Answered: Consider the following: the latency of…

Consider the following: the latency of an interconnect is 2 seconds, and the bandwidth is 64 bytes per second. Calculate the time it takes to transmit a message of size 256 bytes ?

Operations Research : Applications and Algorithms

4th Edition

ISBN:9780534380588

Author:Wayne L. Winston

Publisher:Wayne L. Winston

Chapter20: Queuing Theory

Section20.10: Exponential Queues In Series And Open Queuing Networks

Problem 8P

See similar textbooks

Related questions

Q: Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During…

A: Given: TDM based circuit switching networks is transmits and receive signals on a single path by…

Q: Evaluate the modulation dep Calculate the carrier power, Draw the block diagram mathematical…

A: Evaluate the modulation depth m, and mention the type of this AM system. The modulation depth (m)…

Q: Identify the shortest path from A to C. B 5 A O a. 9 Ob.-3 O c. 5 Od. 6 3 D -3 -2 4 E

A: We have different path from A to C: A→B→C A→D→E→C Now the weight for each path, A→B→C : 5 + 4 = 9…

Q: If a system has an average power level of 200, an average noise level of 6.66, and a bandwidth of…

A: The Answer start from step-2.

Q: A DMS has an Entropy H = 2.585 bits/symbol for a message with equally likely symbols. Now suppose…

A: ANSWER:-

Q: An automated water tank system consists of Flash ADC, DAC, sensor and motor where sensor gives…

A: Please find the answer in step 2

Q: voice messages work in the 700 high frequency of 10 kHz and low frequency of 2 kHz and 10 video…

A: Ans

Q: Taking the speed of the radio signal as 3x108 meters per second, calculate the time taken for a…

A: Given that, Speed of the radio signal = 3×108 m/s Distance between the GPS satellite and GPS…

Q: Consider the following signal encoding technique. Binary data are presented as input, am for m=…

Q: Q2: A broadcast station was transmit AM wave with carrier frequency of 130 KI modulation index of…

A: It is defined as a downlink channel in a GSM system that is used by the base stations to provide…

Q: Consider a digital multimedia transmission system. Separate audio and video coders are used to…

A: In a digital multimedia transmission system, separate audio and video coders encode signals and then…

Q: uppose that data are stored on 2.44 Mbyte floppy diskettes that weight 20 gm each. Suppose that an…

A: Introduction

Q: in the communication channel every 0.0125 ms and no, communication errors are taken into account,…

A: The analog signal is sampled at a sampling frequency of 20O0 Hz using a 256 sampling level.a) How…

Q: a. Compute for the data efficiency of transmitting if the data format is a General Synchronous Data…

A: a. Compute for the data efficiency of transmitting if the data format is a General Synchronous Data…

Q: (a)What is the probability of message error for an uncodedblock of 92 bits if the channel symbol…

A: In coding, linear codes are known as error-correcting codes. Some sequence or blocks of codes are…

Q: 3. Find the time delay for the delay subroutine shown as follow, if the system has an S051 with…

A: The CPU takes a particular number of clock cycles to perform an instruction. These clock cycles are…

Q: Don't use ai to answer I will report your answer.. Solve it Asap with explanation and calculation…

A: Let's tackle the problem step-by-step.Part (a)Problem Statement:Consider transmitting 1000 bits.…

Q: Please solve this question in multimedia networks quickly

A: Encoded message: Count = 100 (total) Character = 6 * 8 bit = 48 bit Code = 1 * 3 + 3 * 4 + 2 * 5…

Q: For a computer system using a 64 bit width data path, how many number of a bits will this computer…

A: А соmрuter аlоng with аdditiоnаl hаrdwаre аnd sоftwаre tоgether is саlled а соmрuter…

Q: In 8 bit data transmission system the transmitted data X, Y and Z after adding an EVEN Parity. The…

A: Given 8 bit transmission system the transmitted data X,Y,Z after adding an EVEN parity and we need…

Q: The Amplitude Modulation (AM) is a technique used in communication for transmitting information via…

A: Step 1: Define parameters vc, vm, fc, fm and dt. Step 2: Declare time vector which takes value…

Concept explainers

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.

Question

Paralell computing

Consider the following: the latency of an interconnect is 2 seconds, and the bandwidth is 64 bytes per second.

Calculate the time it takes to transmit a message of size 256 bytes ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Unless specified otherwise, use the free space propagation speed of light 3x108 m/s to calculate the propagation delay. For numerical calculations, the results must show the appropriate unit. Show a complete solution for each problem3. Consider a digital multimedia transmission system. Separate audio and video coders are used to encode these signals. Audio and video bits are packed in packets together and transmitted over a transmission link. Each packet is 2,000 bytes long, which includes a 48-byte header. The system generates one packet every 40 ms. Calculate the following values:a. The minimum data transmission rate required to support the above system.b. The minimum signal-to-noise ratio (SNR) in dB required to transmit the above audio and video information. Assume a 400-kHz transmission channel bandwidth is used.c. The end-to-end packet delay over a 50-km link, using answer in Part a).
Suppose you are designing a sliding window protocol for a 1-Mbps point-to-point link to a stationary satellite revolving around the earth at 3 x 104 km altitude. Assuming that each frame carries 1 KB of data, what is the minimum number of bits you need for the sequence number in the following cases? Assume the speed of light is 3 x 108 m/s. (a) RWS=1 (b) RWS=SWS
Suppose there is a b+n (Sum of first and last digit of your Reg#) Mbps microwave link between a geostationary satellite and its base station on Earth. Every minute the satellite takes a digital photo and sends it to the base station. Assume a propagation speed of 2.4*108 meters/sec. 1. What is the propagation delay of the link? 2. What is the bandwidth-delay product?
Consider a communication channel with bandwidth B = 8000 Hz. Suppose the channel has a signal-to-noise ratio S/N = 541. What is the maximum data rate of this channel? ? What is the minimum number of signal levels needed to achieve a data rate of 64000 bps?
The Amplitude Modulation (AM) is a technique used in communication for transmitting information via radio carrier wave. AM works by varying the amplitude of the transmitted signal in relation to the information being sent. The equations of the carrier signal, the original signal to send, and the modulated signal combining the two signals are respectively: VI-V sin (2nfet) V2=Vm sin (2πfmt) V3-V sin (2nfet)+V sin (2nft)* sin (2nft) Supposing that V-Vm-1, fc-20, fm 1. Write a MATLAB program that plots the three signals with single call, the graphs must be contain (desired title, axis labels, annotations, with symbols for color, style, and marker) for each graph. Use the step 0.0025 for the time.
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. What is the shortest time possible (in seconds) to transmit a 1 Mbyte file over the given link?
Data communication Suppose that the spectrum of a channel is between 8 MHz and 10 MHz, and the intended capacity is 8 Mbps. 1= With multiple signaling level, how many levels are required to obtain this capacity and how many bits can be transferred with each signal element? Constant values= c=3x^10°m/s, k=1,38x^10231/K
Computer Science
Computer Science A Go-Back-N (GBN) ARQ scheme has been designed with window-size W = 10 such that it is fully efficient when there are no errors on the channel. Assume that frame size is 20000 bits and the overhead bits are negligible. What is the bit probability error (as seen at Layer 2) that makes the Go-Back-N ARQ 50% efficient?
55. Suppose a digitized voice channel is made by digitizing 8 kHz bandwidth analog voice signal. It is required to sample the signal at twice the highest frequency (two samples per hertz). What is the bit rate required, if it is assumed that each sample requires 8 bits? a. 32 kbps b. 64 kbps c. 128 kbps d. 256 kbps
Given a home wireless IEEE 802.11AC Wi-Fi channel with a bandwidth of 80 MHz, a) Apply the real time streaming transmission of a video that samples at 40 frames/second and each frame has a resolution of 800x600 pixels. Each pixel has its colour presented in 16 bits. Calculate the required transmission rate. b) If the Wi-Fi Channel is very noisy with an acceptable Signal-to-Noise Ratio of 10dB, does the video streaming in part (a) still possible without any distortion? (provide workings)
A computer user finds that his wireless router transmits data at a rate of 75 Mbps (megabits per second). Compare the average time to transmit one bit of data with the time difference between the wifi signal reaching an observer's cell phone directly and by bouncing back to the observer from a wall 8.00 m past the observer.