Compute the number of modes that will be supported by a fibre with core diameter of 20mm, a core refractive index of 1.5 and a cladding index of 1.48 if it is excited by light of frequency 0.25MHz.

Q: Copper interconnections are introduced into state-of-the-art ICs because of its lower resistivity of…

A: Given; Resistivity (r)= 1.66µW.cm. Thickness = 1µm Width = 10µm die side Length =  20mm ab→= l…

Q: Find the cost per die for both wafers.

A: Cost per die can be calculated by the formula given below – For 1st wafer – Cost per wafer = 12…

Q: How many stored carriers are outside depletion region with an ideal abrupt junction silicon diode…

A: Here is the answer :-

Q: Consider the following circuit that implements the 3-input function F. Draw the equivalent CMOS…

A:

Q: 1 μm particles at equilibrium charge distribution will consist of many multiple charged particles of…

A: True

Q: 8-1. The D and CIk waveforms are given for the negative edge-triggered MS FF in the figure. Sketch…

A: I'm providing you the answer of the above question. I hope this will help you.

Q: How can we reduce the transition time of a Bistable Multivibrator?

A: A Bistable Multivibrator has two stable states. The circuit stays in any one of the two stable…

Q: Determine the worst case delay of CMOS circuit with the expression F=((A.C)+B).(A’.C’) driving 8…

A: Given: Determine the worst case delay of CMOS circuit with the expression F=((A.C)+B).(A’.C’)…

Q: 4. Design equation F(A,B,C,D)=E(1,2,3,6,8,10,12,13,15) using a 4×1 Mux?

A: A 4X1 mux, also known as a 4-to-1 multiplexer, is a digital circuit that selects one of four input…

Q: Show that: the APF for the SC cell is 0.52?

A: First of all, we should know what is APF: In crystallography, Atomic packing factor, packing…

Q: (a) Design a 1-Bit Comparator circuit which is capable of comparing two bits A and B and produce…

A: In this question,  we have to design a 1-Bit comparator circuit which will compare Two bits A and B.…

Q: For the given circuit, find the equivalent capacitance. C1 = 5µF , C2 = 3µF, C3 = 8µF and C4 = 9µF.…

A: Refer to step 2 for the answer.

Q: 3. Draw the equivalent signal flow graph and determine the forward path gains, feedback loop gains…

A: Answer is given below

Q: Design a 4 x 4 multiplier in Verilog HDL using any method of coding

A: GIVEN: Design a 4 x 4 multiplier in Verilog HDL using any method of coding

Q: Discuss how electrons flow in both forward and reverse biased PN junction. Ensure that you clarify…

A: A P-N junction diode is said to be forward-biased when the positive terminal of a cell or battery is…

Q: Suppose that a (pA = 0.1, ps = 0.2, A = 1 min)-BSSQQ is operating in steady state. Calculate EQ(0).

A: Given information: It is given that pA = 0.1, pS = 0.2 and delta = 1 min-BSSQ.

Q: If C=6nF, the frequency F=6KHZ of the Monostable multivibrator using NAND gate .Find the value of…

A: Given, Capacitor C = 6nF = 6 x 10-9 F Frequency F = 6 KHz =  6 x 103 Hz   To find the value of…

Q: Find the Fourier transform of the rectangular pulse signal x(t) defined by x(t) = Pa(t) = {1 |t| a

A: Answer

Q: Example # 4 The forward path transfer function is given by G(s) = 9/s(s+6). Obtain an expression for…

A:

Q: Find the transfer function, Vo(s)/Vi(s), for the circuit below.

A: From the basis of op-Amp,    Voltage at inverting terminal=non inverting terminal

Q: Find the Transfer Function of the System given by: d²y(t) 3dy(t) dt² dt + -+ 2y(t) = x(t) Where:…

A: Solution: Transfer function from the differential function formula:

Q: The time delay of following program is if crystal frequency is 8 MP LDI R15, 12 LDI R16, 14 LDI R21,…

A: We have to find the time delay. Given: Crystal Frequency= 8 Mhz

Q: Problem 1: Using KMaps, find the simplest SOP expression of F= Ew,x,Y,z(0, 1, 6, 7, 8, 9, 14, 15).

A: I have  provided   answer  with  brief  explanation------------ I have  provided  hand-written…

Q: For an 8-PSK system operating at an information rate of 36 kbps determine, (i) Baud

A: The Answer is

Q: 7. Design a self-bias network using a JFET transistor with Ipss=8 mA and Vp -6 V to have a Q-point…

A: The complete explanation is given below.

Q: O Reference pulse gen O LPF and multiplier ci O LPF and holding circ

A: given - PAM Demodulator consists ofComparator and SawtoothFlip flop and LPF Reference pulse…

Q: .Ccoraing to the following tion data for a chioride lon selective electrode. Sample Conc. pCl- Avg.…

A: First word written their which got cut is THE.

Q: it. Show that t=how it will propagate through the given diag 5. Explain in detail. 1 2 3 4 5 |H

A: Given:

Q: Output Port Load Output Port PIC crocontroller

A: ANSWER:The correct answer to the given question  is Option("a") "155 ohm"

Q: Design a 8:1 MUX in Verilog and VHDL mode

A: 8:1 Mux in Verilog:-

Q: What is the maximum wet film thickness (mils) for Sherwin-Williams B67R5? O a. 6.0 O b. 150.0 OC.…

A: Let's see the solution in the next steps

Q: 1.Ans the following: a)when a light signal is absorbed inside a fiber? b)write down the three major…

A: Wired medium is used for data transmission. Cables are used for transmission as it carries the data…

Q: 3- How many 74LS00 NAND gate inputs can be driven by a 74LS00 NAND gate outputs' Refer to data sheet…

A:

Q: For the admittance locus diagram shown below: find the value of each element in the * ?circuit if…

A: The admittance diagram is one of a family of graphical techniques that are of interest in…

Q: 2. A four-bar mechanism show in figure, so call drag-link mechanism. Write the Python program to…

A: Python code is given below

Q: Can you help me to solve this problem please Design a low-pass filter with the following…

A: Lowpass filter: The assignment of coming up with and building analog filters are often shifting into…

Q: Describe how does the BCS theory account for all the features of the  super conductivity

A: Describe how does the BCS theory account for all the features of the super conductivity