Consider constellation plot of a B-PSK signalling scheme as shownin the figure below:S2₂(t)-1×10-3$2(t)S₁(t)1×10-³$1(t)$1(t) and 2(t) represent ortho normal basis functions. If the two sidedPSD of AWGN is 10-6W/Hz, then the probability of error 'Pe' is

Two-sided noise PSD is 10-6 W/Hz.

Consider constellation plot of a B-PSK signalling scheme as shown in the figure below: S₂(t) -1×10-³ $2(t) S₁(t) 1×10-³ $1(t) $1(t) and 2(t) represent ortho normal basis functions. If the two sided PSD of AWGN is 10-6W/Hz, then the probability of error 'Pe' is

Consider constellation plot of a B-PSK signalling scheme as shown in the figure below: S₂(t) -1×10-³ $2(t) S₁(t) 1×10-³ $1(t) $1(t) and 2(t) represent ortho normal basis functions. If the two sided PSD of AWGN is 10-6W/Hz, then the probability of error 'Pe' is

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: In QAM, both of a carrier signal are varied. Select one: O a. phase and frequency O b. None O c.…

A: In QAM both phase and amplitude are varied.

Q: In 8-bits digits, the number (+19) using the ______________ form is equivalent to: Arrive with the…

A: Solution- The given number is (+19),

Q: A modulated carrier wave in AM bu 4 modulation has maximum and minimum amplitudes of 750 mV and 250…

A: Note: As per the company policy, we experts are allowed to answer only one question. Kindly post the…

Q: Suppose the binary data stream 10111010111 is differentially encoded and then transmitted…

A: According to the question, we need to plot the binary data stream 10111010111.

Q: Answer all questions below: 1. Draw the general block diagram of Frequency Division Multiplexing…

A: General block diagram for frequency division multiplexing.The given figure has a multiplexer with…

Q: Why do we utilize both digital signals (which are not periodic) and analog signals (which are…

A: Analog and digital signals are used to transmit information or data usually by using electric…

Q: Q1) Explain why the transmitted data block is relatively short in asynchronous transmission.

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 5. QPSK is a modulation scheme where each symbol consists of a. 4 bits b. 2 bits c. 1 bits d. M…

Q: For NRZ code, if Eb = 9.07 pico Joule and NO =1E-12, then the bit error rate is equal to a)1E-5…

Q: Q2: For the following digital sequences sketch the line codes e.g. polar, unipolar, bipolar and…

A: Given bit sequence: 10100110 Polar line coding is categorised into two unipolar and bipolar. For…

Q: All of the mentioned b. Perpendicular to each other c. One signal cannot interfere with the other d.…

A: Two signals are called orthogonal if their dot product is zero and they are perpendicular to each…

Q: Why do we utilize periodic analogue signals and non-periodic digital signals for data transmission?

A: The analog signal is a continuous signal and digital signal has discrete stages.

Q: Implement the following function using 8 to 1 line Multiplexer. F(A,B,C,D) = m(0,4,5,8,10,12,14,15)

A: Implematation of funtion using 8×1 mux as- first draw k map then circle the given no on k map if…

Q: What is the ideal percentage of modulation for maxi- mum amplitude of information trans mission?

Q: If a binary sequence of 100000001 is digitally encoded. Which line encoding format will most likely…

A: If a binary sequence of 100000001 is digitally encoded, the line coding format having…

Q: 1.5 1 0.5 |-0.5 -1 |-1.5 1 3 4 6. LO 2.

A: Find the type of line coding for the given waveform with the given data 010010.

Q: Given the AMI-NRZ Line Coding Waveform, the corresponding binary data is _______

Q: W-CDMA requires a complete change of RF equipment at each base station. a) True b) False

A: The solution is provided in the following section.

Q: B. Why VSB modulation is used in TV picture transmission?

Q: Why SSB is preferred for transmission of good quality signal

Q: How to operate the non-coherent and when used in communication system ? if m(t) is the information…

Q: What are the three most important effects due to multipath in mobile radio channel? Explain each…

A: We have given the problem What are the three most important effects due to multipath in mobile radio…

Q: 1 1 0 0 0 1 0 1 лишь ASK --> PSK NRZ (M) --> -

Q: B. Why VSB modulation is used in TV picture transmission?

A: The explanation is as follows.

Q: ... H.W.JPG A.W Em In an FM systems the modulating frequeng the modulating voltage Um = 2 volt, and…

A: In this question we have given FM modulation....We have to find out deviation and modulation…

Q: Pair of the quantiter of at load-bus and Q1 what are Slack bus jA toad 2low studies?

A: In this question we will write about quantities specified on load bus and slack bus...

Q: A digital communication link consists of nine regenerative repeaters along with a receiver. Signal…

A: Given: A digital communication link consists of nine regenerative repeaters along with a receiver.…

Q: 7. If a 2000 kHz carrier signal (f) is amplitude modulated by a 3 kHz message signal (fm), what…

A: Given,

Q: The bit error probability for orthogonal signaling is greater than the bit error probability for…

Q: For the signal 1. What type of modulation does this represent? 32-QAM 2. How many symbols are…

A: Given signal constellationBaud rate= 50000 symbols per second

Q: In your own words, explain the importance of line coder in digital communication. In…

A: Line coding Line coding also known as digital baseband modulation or digital baseband transmission…

Q: Vs=11111.316684.9419-Sending Phase lag How did you get the output?

Q: The change in the bandwidth of the signal in FM when the modulating frequency increases from 6 kHz…

Q: For the above given signal each bit is separated by a vertical line. If total time is given as 12…

A: Bit duration=12ms

Q: Assume that an AM system operates with an index of 0.5 and that the message signal is m(t) =…

A: Given,For an AM system,Modulation index, μ=0.5Message signal, mt=4cos2π50t

Q: Digital Subscriber Lines can not be implemented with loading coils for the reason that

A: Solution of question (1): Four options are given, we need to choose the correct option. It is asked…

Q: Q24) This multiple choice question from DIGITAL COMMUNICATIONS course. just write for me the final…

Q: Draw the signal constellation that used the QAM defined by the following table given below

Question

Consider constellation plot of a B-PSK signalling scheme as shown
in the figure below:
S2₂(t)
-1×10-3
$2(t)
S₁(t)
1×10-³
$1(t)
$1(t) and 2(t) represent ortho normal basis functions. If the two sided
PSD of AWGN is 10-6W/Hz, then the probability of error 'Pe' is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given Data:-

VIEW

Step 2: Calculation of Probability of error.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(b) Consider a binary sequence of with a long sequence of 1's followed by a single 0 and then a long sequence of 1 as (11111011111). Draw waveforms for this binary sequence using the following formats i- Unipolar RZ signaling. ii- Bipolar NRZ signaling. iii-Split-Phase (Manchester) signaling. iv- Sinusoidal ASK modulation. v- Sinusoidal FSK modulation.
ANSWER 4 AND 5 ONLY
Consider the figure below for a real-time transmission. There are three packets to be played where first, second and third packets contain 12, 13 and 14 seconds of data, respectively. What is the units played for the second packet at time 28? Server Client Internet 00.00.01 00.00.00 First packet 00.00.04 00.00.12 00.00.14 00.00.16 Second packet 00.00.25 00.00.28 00.00.42 00.00.29 Third packet 00.00.39 00.00.43 Flow Play time Arrive time Send time Select one: a.0 b.12 c.14 d.1 e.10
24
State a bit rate and maximum number of channels in T-1 and T-3 telephone TDM system.
22
is one of the methods used for the generation of SSB-SC signals. O Carrier shift method O Frequency shift method O Amplitude shift method O Phase shift method
For the data stream 011100101, sketch the transmitted sequence of pulses for each of the following line codes: 1) Manchester Code 2) Polar NRZ signaling 3) Bipolar NRZ signaling 4) Alternate Mark Inversion 5) Unipolar RZ signaling
(b) In a particular implementation of ADSL2+, 400 downstream subchannels are being used to achieve a data rate of 10.4 Mbit s-1. If 75 subchannels are using 1024-QAM, 125 are using 64-QAM and 100 are using 16-QAM, what modulation scheme must the remaining channels use, assuming they all use the same scheme? Show all your workings
A digital sigbaling system is required to operate at 9600 bps. If a signal element encodes an 8-bit word, the minimum required bandwidth of the channel is _______kHz.
Q3. Draw a time division multiplexing PAM (TDM-PAM) and show that the minimum required channel BW is 2nfm where n is the number of users and fM is the maximum frequency of the message signal.
Given the Manchester Line Coding Waveform, the corresponding binary data is ________________