Consider an LTI system whose response to the signal x, (t) in Figure is the signal y, (t). 1. Determine and sketch carefully the response of the system to the input x,(t). 2. Determine and sketch carefully the response of the system to the input x,(t).

I need the expert solution and a detailed explanation of each step in the solution.

For the circuit described by the state diagram given below, determine the state transitions and output sequence that will be generated when an input sequence of (11101101110) is applied to the circuit and it is initially in the state 00. 0/0 1/0 10 0/1 00 1/0 0/1 0/1 1/0 1/0 01 11 10110010001 11100110101 00010011001 00010010001

In signal processing   1.what are the singularity problem of CMA algorithm 2. Why such singularity problem induced by using CMA  3.how to prevent the problem It would be appreciated if you can answer in handwritten notes. Please don't direct copied from the internet, I need explanation, thank you

6. A university wants to establish a control system model that represents the student population as an output, with the desired student population as an input. The administration determines the rate of admissions by comparing the current and desired student populations. The admissions office then uses this rate to admit students. Draw a functional block diagram showing the administration and the admis- sions office as blocks of the system. Also show the following signals: the desired student population, the actual student population, the desired student rate as determined by the administration, the actual student rate as generated by the admissions office, the dropout rate, and the net rate of influx. [Section

4. Discussion: Compare between theoretical effect of KI at first order and second order systems regarding steady-state errors and transient responses with the practical In Experiment Integral Controller

Question 1 Digital Electronics and Combinational Logic la) Analog and Digital Electronics i. Write either "digital" or "analog" in this to indicate whether the property in that row is typical of digital electronics or analog electronics. The first row has been completed as an example. Property Difficult, manual circuit design Continuous valued signals Tolerant of electrical noise Circuit state tends to leak Intolerant of component variations Digital/Analog Analog ii. In older cars the timing of the electrical pulses to the spark plugs was controlled by a mechanical distributor. This contained a rotating contact that was mechanically linked to the rotation of the engine. Newer cars use electronic ignition. Electrical sensors detect the position and speed of the motor and a digital controller sends ignition pulses to the spark plugs. Briefly describe 2 likely benefits of the digital electronic ignition system over the mechanical one. An example is given first. More flexible control: the…

Plz i need the answer of this question number 7  subject control engineering

Number 15

I need the answer as soon as possible