Consider a suunt resistor Of 0-011n connected to an ammeter which draws 0-8A wiluen the poten tilal dlfference auross the ammeter is 0-08V Determine the; (i Power Consumes by the ammeter and its shunt resistor. W Current flowing turough Hhe metero

Consider a suunt resistor Of 0-011n connected to an ammeter which draws 0-8A wiluen the poten tilal dlfference auross the ammeter is 0-08V Determine the; (i Power Consumes by the ammeter and its shunt resistor. W Current flowing turough Hhe metero

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: A 300 watt carrier is simultaneously modulated by 3 sine waves with modulated percentages of 20, 29…

Q: A fluorescent lighting fixture has a compact ballast with a nameplate rating of 180w, 120 V.…

Q: The following information is given in connection with a load circuit consisting of two parallel…

Q: For an AM commercial broadcast band receiver (535 kHz to 1605 kHz) with an input filter Q-factor of…

Q: A circuit composed of a 24-V battery and four resistors connected in a series connection, whose…

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: 6. Calculate the torque produced by a DC motor with a CEMF of 95 V, an armature current of 75 A, and…

Q: What is the overali efficiency of the solar collector with the following test results? Calculated…

Q: In the following circuit, the switch has been in current position for a long time. At t = 4 s it…

Q: An input voltage of 2 Vrms (measured from base to ground) is applied to the circuit of the figure.…

A: The following circuit diagram is given:

Q: a. In what mode does M1 operate and why? b. Find the relationship between I, and IREF in terms of…

A: Disclaimer: “Since you have posted a question with multiple sub-parts, we will solve first three…

Q: Sketch the transfer curve for p-channel IFET with IDSS = 18 mA and Vp = -9 V %3D %3D

A: In this question , we will draw transfer curve for p- channel JFET...

Q: Consider a system with transfer function G(s) = (s + 6)/(Ks^2 + s+ 6). Its damping ratio will be 0.5…

Q: a 300 watt carrier is simultaneously modulated by 3 sine waves with modulated percentages of 20, 29…

A: The solution is given below This problem is from basic of amplitude communication. The power can…

Q: VACA 10 0 30 0 20 1 40 2 15 0 15 0 10 0: 100 2 50 0 15 0 (1) (2) (3) (4) (a)

Q: Using node voltage network analysis, find the ratio Vo/Vi in network shown of Figure 1, given Vo as…

Q: resistor of 50 ohms, a 200mH inductor, and a 1.5 x 10-4 F capacitor are connected in parallel to a…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: TRUE or FALSE: Once a metal has become passivated, it will always remain so.

A: The solution is given below the given statement is false .

Q: Determine the voltage VP

A: Given,

Q: Find expressions for the magnitude |G(jw)| for function G(s) below: s+5 G(s) = - s(s + 1)(s + 2)

Q: A phase modulator has kp=2 rad/V. What rms voltage of a sine wave would cause a peak phase deviation…

Q: 1. +24 V 22 kn 2.7 kn Si B = 75 4 kn 50 mv 6.8 kn 1.5 kn 2.0 kn In the given circuit above, work out…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: 9 μF C1 C39 µF + E 24 V C2 10 µF 72 μF

A: We need to find out charge on each capacitor .

Q: A DC shunt motor produces an output power of 4.8 kW on the shaft with a speed of 1120 rpm and a…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Determine the total resistance (R) and the current flow (I) for the circuit shown in the…

Q: What is the frequency (in Hz) of the figure below? 250 us

Q: Derive the truth table, simplified Boolean function (equation), and draw the logical diagram:…

Q: A boost converter has an input of 5V and an output of 20W at 15V. The minimum inductor current must…

A: Given, a boost converter Vin=5v, Vo= 15v, P=20w

Q: Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance…

Q: L UL LET iL 85mA sin(1650t+160 ) and L = 5 mH %3D then Calculate the voltage across the inductor in…

Q: Sketch the transfer curve for p-channel JFET with IDSS 18 mA and Vp -9 V %3D %3!

A: In this question we will draw transfer characteristics for p- channel JFET.

Q: A cold junction of a themocouple is at room temperature of 83°C. A votmeter connected to the…

Q: Answer the following about measuring electricity:

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: A clothes dryer rated at 6kW is connected to a 120/240 V, single-phase, three-wir individual branch…

A: In this question, We need to choose the correct options What is load current if total load 6kW…

Q: A star-connected 3-phase synchronous motor operates at a frequency of 50 Hz and a line voltage of…

Q: Which sub-atomic part of an atom is used as a fundamental unit of electricity par'icularly when it…

A: 1.answer: C electron Electron is the fundamental particle which causes current. While remaining…

Q: Find an expression for the closed-loop gain G = v0/vS. Then, assume that R1 = 1kΩ, R2 = 4kΩ, C = 1uF

A: In this question, We need to determine the gain G If R1 = 1kΩ, R2 = 4kΩ, C = 1uF. We are solving…

Q: How do you calculate the effective resistance of a parallel circuit? (Equation)

A: Consider the resistances that are connected in parallel are, R1,R2,R3..........,RN Consider the…

Q: Find expressions for the magnitude |G(j@)| for function G(s) below: s+5 G(s) = s(s + 1)(s + 2)

Q: An inductor of inductance of 2 H is connected in series to a resistor of 10 2 and a 12 v battery.…

Q: When a fault occurs, Select one: O A. the generator terminal voltage does not change immediately O…

Q: 3. Draw a series and parallel circuit containing 7 capacitor, each 3µF capacitor and the…

A: According to the question, we need to design a series and parallel circuit containing 7 capacitors,…

Q: The drawing shows a circuit that includes a bimetallic strip (made from brass and steel) with a…

A: Bimettalic strip is at normal position when temperature is below the certain temperature. And after…

Q: Provide the output equation, c(t). If there is a numerical answer that is nonterminating, it should…

A: In this question we need to find a output c(t) of the given system.

Q: In a parallel circuit, current flowing from the source to each path is: equal zero lesser greater

A: In this question, We need to choose the correct options In a parallel circuit, current flowing from…

Q: A 100kW, 230V, shunt generator has an armature resistance and field resistance of 0.05Ω and 57.5Ω.…

Q: 1. When is the counter EMF at a minimum?

Q: Part II. In the given circuit below, determine the current flowing through each resistors using;…

Q: Determine the upper 3dB cutoff frequency of the voltage gain !

A: The circuit is shown below: R1=10.2kohmR2=2.4kohmR3=12.7kohmR4=4.7kohmR5=4.7kohmC=10nF

Q: Diecions:Using the schematic below and the test results listed, which load contains an open?…

A: Fig: Given circuit it is given that when all load is connected in the…

Q: Vo R, ww R R, OV

A: Please find the detailed solution in below images.

Question

Consider a suunt resistor Of 0-011n connected to an
ammeter which draws 0-8A wilhen the poten tlal dlfference
auross the ammeter is 0-08V. Determine the;
(i Power Consumes by the ammeter and its shunt resistor.
) Current flowing Yurough the meter.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the loop currents Ia, I,, and Ic. 100 Ic 100 100 100 100 Ib 55V 100 V la
An ammeter has been designed by indirect method with current ranges 1A, and 5A, if PMMC meter have internal resistance of 50 (2 and half scale current of 0.5 mA. Ra and Rb will be --- ohm Ra= 0.05005 , Rb=0.01001 Ra = 0.04004 , Rb = 0.01001 Ra= 0.05005 Rb= 0.04004
Q) What should be the value of R such that maximum power transfer can tabe place from the rest of the networt to R in the figure?0mci01ei8 31 .ol 2 [Ans. 5-33 n and 188 mw) 24 V 25A (1
The conductance of a 9230 resistance is a) 1.08 * 10-3 mho b) 1.08 * 10-4 mho c) 1.02 * 10-3 mho d) 1.02 * 104 mho
The maximum power that can be generated by a wind turbine is called Select one: O Cut-in Power O Cut-out Power O lock-in Power O Rated Power
Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a switch. The switch is placed in position A at time t = 0 and switched to position B at time t = 743 ms. Find the voltage across each of the resistors at time t = 1.17 seconds. Owo DO A R R in in ete SW éte لفظو
For some reason it's saying the 0.3636 is wrong. I tried 0.364 as well thinking it may be have wanted it rounded. This is explained very well. Thank you. On the second part, you did 60-60 because the charge didn't change. Is that correct?
The maximum power that can be generated by a wind turbine is called Select one: O lock-in Power O Cut-in Power Rated Power O Cut-out Power
Q5 Figure 6 Show the calculation and steps please
Given the circuit shown, Calculate the Peak Output Voltage. Express your answers in two decimal places (i.e., 9.946 becomes 9.95, and 7.6 becomes 7.60). 4:1 D1 120 V rms RL 1.0 kN D2 elle lelll
5. Name two methods used to make a DC multirange ammeter.
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.