Consider a Brayton Cycle with all the goodies installed: Regenerator (c=75%); Intercooling of 2-Stage Compressor (nc = 85%); and Reheating for 2-Stage Turbine (nr = 80%). The pressure ratio rp = 10:1, with air entering the compressor at 100 kPa and 300K. Maximum Temperature is set to 1500K. Pressure ratios will be equal in the Compressor and Turbine. a) Draw the Schematic with state point labels. b) Populate the table below. State Temp [K] Enthalpy [kJ/kg] 1 300 K 2s 2a 3 4s 4a 5 6 7s 7a 8 9s 9a 10 300 K 1500K

Consider a Brayton Cycle with all the goodies installed: Regenerator (c=75%); Intercooling of 2-Stage Compressor (nc = 85%); and Reheating for 2-Stage Turbine (nr = 80%). The pressure ratio rp = 10:1, with air entering the compressor at 100 kPa and 300K. Maximum Temperature is set to 1500K. Pressure ratios will be equal in the Compressor and Turbine. a) Draw the Schematic with state point labels. b) Populate the table below. State Temp [K] Enthalpy [kJ/kg] 1 300 K 2s 2a 3 4s 4a 5 6 7s 7a 8 9s 9a 10 300 K 1500K

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Must solve both i and (ii) . Dont solve only one.
For an ideal Rankine cycle, steam first enters the turbine at 5 MPa and 500C then it expands to a pressure of 100 kPa. a.) Draw the proper T- S diagram of the cycle with proper label for the points. b.) Find the quality of the steam, Qa, Qr, Wt, Wp, Wnet, efficiency, and steam rate.
Thermodynamics Instructions: Answer the problem. a) Estimate the enthalpy and quality (or temperature) of the exhaust. *show complete solutions and please write legibly. TY
For Brayton cycle, plot the efficiency vs pressure ratio curve between pressure ratio 6 to 10. What can we conclude from the graph?
Provide complete solution and detailed diagram. What is the resulting pressure when one pound of air at 15 psia and 200oF is heated at constant volume to 800oF? A. 180 psia B. 28.6 psia C. 36.4 psia D. 521.1 psia
A,B and C were answered, proceed to D,E and F. Air enters the compressor of an ideal air standard brayton cycle at 100 kPa, 300 K, with a volumetric flow rate of 5 cu.m/s. The compressor pressure ratio is 10. The turbine inlet temperature is 1400 K. Compute the (a) P, V, and T at each point of the cycle; (b) QA, QR in kW; (c) WC, WT in kW; (d) rp, TBW; (e) e; (f) mep.
Please proceed asap,urgent. Thanks.
Draw and label the P-V diagram of actual otto cycle applied to petrol engine. Draw and label the T-s diagram of ideal Rankine Cycle. Highest temperature of gas turbine cycle is 1200K and lowest temperature is 400K. What is the pressure ratio that will produce maximum efficiency, given that specifica heat ratio k for air is 1.42?
In a regenerative gas turbine cycle, the pressure ratio, maximum temp and min temp is 4.5, 900 K and 290 K, the cycle efficiency will be equal to
COMBUSTIONMENGINEERING PROBLEM: Rdirat www A regenerative-reheat gas turbine with intercooling between turbine stages is shown in figure. Air enters at 100 kPa, 300 K with a mass flow rate of 5.807 . The pressure ratio across the two-stage sec compressor is 10. The pressure ratio across the two-stage turbine is 10. The intercooler and reheater each operate at 300 kPa. At the inlets to the Turbine stages, the temperature is 1400 K. The temperature inlet to the second compressor stage is 300 K. The polytropic efficiency of each compressor and turbine stage is 80 %. The regenerator effectiveness is 80 %. č, = 1.005 , k = 1.4 Determine a. The Compressor work, in kg air k/ b. The Turbine work, in- kg air c. The Net cycle work, in- kg air d. The thermal efficiency, in percent e. The work ratio f. The The net power developed, in kW E- Draw the corresponding cycle diagram on the pv plane.
ı need solution
Question #1 (10 pts) Rankine cycle – Consider the ideal cycle shown below and determine the thermal efficiency of the cycle using the steam tables. T 500 °C 3 Wturb,out Tin 6 MPа 10 kPa Jout pump,in