consider the spectrum magnitude of a signalshown. From this graph, most nearly, what isthe fundamental frequency of x(t)?Magnitude Spectra of xt)25225211.50.5-1.5050.5Frequency (Hz)0.75 Hz0.25 HzThe correct answer is not among the alternatives.0.5 HzDC signal, has no fundamental frequency() epryubey

Since the fundamental frequency comes out to be 1Mhz clearly can be seen from the plot .

consider the spectrum magnitude of a signal shown. From this graph, most nearly, what is the fundamental frequency of x(t)? Magnitude Spectra of xft) 25 225 21 15 0.5 -1.5 05 0.5 Frequency (Hz) 0.75 Hz 0.25 Hz The correct answer is not among the alternatives. 0.5 Hz DC signal, has no fundamental frequency Magritude (v)

consider the spectrum magnitude of a signal shown. From this graph, most nearly, what is the fundamental frequency of x(t)? Magnitude Spectra of xft) 25 225 21 15 0.5 -1.5 05 0.5 Frequency (Hz) 0.75 Hz 0.25 Hz The correct answer is not among the alternatives. 0.5 Hz DC signal, has no fundamental frequency Magritude (v)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

J: A 600 Hz incoming sine wave results in a gain of -3db. The frequency is changed, resulting in a gain of -2db. Was there an increase in frequency? C1 Vb Va + R1
Please answer in typing format solution
Convert to rectangular form: (a) 2Đ15°, (b) 3Đ-10° a). b)
2. Write an OCTAVE program to plot the signal given below P=Pmax Sin(2πft); where Pmax=10 MW, f=60 Hz Find out time.peniod and verify it with graph. Assume necessary data.
i need the answer quickly
An AM broadcast station operates at its maximum allowed total output of 50 kW with 80% modulation. The power in the intelligence part is a) 12.12 kW b) 31.12 kW c) 6.42 kW d) none of the mentioned
The pulse voltage waveform displayed on a CRO, is shown in figure given below. Find, (a) Frequency. (b) Magnitude of the pulse. (c) The amplitude. 21 0.5 5 0.2 10 20-(Vicm 5 ms 100 us 50 ms time/om 500 ms 30- 40 50 2s
Question 3 A step-up chopper has input voltage of 225 V and output voltage of 385 V. If the non- conducting time of thyristor is 60 µs, compute the pulse width of output voltage. In case the pulse width is 3/4th for constant frequency operation, find the new output voltage.
04. How ado the effeetive value of an you depine AC wuavebm ? UDeteunine the R.M-S valilk of wave f derivation) full suctified"
3. Determine the total harmonic distortion if the fundamental amplitude of 12 V and the %2nd order, %3rd order, %4th order, and %5th orders are 3.5%, 2.25%, 1.75%, and 2.8% respectively.
What happens to the impedance for The frequencies between 1Hz-40KHz for RLC series parallel combination. Justify your answer.
Find the voltage V shown in the figure below. 119/0-v+ 60 www -j6n V Enter (a) the amplitude and (b) the phase angle. The phase angle must be in the interval (-180?, 180?].