Consider the circuit shown in (Figure 1). The batteries have emfs of E₁ = 9.0 V and E2 = 12.0 V and the resistors have values of R₁ = 25 N, R₂ = 60 N, and R3 = 41 n. Figure R₁ R₂ R3 www 1 of 1 Part A Determine the magnitudes of the currents in each resistor shown in the figure. Ignore internal resistance of the batteries. Express your answers using two significant figures separated by commas. 195| ΑΣΦ I1, I2, I3= 0.54,0.23 Submit Part B Previous Answers Request Answer ? A

Consider the circuit shown in (Figure 1). The batteries have emfs of E₁ = 9.0 V and E2 = 12.0 V and the resistors have values of R₁ = 25 N, R₂ = 60 N, and R3 = 41 n. Figure R₁ R₂ R3 www 1 of 1 Part A Determine the magnitudes of the currents in each resistor shown in the figure. Ignore internal resistance of the batteries. Express your answers using two significant figures separated by commas. 195| ΑΣΦ I1, I2, I3= 0.54,0.23 Submit Part B Previous Answers Request Answer ? A

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 70AP: A 10.00-meter long wire cable that is made of copper has a resistance of 0.051 ohms, (a) What is the...

See similar textbooks

Similar questions

A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg • °C, assuming no heat escapes?
A 10.00-meter long wire cable that is made of copper has a resistance of 0.051 ohms, (a) What is the weight if the wire was made of copper? (b) What is the weight of a 10.00-meter-long wire of the same gauge made of aluminum? (c)What is the resistance of the aluminum wire? The density of copper is 8960 kg/m3 and the density of aluminum is 2760 kg/m3.
Inthe figure the current in resistance 6 is is = 1.41 A and the resistances are R1 = R2 = R3 = 1.63 0, R4 = 16.3 O, Rs = 7.100, and Rg = 3.860. What is the emf of the ideal battery? R R R, R R Number Units V
Three resistors, R1=80, R2=20, R3=80 are connected to a battery as shown in the figure below. If the battery voltage is 46Volts, determine the power dissipated by R2. Express your answer in units of Watts, using zero decimal places. R2 ww R1 R3 V
For this circuit, complete the VIRP chart. The numbering of the resistors is R1 = 30 Ohms, R2 = 20 Ohms and R3 = 10 Ohms. Do NOT include units. 24V 30Ω 2002 100 R1 R2 R3 Totals V R P
What is the equivalent resistor between the terminals a and b if you replace R1 by 20 Ohm and R2 by 40 Ohm ? This combination of resistors goes to infinity by repeating itself. Write your answer in units of Ohm. No decimal points is necessary. Maximum od 4% of error is accepted in your answer. R1 R, R2 R2 b. R1 R,
Three resistors, R1=20, R2-40n, R3-50 are connected to a battery as shown in the figure below. If the battery voltage is 35Volts, determine the power dissipated by R1. Express your answer in units of Watts, using zero decimal places. R2 R1 R3 V
a). A circuit consist of five resistors connected as below, determine the effective resistance in the circuit. RI R2 Given that R1, R,Rs,RA and Rs are given respectively as 50, 25, 30, 60 and 70Q, what is the current in the circuit if the potential aeross the resistors is 24 V?
In the circuit shown below E = 75.0 V, R5 = 4.0o n, R3 = 2.00 n, R2 = 2.20 n, Iş = 8.40 A, I4 = 5.50 A, and I = 11.0 A. Find the current through Rz and R3, and the values of the resistors R, and Ra. Iz = I3 = A R1 = R. = R4 ww Is ww
What is the equivalent resistor between the terminals a and b if you replace R1 by 38 Ohm and R2 by 34 Ohm ? This combination of resistors goes to infinity by repeating itself. Write your answer in units of Ohm. No decimal points is necessary. Maximum od 4% of error is accepted in your answer.
Figure 1 shows a circuit which connects four resistors and three batteries. Calculate the currents I, L, Is and I by applying a Kirchhoff's rules. Neglect the internal resistance in each battery. R, = 100 E, = 15 V R = 100 R = 100 R = 100 E, = 15 V E, = 9V Rajah 1/ Figure 1
A battery has emf 30.0 V and internal resistance r. A 9.00 resistor is connected to the terminals of the battery, and the voltage drop across the resistor is 26.0 V. What is the internal resistance of the battery? Express your answer with the appropriate units. TE II Submit μÀ Value Provide Feedback Request Answer Units ?