Consider the series-shunt feedback amplifier of Figure below. Assume that the voltage divider (R1, R2) is implemented with a 1-MQ potentiometer. Assume that the MOSFET is biased so that gm 4 mA/V and r, is large. Also, Rp = 10 k2. A VDD Find the value of R1 that results in a closed-loop gain of 5 V/V. Rp R2 R1 V,

Consider the series-shunt feedback amplifier of Figure below. Assume that the voltage divider (R1, R2) is implemented with a 1-MQ potentiometer. Assume that the MOSFET is biased so that gm 4 mA/V and r, is large. Also, Rp = 10 k2. A VDD Find the value of R1 that results in a closed-loop gain of 5 V/V. Rp R2 R1 V,

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. The circuit uses current- (or shunt-) feedback bias. The Si transistor has ICEO = 0, VCEsat =0, and B= 100. If RC = 2k and VCC =12V, size RF for ideal maximum symmetrical swing (that is, location of the quiescent point such that VCEQ =VCC/2). +V cc RC Cc Rs RL VL Cc R. R
What is a typical value of open-loop, low-frequency gain of an op-arop circuit? How does this compare to the ideal value?
2. For the Feedback Amplifier circuit shown in Figure 4, determine the following: a. Identify the type of sampling and mixing for the amplifier. b. Calculate the feedback factor for the amplifier. c. Draw the small signal equivalent circuit for the amplifier with no feedback and calculate the voltage gain without any feedback. d. Calculate the voltage gain with feedback. e. Calculate input and output resistances of the amplifier with feedback. B=100; 2=2.5k12. No DC Calculations necessary. +15V IK: Vs look TON't 27k fig. lONf -15V 4. €2.5k ZONE lk $250 Yout F₂0 =20NF lok
Derive a mathematical expression to determine the stability factor for voltage – feedback bias circuit 3- S(β)
The transistor parameters for the circuit in Figure are B, =B2 = 100, VBE1on) = VBE2ton) = 0.7 V, and %3D VA1 =VA2 =0.Find the small signal voltage gain Av = vo/vs. (Note that V-=0.026 V) Vcc=9 V Rib Q1 Vs 1 ko -Ro 20 V 100 Q -ww
Design an op-amp circuit that can perform this operation: Vo = 2V1V2 – 3V3. Marking Scheme: 1. Circuit Diagram 2. Calculation with Assumptions
Assume an inverting amplifier with input resistance 1 kilohm and feedback resistance of 100 kilohm. If the op-amp has GBP = 1 MHz, what is the closed loop amplifier bandwidth?
solve a,b and c please. a. Define on-off ratio. Why series JFET has higher on-off ratio as compared to shunt JFET? b. Compare inverting and non-inverting amplifier? c. calculate the closed loop gain of the circuit diagram given below.
Table Q2 shows the datasheet comprising the parameters of a practicalop-amp. Please answer the following questions with reference to the data inTable Q2. Determine the full-power bandwidth for a 10-V output. Using the typical values from Table Q2, find the magnitude of thecommon-mode gain, Acm.
Question 3: Please write answers to all parts of the question in the separate dot points as shown What is the circuit called? Discuss all components including voltage sources. Which components determine the closed-loop gain of the circuit? Describe the slew-rate of the op-amp. Describe the Common-Mode-Rejection ratio of the op-amp? What is the unity gain bandwidth? Describe the gain bandwidth product (GBP). Describe the GBP relationship between the break (critical) frequency and the gain? What two methods calculate the max frequency? If one produces a higher value of maximum frequency than the other, which would you use as the maximum frequency?
Q3 a) Show that negative feedback can reduce the sensitivity of an amplifier circuit, by deducing the expression of dAd/dAo]- b) Figure Q3.b shows a discrete transistor feedback configuration. Vcc RC RF O vo Vi Rs Figure Q3.b 1) Identify the feedback topology of this configuration. 2) What type of amplifier is this configuration? How the feedback can affect its input and output resistances? 3) Draw the small-signal equivalent circuit and derive the closed loop transfer function. c) Copy the following table into your answer book and complete it with either 'infinite' or 'zero'. Please note that table is for ideal amplifiers. Input Resistance Output Resistance Voltage amplifier Current amplifier Transresistance amplifier Tranconductance amplifier
3. Inverting Amplifier is a normal OP-Amp in which the output is given as feedback with a feedback resistor. i. Draw a circuit diagram for the inverting amplifier. Derived the expression for the closed loop gain for the inverting amplifier. iii. In an inverting amplifier input resistance (R1) =2.2 k2 and feedback resistance 220kN. Calculate the closed loop gain for the inverting amplifier.