Consider a one-storey building that is a square. It will have an access point in each corner and one in the center of the square. Each access point can hear only its neighbor one. (That is the AP placed at a corner cannot hear another AP at the opposite corner.) Assign access point channels to the five access points if you are using 802.11g (2.4 GHz). Available channels are 1, 6, and 11. Were you able to eliminate interference between access points? If NO, Why? Otherwise, show your channel assignment. Repeat the a) part of the question, this time using 802.11a (5 GHz). Available channels are 36, 40, 44, 48, 53, 56, 60, 64, 149, 153, 157, and 161, but many NICS and access points only support channels below 100. APT AP4 AP5 AP2 АРЗ

Consider a one-storey building that is a square. It will have an access point in each corner and one in the center of the square. Each access point can hear only its neighbor one. (That is the AP placed at a corner cannot hear another AP at the opposite corner.) Assign access point channels to the five access points if you are using 802.11g (2.4 GHz). Available channels are 1, 6, and 11. Were you able to eliminate interference between access points? If NO, Why? Otherwise, show your channel assignment. Repeat the a) part of the question, this time using 802.11a (5 GHz). Available channels are 36, 40, 44, 48, 53, 56, 60, 64, 149, 153, 157, and 161, but many NICS and access points only support channels below 100. APT AP4 AP5 AP2 АРЗ

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

I need the answer as soon as possible
Q3.Unless specified otherwise, use the free space propagation speed of light 3x108 m/s to calculate the propagation delay. For numerical calculations, the results must show the appropriate unit. Show me a complete solution NOT THE AI SOLUTION. Consider a digital multimedia transmission system. Separate audio and video coders are used to encode these signals. Audio and video bits are packed in packets together and transmitted over a transmission link. Each packet is 2,000 bytes long, which includes a 48-byte header. The system generates one packet every 40 ms. Calculate the following values:a. The minimum data transmission rate required to support the above system.b. The minimum signal-to-noise ratio (SNR) in dB required to transmit the above audio and video information. Assume a 400-kHz transmission channel bandwidth is used.c. The end-to-end packet delay over a 50-km link, using answer in Part a).
I need the answer as soon as possible
Q3// A given FM transmitter is modulated with sinusoidal input (in volt), m(t)= 25 cos800 t, and the modulation index is (5). The un-modulated carrier power is (150Watt) across 2002 resistive load. Determine: 1. The modulation constant, K₁. 2. The approximate bandwidth of FM signal. 3. The peak amplitude of the first order lower sideband. 4. The ratio of the average power in the sum of the second and fourth sidebands to power in all the remaining sidebands excluding carrier
In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex communication. There are 1000 channels in total in the system.What is the bandwidth for a single direction (user to base station) according to the information given above??
suppose an even parity code is used to send a message across a noisy channel. which of the ff received word is sure to contain at least one error? a. 10101011 b. 111111 c. 000000 d. 001111
We need to transmit 100 digitized voice channels using a pass-band channel of 20 KHz. What should be the ratio of bits/Hz if we use no guard band?
Assume having a narrow low-pass channel that spans from a Frequency of 0Hz to 5400HZ, and a digital signal that has a bit- rate value of 14Kbps to send. Then, to roughly simulate that digital signal you would need an analog signal with a minimum frequency of Khz.
Choose the right answer: 1- A line encoding method wherein the positive half interval pulse is followed by a negative half interval pulse for transmission of ‘1’ is a.Bipolar NRZ b.NRZ-M c.bi-phase-level d.RZ-AMI 2- In block coding, the number of valid codewords is equal to a.2^n + 2^k b.2^n c.2^k d.2^n - 2^k 3- Which statement is correct for a simple parity-check code? a.can detect an odd-number of errors. b.can detect two errors. c.can detect no errors d.can detect an even-number of errors. 4- In modulo-2 arithmetic, adding 1 and 1 will have an outcome of a.0 b.2 c.1 d.11 5- The remainder in cyclic redundancy checking represents the a.The CRC b.The error c.The divisor d.The syndrome
True or false, and briefly explain your responses on the following questions: When the transmitter and receiver window widths are both one, the alternating-bit protocol is equivalent to the SR protocol.
FDM system user to combine 9 tones on a single carrier four of these tones are each 2.5 kHz and modulated SSB on sub-carrier with guard band of 200 Hz. The other is each at 4.2 kHz and are modulated FM on sub-carrier with modulation index of 5 with guard band of 300 Hz. The base band signal is frequency modulated on main carrier with modulation index of 10. calculate the transmission bandwidth of the FDM signal. Assuming 400 Hz as a guard band between SSB and FM sub- .carrier BW=6.812 MHz O BW=9.812 MHZ O BW=7.812 MHZ O BW-5.812 MHz O BW=8.812 MHz O
40 devices share a clean ALOHA channel. The drawer is 2μs in size. Because they want the devices to carry as much as possiblenumber of frames per second, are satisfied with 65% of the maximum achievable channel efficiency.How many frames per second can each device emit to achieve 65% of the maximum achievable channel utilization?