Compute the pressure difference between two points 500 feet apart.  The pipe is horizontal.  Report your result in inWC.

Q: TRUE or FALSE Pitot tube is an insertion meter. When this is located at the center, the flow that…

A: Solution is attached below:

Q: Pitot probe is mounted in a 25 mm inner diameter pipe at a location where the local velocity is…

A:

Q: What is the pressure drop in psi of 60°F water flowing through 65 ft of horizontal 1-inch schedule…

A: Consider the solution below

Q: ( Use nomograph AND the formula) Size a pipe that will not exceed 48' of HL in 6000 feet of pipe at…

A: Given data: Head loss, HL = head loss due to friction, Hf= 48 ft Length of the pipe, L = 6000 ft…

Q: A pipe handles a flow rate of 0.002 m³/s. Find the minimum inside diameter that will provide an…

A: To find: The minimum inside diameter. Given: The flow rate is Q=0.002 m3/s. The fluid velocity is…

Q: The figure shows a duct in which methyl alcohol at 25 °C flows at the rate of 3600 L/min. a) Compute…

A:

Q: You must discuss in detail the way in which the pitot tube and nozzle flow meter are used to…

A: A pitot tube is a device that consists of a tube with a brief right-angled bend that is…

Q: A horizontal venturi meter 250 mm in mercury manometer is connected to th difference in mercury…

A:

Q: Question 8 Describe the possible flows through the network of water pipes shown in figure where flow…

A: At each node, we write out the equation that represents the conservation offlow there. We then…

Q: A gear train is composed of four helical gears with the three shaft axes in a single plane, as shown…

A:

Q: Compute points on the velocity profile from the pipe wall to the centerline of a 3/4-in Type K…

A: Given: The diameter of the pipe, d = 3/4 in The volume flow rate, Q = 0.5 gal/min The temperature of…

Q: A fire hydrant has an outlet diameter of 635 mm located 1.2 meters above the ground. When the valve…

A: Calculate the time taken by the water jet to reach the ground. t=2Hg Here, t is the time taken by…

Q: Reynolds number, based on the pipe diameter

A: Given; Two pipes of uniform section but different diameters carry water at the same flow rate.Water…

Q: A Venturi meter with a 15 cm I.D. at inlet and 10 cm I.D. at throat is laid with its axis horizontal…

A:

Q: Water enters a pump through a 250 mm diameter and leaves the pump through a 150 mm diameter pipe. If…

A: To find a. Velocity of suction pipe.b. Velocity of discharge pipe.

Q: Pure ethyl alcohol at 35°C is flowing inside a 2-inch diameter plastic pipe at a flow rate of 0.13…

A: Soln :- Given ethyl alcohol at 35°C Dia of pipe = D = 2 inch Flow rate = 0.13 m^3/s a) the density…

Q: A lorry is carrying 4000 liters of water. It is driven from Kota Kinabalu to Mesilau and it was…

A: Given Data: The initial volume of water in the lorry is, V1=4000 litres. The change in the…

Q: A condition of the venturi meter is in horizontal with inlet diameter 315 mm. Venturi meter…

A:

Q: 8. In the regenerative circuit shown below, the pump's flow rate is 10 gpm. If the piston diameter…

A: given data; ⇒flow rate (Q)=10gpm=6.309*10-5m3/s⇒piston diamter (d1)=7 in=0.1778m⇒rod diamter(d2)=5…

Q: f the typical piping system of a pump installation using standard symbols for required valves and…

A: Pipe not entirely set in stone through estimations utilizing directions and heights. Vertical…

Q: Q.1 Water is flowing through a 6” dia corrugated steel pipe. An energy loss of 2ft of head occurs…

A: diameter of pipe, d=6in=0.1524mhead loss, hL=2ft.=0.6096mlength of pipe, l=100ft.=30.48mfriction…

Q: A pressure relief valve has a pressure setting of 2000 psi. Compute the horsepower  loss across this…

A:

Q: A line of fluid power cylinders has a range of diameters in 1.00-in increments from 1.00 to 8.00 in.…

A: Given, Range of diameter of cylinders = D = 1 in to 8 in Force to be exerted = F = 5000 lb   In this…

Q: A Pitot tube is used to find stagnation pressure in relation to the static pressure port in an…

A: Given: at 10 km altitude  gauge pressure = 16.4 kPa

Q: Water 80F at 10 ft/s through a 6 inches sch 40 steel pipe with lenght of 1000ft The Reynolds number…

A:

Q: The pitot tube is used to measure the velocity of flow at the required point in a pipe Select one:…

A: Given Data⇒ Pitot tube

Q: a. Solve for the two (2) atmospheric condition, Pn1 & Pn2 at 32.68 0C and 41.12 °C. b. Calculate…

A: Given: (a): For temperature→T1=32.68°C=305.83 K The pressure will be: →Pn1=ρRT1…

Q: D F 40° leter inc he 2000N 30° E 70° C *Final answers should be in 3 decimal places. But use all the…

A:

Q: A pumping system is required that will a water ride. The system schematic is given below. Note that…

A: Solving the solution (1) of the question in figures

Q: Determine the maximum flow in a 2-inch class 200 PVC pipe with a objective of limiting the loss of…

A:

Q: Read the question carefully and give me right solution with clear calculations.  Note: pipe size…

A:

Q: 1) With the below nozzle arrangement, what pressure is needed in the pipe in order to get a nozzle…

A: From the given data,

Q: A venturi meter has a main pipe diameter of 65 mm and 26 mm diameter of throat. When measuring the…

A:

Q: The Alaska pipeline conveys crude oil 800 miles across the state of Alaska from Prudhoe Bay to…

A: Data given -  L = 800 miles = 800×5280 ft  di = 48 inch = 4ft  t = 0.5 inch  Outer diameter of…

Q: A water system of 2 inches (inside diameter) pipe, having a length of 1/4mile, is to be flushed with…

A: Given Data: The inside diameter of the pipe is, d=2 in=2 in×ft12 in=16 ft. The length of the pipe…

Q: Sl unit for the pressure head at a point on the flowing liquid inside pipe is in m of liquid. Select…

A: Solution:

Q: 1. A combination Pitot tube is being used to measure maximum velocity for water flow in a pipe. The…

A: Here we will use the general formula for velocity in pitot tube.

Q: 5. Write down the Benoulli equation and explain the meaning of each terins 6. Water is flowing…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.