Consider the commercial steel pipe shown in (Figure 1).Part ADetermine the flow of methane at T = 68°F in ft³/h through a 2600-ft-long horizontal 1-in.-diameter commercial steel pipe if the pressure drop is 5(10³) psi.Express your answer using three significant figures.Q = 0.744AΣ vecSubmit Previous Answers Request AnswerX Incorrect; Try Again; 7 attempts remainingProvide Feedback?ft³/h 1 in.L

Pressure Drop (ΔP) = 5 * 10^(-3) psiLength of the pipe (L) = 2600 ftDiameter of the pipe (D) = 1…

Consider the commercial steel pipe shown in (Figure 1). Determine the flow of methane at T = 68°F in ft³/h through a 2800-ft-long horizontal 1-in.-diameter commercial steel pipe if the pressure drop is 5(103) psi. Express your answer using three significant figures. [ΕΙ ΑΣΦ. | Q-0.744 4 → Submit Previous Answers Request Answer Provide Feedback X Incorrect; Try Again; 7 attempts remaining ? ft³/h

Consider the commercial steel pipe shown in (Figure 1). Determine the flow of methane at T = 68°F in ft³/h through a 2800-ft-long horizontal 1-in.-diameter commercial steel pipe if the pressure drop is 5(103) psi. Express your answer using three significant figures. [ΕΙ ΑΣΦ. | Q-0.744 4 → Submit Previous Answers Request Answer Provide Feedback X Incorrect; Try Again; 7 attempts remaining ? ft³/h

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Provide solution for each answer
A cylindrical tank having a diameter of 40 cm in diameter and 20 cm height floats in mercury in a vertical position, its depth of immersion being 8 cm. Determine the value of MBo Unit of the Correct Answer: cm Decimal Places required in the final answer: 4
I want accurate answer approach as given
During a hydraulics laboratory experiment using a venturi meter and orifice meter to calculate the coefficient of discharge, the following results were obtained. Using the following data produce the results table from the lab results and data given. Table of Results 1 2 3 4 5 HV = (h1 - h2) m HO = (h6 – h7) m Q m3/s HV1/2 HO1/2
1. The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. The tank is A deep and is contaminated with B of water. The specific volume of gasoline is 0.00147076 m /kg and that of air is 0.0008313 m³/kg. Unit weight of water is 9790 N/m3 a. Determine the gage reading when the tank is full of gasoline b. How many cm of air remains at the top when the gage indicates full if the tank is A deep and is contaminated with B of water. c. Determine the pressure at the interface of the gasoline and water when the gage indicates full A = First name in inches Vent B = A/10 in inches Air h A Gasoline Pgage Water B
Show complete solutions with figures. A bottle consists of a cylinder 0.3 m in diameter and 0.4 m high, and a neck 0.05 m in diameter and 0.4 m high. When the bottle (filled with air under atmospheric pressure) is inverted and submerged in water until the open end is 0.6 m below the water surface, determine the pressure of the trapped air in the bottle. a) 103.8 kPa b) 104.8 kPa c) 105.8 kPa d) 106.8 kPa e) None of the choices
АСTIVITY 2 Direction: solve and analyze each of the following problem in neat and orderly manner. Do this in your indicated format. 1. A thermometer reading 18°C is brought into a room where the temperature is 70°C ; 1 minute later the thermometer reading is 31°C. determine the thermometer reading 5 minutes after its brought into the room.
The inside diameter of an open cylinder tank was measured. The results of four replicate measurements were 5.2; 5.7; 5.3; and 5.5 m. Measurements of the height of the tank yielded 7.9; 7.8; and 7.6m. Calculate the volume in liters of the tank and the standard deviation of the result.
Choose the pair of terms x, y that would correctly complete the sentence:“An inversion layer in the atmosphere occurs when Γ is [___x___], and this typically leads to very [___y___] conditions.” Selected Answer: a. x: positive; y: stable Answers: a. x: positive; y: stable b. x: negative; y: stable c. x: positive; y: unstable d. x: negative; y: unstable
Hello , can I get an answer please?
Question 12 of 25 If a depth of fluid of 1 m causes a pressure of 7 kPa, what is the specific gravity of the fluid? Select the correct response: 0.795 0.828 0.632 0.646 0.714