Consider a cylindrical oil reservoir of radius 1.2 km and height 20 m having in situ pressure of 45 MPa. A well of 200 mm is drilled in the middle of the reservoir to extract oil. Estimate the quantity of oil that may flow per day to the well. Assume viscosity of oil is 75 cp, specific gravity 0.85 and permeability 50 md in situ condition.

Consider a cylindrical oil reservoir of radius 1.2 km and height 20 m having in situ pressure of 45 MPa. A well of 200 mm is drilled in the middle of the reservoir to extract oil. Estimate the quantity of oil that may flow per day to the well. Assume viscosity of oil is 75 cp, specific gravity 0.85 and permeability 50 md in situ condition.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

With units please
The oil volume in the above reservoir is 1. 5 × 10° m² at initial pressure 27.0 MPa, the bubble point pressure is 17.07 MPa, and the formation volume factor of oil at bubble point is 1.2. Calculate the elastic reserve of the reservoir.
Can you calculate the concentration at the end of the well using the 1-D steady advection-dispersion-reaction equation. The given parameters are distance = 200 m, Initial concentration = 10 mg/L, reaction = 0.0062 / day, dispersion = 1.5 m^2/d, and velocity = 0.5 m/d.
d) What is the equivalent permeability which will govern the productivity of the following well? re= 700 ft Ke = 500 md %3D rw = 4 inch ka= 5 md ra= 2 ft
Question 1 The discharge from a fully penetrating well under steady state pumping in a confined aquifer is (1000 two wells located at 6 and 12 meters from the well are 3.0 m and 2.0 m respectively. Čalculate the permeability of the aquifer. Show the data on the neat sketch. liters per minutes. The aquifer has a thickness of 20 m. The drawdowns observed at
(6) Derive an expression relating effluent concentration to influent concentration, hydraulic residence time, and the reaction rate constant for a second-order reaction in a batch at non-steady state. Repeat the exercise for a CMFR and a PFR at steady state. Explain your results.
If the distance and observed potentiometric surface between two adjacent wells are 1000 m and 3 m, respectively. Find an estimate of the time it takes for a molecule of water to move from one well to the other. Assume of 3.5 m/day and effective porosity of 0.35.
A well produces 850STBD amd1.67MMCF/STB the tubing diameter is4.5at a certain depth pressure is1002 psi calculated density for oil and gas is 805Kg/m^3 and 0.715kg/m^3 respectively Bo is 1.1 ,Bg=0.01ft^3/scf and Rs is 255 scf/stb calculated fluid slippage ,liquid hold up ,type of flow in the tubing and real phase velocities Using this equation to calculate it
DETERMINE: a. Rate of seepage into the well during pumping
During the recuperating test, the water level was initially lowered by 2.65 m and is recuperated by 1.45 m in 1 hour. Determine the yield (in litre per sec) from an open well of diameter 3 m under a depression head of 3.45 m.
Environmental Enginee... During a recuperative test, the water is pumped out 2.8 m initially and allowed to recuperate. It was observed that the water level rises by 1.45m in 80 minutes. If the diameter of the well is 3.45m, determine by what amount the diameter need to be increased to get a yield of 5 litre per sec under a depression head of 1.65m.
Discuss about Overconsolidation Ratio