Consider an RL circuit powered using a square wave from the signal generator. The figure below represents the voltage on the resistor VL displayed on the CRO screen. If the inductance is L= 12.9 mH, then using the figure the value of the resistance (in Kilo-Ohms) is:

Consider an RL circuit powered using a square wave from the signal generator. The figure below represents the voltage on the resistor VL displayed on the CRO screen. If the inductance is L= 12.9 mH, then using the figure the value of the resistance (in Kilo-Ohms) is:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Given the circuit, what will be the mathematical expressions for the current i in terms of vx and…

A: In the Given the circuit, what will be the mathematical expressions for the current i in terms of vx…

Q: The directive gain of an element is 44 dB. If the main beam of the element is circular, then what…

A: The directive gain of an element essentially indicates the directivity of the element. In this…

Q: Figure: structure of a thin film silicon solar cell. Glass Front ITO i (aSi:H) back ZnO:AI 1-D PC…

A: A thin film solar cell is made up of depositing one or more thin film or layers. The thin layers are…

Q: A rectangular waveguide has dimensions a = 6 cm and b = 4 cm. a) Over what range of frequencies will…

A: A rectangular waveguide has dimensions a = 6 cm and b = 4 cm.a) Over what range of frequencies will…

Q: a. In a full wave rectification, average DC current, RMS value of Current, DC power output and AC…

A: In the question, Draw the full wave rectification. ? Find the Average DC current ? Find the RMS…

Q: R1 1k V1 VOFF = 0 VAMPL = 4V FREQ = 10kHZ C1 0.1uF Figure 2 2.3 Plot the waveform v for the voltage…

Q: 2. A current source in a linear circuit has is = 8cos(500nt – 25°) %3D (a) What is the amplitude of…

Q: What is the differential element for surface defined by 0 sp s 5 and z = 10? %3D

Q: Mathematical discussion is posted a screenshot for further information.

A: Evaluating the amplitude of current wave when a triangular wave voltage of amplitude 2 V and…

Q: Example: Determine the amplitude, frequency and phase difference between the two waveforms…

A: The required parameters from the CRO waveform display can be calculated by considering the number of…

Q: Suppose a capacitor is made using square plates that are 5.1 cm on a side, and are separated by 5.2…

A: Given: A parallel plate capacitor has Square plates with side, a=5.1 cm Separation in plates, d=5.2…

Q: 5. How does a capacitor work, and what is its purpose in an AC circuit? 6. In an AC circuit, Ohun's…

A: AC circuit is nothing but a circuit using alternating current, the magnitude and the direction of an…

Q: 10. Find an expression for the equivalent inductance for the circuit shown Leq = Lea elle elle

A: Given circuit,

Q: Given V, = 20 sin(@t + 60°) and V, 60 cos(wt – 10°). What is the phase angle %3D %3D between the…

A: Given Data: V1 = 20 sin (wt + 60) V2 = 60 cos( wt-10)

Q: solve for the potential difference:

Q: find foavier Trang form for the function that appears in figure below 7 00

A: Given waveform shown

Q: Given the waveform of the current in a 3H inductor as shown in Figure below, determine the inductor…

Q: 520V. Determine the: (A) Equivalent Circuit Capacitance, (B) Charge on each capacitor, and (C) PD on…

Q: A cross-sectional view of an optical fiber is shown in the figure. The optical fiber has core and…

A: Answer:(a) Explanation: (a). It is a valid option. The total internal reflection will happen if the…

Q: The given circuit has Vth=30V and Rth=30K Ohms. If the inductor will be short circuit and the switch…

A: Given- Inductor short circuited Switch closed To find- Value of current i =?

Q: draw the voltage, current, and power waveforms in the case of AC applied to a pure inductor circuit.…

A: we need to draw voltage, current, and power waveforms in the case of AC applied to a pure inductor…

Q: Provide 1 example for the Miller Effect Capacitance

Q: A deemphasis circuit has a capacitor value of 0.02 µF. What value of resistor is needed? Give the…

A: Given: C=0.02 μF

Q: what is the inductor current at skady state?

A: We need to find out current through inductor at steady state .

Q: Design a 15v full wave power supply that will deliver a 1.5A of DC current to a load of 1kohms…

A: A full-wave rectifier is a circuit used for converting a full AC wave to a full DC wave. It consists…

Q: %3D %3D %3D For the circuit shown in the following figure. If Ig = 75 µA, B = 100, Vcc = 15 V, and R…

A: A transistor connected in the common-emitter configuration is given in the question. The input…

Q: If Re = 2 and Im = -5, What is the complex number in: rectangular, trigonometric, polar and…

A: In this we will find complex number different forms...

Q: 1. Why OCC looks like B-H curve?

A: Open circuit characteristics of dc generator is given by below figure.

Q: Value of the capacitor’s voltage amplitude VC ?

Q: 2. Explain briefly how we can generate a PPM by using PWM wave form? Support your explanation with…

Q: a)Find the mathematical expression of the capacitor voltage? b)calculate the average power on the…

Q: What is microelectronics

Q: Explain the generation of PWM waves by using common collector circuit. Also state ptractical…

Q: A B 7025 47025 D 70 25v 47025 E Capacitors A-E 2. Look at the picture above. Which capacitor do you…

Q: 1. Set the function signal generator to generate square wave at f = 650 Hz and Vs p.p = 8 V. 2.…

Q: A steady state of 20 mA is passed through a coil with an inductance of 100 mH. What is the voltage…

Q: Explain the phase difference between pure resistor, pure inductor and pure capacitor circuit in…

A: 1. Pure Resistive circuit In an AC circuit, the ratio of voltage to current depends upon the supply…

Q: Maxwell's bridge is used for the measuremen of medium inductance for Q-factor value of circuit below…

A: In this question we will find range of Quality factor for maxwell bridge....

Q: Q5) For the waveform shown below, find Vrms v(t) A 2 LAA: 4 6 l10 t -1

A: The given waveform is shown below. Find Vrms.

Q: Explain the phase difference between pure resistor, pure inductor and pure capacitor circuit in…

A: Given Explain the phase difference between pure resistor, pure inductor and pure capacitor circuit…

Q: Referring to Figure 16, assume that the current through each inductor have reached their final…

A: It is given that:

Q: Explain the simple RL circuits (Section 32.2, structure/decay of current through an inductor)?

Q: L di let im sMwt

A: In this question by the equation, (1) and (2) it is shown that the phase difference between the…

Q: For the following circuit C=91, Determine the equivalent Capacitance Ceq=?

A: In this question we will find equivalent capacitance....

Q: For the component shown with the given voltage and current reference directions, the voltage across…

A: A element is said to deliver energy when current leaves the possitive terminal and element observes…

Q: a) What is the dominant mode if a<b in a rectangular waveguide? This mod's cut What is wavelength?…

Q: R1 ) vs(t)=10cos(2000rt) i: C1 R1=330 N Cı=1,5 µF Vs

A: we need to find the frequency, period, amplitude and phases of Is, Vs and VR1.

Q: How will we know if the capacitor is already fully charged?

A: Capacitor is a passive device which is used to store a form of energy between its plates.

Q: Draw a multilayer perceptron with two input-four hidden-three output layers??

A: A multilayer perceptron (MLP) is a class of feedforward artificial neural network (ANN). An MLP…

Question

Consider an RL circuit powered using a square wave from the signal generator. The figure below
represents the voltage on the resistor VL displayed on the CRO screen. If the inductance is L= 12.9
mH, then using the figure the value of the resistance (in Kilo-Ohms) is:
Tek
O Trig'd
M Pos: 0.000s
AUTOSET
CH1
Mean
-845mA
CH1
Pk-Pk
61.2A
Undo
Autoset
CH1 10.0A
M 25.0 uS
CH1/-220MA
1-Dec-10 2127
6.24644kHz
TDS 2002B - 3:28:27 PM 12/1/2010
a. 0.78
O b. 967.50
O c. 129.00
O d. 1.29
e. 0.17

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Waveguide and Its Characteristics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

is the simplest way of producing a source of lower EME from a source of higher EMF.
LVDT produces an rms output voltage of 5.0 V for displacement of 3.5 mm. Calculate the sensitivity of LVDT please explain me
For the cycle circuit, when will the PIV appear when the input waveform will occur? Please choose one: a. B b. One c. C D
A sinusoidal waveform displayed on an oscilloscope is shown in Figure 2. The 'time/cm' switch is on 10 ms and the 'volts/cm' switch is on 5V/cm. Determine for the waveform: d) The r.m.s. value of waveform Q e) The phase difference of waveform Q relative to waveform P
A sinusoidal waveform displayed on an oscilloscope is shown in Figure 2. The 'time/cm' switch is on 10 ms and the 'volts/cm' switch is on 5V/cm. Determine for the waveform: a) The frequency of both waveforms b) The peak-to-peak value of waveform Q c) The amplitude of waveform P d) The r.m.s. value of waveform Q e) The phase difference of waveform Q relative to waveform P
What is the advantage of using square wave-form as an Input Signal? What is the shape of the outputwhen the input signals are sinusoidal and triangular in shape? (Hint: Use Function generator andOscilloscope to observe the output)
A double beam oscilloscope displays 2sine waveforms A and B. The time/cm switch is on 100us/cm and the volt/cm switch on 2V/cm. The width of each complete cycle is 5cm for both the waveforms. The height of waveforms A and B are 2cm and 2.5cm respectively. Determine their a) frequency, b) phase difference, and c) peak and r.m.s value of voltages. The difference between the two waveforms is 0.5 cm.
Create a waveform generator with the 8051. The waveform is sent to DAC via P1. There are SQUARE, TRIANGLE, SINE, and SAWTOOTH waveforms.
The main purpose of an oscilloscope is to graph an electrical signal as it varies over time. Most scopes produce a two-dimensional graph with time on the x-axis and voltage on the y-axis. The voltage waveform on the screen looks as shown in the figure below. Here, the vertical resolution of the oscilloscope is set up to be 2 mV/division and the horizontal resolution is 2 ms/division. Time 1. Determine the peak-to-peak amplitude of the wave. Voltage
Q18. An AC waveform is shown in figure B3. 4 10 20 30 40 50 70 100 Time (ms) 110 -2 -3 -4 -5 Figure B3 i) For the above waveform, determine a. Peak-to-peak voltage b. Time period c. Frequency ii) For the above waveform, determine a. Peak Factor b. Form Factor
so then how is Rth 0.8695 kOhms in the original explanation?
Answer (c). What are Ac voltage at each point indicated (A,B,C,D,E) in the circuit with Vs = 100mVp-p