for the following wave-wound armatures: (a) 75 segments, four po...

A: This question belongs to electrical machine . It is based on the commutator pitch for a wave wound a...

Q: SCR is a three layered three junction power electronic switch? a.True b. False

Q: H.W. For the circuit shown below, calculate the value ofRL which absorbs maximum power and then calc...

Q: An Alternator having three-phase, 3-wire ABC system supplying an effective line voltage of 120 V, ha...

Q: How many parallel paths are there in (a) a 10-pole frog-leg winding? (b) an eight-pole frog-leg wind...

A: a ) for a P- pole frog leg winding there are 2* P ,parallel paths P = 10 ...

Q: 2. A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source. Calc...

Q: What is the characteristic time o

Q: 5. How do you measure the current using a multimeter? 6. How do you measure the voltage using a mult...

A: 5. How do you measure the current using a multimeter ? Ans : connect the multimeter in series to mea...

Q: 5Ω -10 Ω 2Ω ww wwo 60/120° V ( j20 2 Find Zth.. ele

Q: find the output waveform for the circuit in figure (3) JAP Ivin3D4 sin wt VR 2V Figure (3)

A: In open loop opamp acts as comparator and output switches between saturation values. If voltage at n...

Q: (b) Specifications of a boost converter operating in discontinuous current mode are that the input v...

Q: Obtain the closed-loop pulse transfer function (G(z }=C{2 )/ R{z}}of the following system. Ela) Ciai

Q: A 54-slot 216-segment armature has a four-pole lap armature that is equalized 100 per cent at the co...

Q: single phase fully controlled bridge is operated with a resistive load R = 10 Ω, the input voltage t...

A: In this question we have given single phase fully controlled bridge rectifier with R load....We have...

Q: An Alternator having three-phase, 3-wire ABC system supplying an effective line voltage of 120 V, ha...

Q: X) Answer the following questions (answers to be typed, handwritten answer for this questio will not...

A: "since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: OR gate with a small circle on the output gives the symbol of a O a. EX-NOR O b. NOT O c. EX-OR O d....

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output vo...

Q: Answer the following questions (a)What is a clock signal? (b)Differentiate between positive going p...

A: 1) A clock signal oscillates between high and low states in electronics, particularly synchronous di...

Q: Q 4. Using the Kirchhoff's Rules determine the followings. (a) Current I, through resistor R1: Magni...

A: Given

Q: What is the importance of determining the solar constant? Why is there a need to assess the availabl...

Q: (а) [(5 + /2X-1 + J4)-5/60'] 10 + j5 + 3/40 (b) + 10/30° + j5 -3 + j4

A: a z =5+j2-1+j4-5∠60° = -5 -j2+j20-8-5cos60°+j5sin60° = -13 +j18-2.5-j4.33z = 20...

Q: Problem 26: Use mesh analysis to find the current through the resistor. R5 3 0 R3 R2. 10 Ω Ri 4 0 R6...

Q: Evaluste VCH in the transistor circuit ahown below. The transistor is of silicon and has B-150.

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If y...

Q: A capacitor consists of two parallel plates in air with a distance of 0.8cm between them. The area o...

A: Given, A parallel plate capacitor in air Distance between plates, d=0.8 cm Area of plate, A=40 cm2 ε...

Q: : Mention and explain any 4 the differences between conducting and Non-conducting wires

A: Conducting and Non-conducting wires:

Q: 1. A 440V, 3-phasen A.C motor has a power output of 11.25 kW and operates at a power factor of 0.8 l...

Q: 3. At a certain temperature, the velocity of electrons in an intrinsic silicon material is 120m/s. T...

Q: A coil has a resistance of 4 ohms and an inductance of 2H. It is connected to a 20V dc supply. Calcu...

A: Given: A coil have Resistance, R=4 Ω Inductance, L=2 H Supply V=20 V dc

Q: A load of 1250 KW is connected at the receiving end of a 3 phase transmission line 70 km long. The p...

Q: Data collection Voltage: 20.1W Current: T1 T2 T3 T4 T5 T6 T7 52.6 C 50.3 C 48.1 C 37.0С 27.4 C 26.4 ...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: Bidirectional shift register can be used to perform multiple operations. Design a 4-bit bidirectiona...

A: Solution:- AD-FF gives output same as input upon giving a clock pulse. Here, P3, P2, P1,P0 - Parall...

Q: A water jet cinsume 3450 W for 126 hours a week. 1. What is the energy consumed (kWh) for one-year...

Q: 4. A transmission line has a characteristic impedance of Z = 21.05260.4° with propagation constant o...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 A B R1 R3 R5 10 V1 12 R...

Q: Convert to integral form. Use either Gauss or Stokes theorem V × F = x

Q: Q3 Given z,=(3+j4)² and z,= 2.5jej40x a. Find z¡+Z2 b. Find the magnitude and phase of z,z2

A: Given Z1=(3+j4)2 Z2=2.5ej40π

Q: 1) Calculate the current (I) in the following circuits using mesh analysis. 10 2 6 V 6 V 42 12 ww 12...

Q: 5. A 15 kVA, 2300/230 V, 60 Hz transformer has the following constants: R; = 2.7 2, X, = 9.1 2, R2 =...

Q: Two resistors 5 kQ and 20 k2 are at 27°C. Calculate the thermal noise power for a 10 kHz bandwidth f...

A: R1 = 5k R2 = 20 k T =temperature= 27°C = (27 + 273) K = 300K B = Bandwidth= 10 kHz

Q: Example 4 Find the switch equivalent circuit of a diode with an AC source voltage Vs. as shown in Fi...

A: Consider the terminals of the diode are shown below. Here, the left side is the positive and the ri...

Q: Total capacitance of two capacitors of 20 mF connected in parallel will be:

A: Given that Two capacitors of 20mF are connected in parallel. Find the equivalent capacitance of tho...

Q: The following data were obtained when a 25 kVA, 2300/460 V, 50 Hz transformer was subjected to open-...

Q: Determine v o for each network of Fig. 2.177 for the input shown

A: In this question , we will find output voltage vo for given diode circuits...

Q: Explain anyone practical measurement system with all of its functional elements

A: The practical measurement system includes modern measuring instruments such as multimeter, oscillosc...

Q: 1. A relay coil is connected to a 210-V, 50-Hz supply. If it has a resistance of 30 2 and an inducta...

Q: Using Thevenin's theorem, find the current through RL. (12 0) resistor shown in figure 5. 60 48V RL ...

A: In this question, We need to determine the current in the resistance RL using the Thevenin theorem...

Concept explainers

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.

Question

100%

Consider the system defined by
i = Ax + Bu
y = Cx
1
where, A =
1
-6 -11 -6
B= |0| and C = [10 5 1]
Check the system for complete state controllability

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

7.what do you mean by instruction cycle,mechine cycle and T- state
i just want a paragraph of these sensors and their function and which is best then the other.PZT-5HPZT-5JModif. PZT-5A
Test the accuracy of the equation by applying the operation in Ampere law (del.)? If there is a mistake, correct this mistake.
What is transition ?
2. Consider the following circuit D å lå a. Find the expressions for D, T, Qo*, Q₁*. b. Write the transition output table. c. Draw the state diagram of the circuit. d. Is this a Mealy or Moore machine? Explain. T 21 a la 1
ASYNCIN Dan Synchronous System CLOCK Figure Q4 (b) The circuit in Figure Q4 (c) consists of edge triggered flipflops. The second flipflop receives the clock signal through a long slow path which results in delay. Answer the following questions: Q1 Q2 IN DaK CLOCKD CLK CLOCK A long, slow path Figure Q4 (c) 林 Define clock skew, Explain with a timing diagram, what problem this circuit might face? What condition it must satisfy to ensure that the intended circuit output is not affected? For the following LFSR circuit in the Figure Q4 (d), let the initial entries of stages R, be S, for 0sisn. Compute the first 12 bit output for the following cases of initial entries: (d) S2 Si So Case 1 Study Pack Practice &A Case 2
Explain the meaning and give a practical significance of the unit step signal and ramp signal
- In d.c. generators armature reaction is produced by armature current O none of the mentioned compensating winding current field current O commutating winding current The use of d.c. generators elminated the use of rectifiers and ac supplies True False s If the number of layerallot is 4 then the number of colls the number of slots Equal to O none of the mentioned O twice O half O s In 2-pole machines: the wave winding have greater generated voltage than the lap winding'armatures True False For high rotating speed machines the number of poles munt be Little Tiue O Fale O O O
Signals and systems lesson question
How would I approach this question? Do I need to use Kirchoff's junction rules or can I just subtract the voltage drop?
A 120 Vp is applied to the primary coil of a center-tap transformer of turn ratio (n1 : n2 = 6: 2) . If the secondary coils are connected to a Ge diodes center-tap full wave rectifier, the output DC voltage is about __________. *1- 13.42 V2- 14.15 V3- 15.58 V4-12.54 V5- 16.23 V
What is the difference between a positive clamper and a negative clamper? Explain with the aid of circuit diagrams and output waveforms.