Completely solve and box the final answers. Write legibly 1. A Brayton gas cycle produces a net load of 600 Btu/lb for an entrance temperature of 40°F and heat addition temperature of 2500°R. a. Draw the system with a designated level of a given values b. Calculate the pressure ratio of air required in the system

Q: An engine has an inlet stagnation condition of 300 bar and 4000 kelvin. Methane and liquid oxygen…

A: Given: stagnation pressure = 300 bar stagnation temperature = 4000 K Ae/Ath = 34.34

Q: 2 Pressure gauge √x the hydraulic cycle in figure -consist of:7 5 6 X 3 Feed direction tank O…

A: ◆ Figure represented by no. 7 is tank. ◆ Therefore, correct option is (a).

Q: 5. An ideal Otto engine, operating on an air standard with k=1.35 has a compression ratio of 5. At…

A:

Q: A compressor is delivering air at a pressure of 8 bar gauge at the rate of 10 m3/min f.a.d. Average…

A: A compressor is a mechanical device that reduces the volume of gas in order to increase its…

Q: Components of pressure intensifier with defined

A: A hydraulic intensifier is used to increase intensity of pressure of any hydraulic fluid like water.

Q: solve in peaper

A:

Q: A three liters four cylinders C.I. engine has a bore of 9.7 cm and skirt length of 8.4 cm. This…

A: Given that, Volume of cylinder, Vd=3 liter,Number of cylinders, N=4,Bore diameter, d=9.7 cm=0.097…

Q: A point of zero velocity.  A. Critical Point B. Stagnation Point  C. Inflection Point   D. Triple…

A: Point of zero velocity is the point where local velocity of field is zero.

Q: Give a concise introduction on Douglass pressurized reservoirs.

A: DOUGLASS PRESSURIZED RESERVOIR :- Douglass pressurized reservoir is a tank which has immense…

Q: d) Malfunction of the level transmitter (LT) and pressure valve (PV) could result to tank overflow.…

A: General data Liquid Level Transmitter Type LT Liquid Level Transmitter Type LTLT-44 Level…

Q: is assuming to be operating on the ideal air standard (Otto) cycle. This four-cyliner engine has a…

A:

Q: In the classification of hot water boilers, high pressure boilers refer to boilers have pressure up…

A: Correct answer: (b) 3 MPa

Q: 2. A. Design a theoretical nozzle in order to expand isentropically superheated steam (P₁ = 280…

A:

Q: ..Equation for Law of conservation of mass and energy for a nozzle

A: Law of conservation of mass (For nozzle) The mass is conserved during the process, the mass of fluid…

Q: PROBLEM 2: Calculate the work done, to pump the water from 0.06 bar pressure to 6 bar pressure.

A:

Q: n air-standard Carnot cycle operates between temperatures of 80 deg F and 1472 deg F. The minimum…

A: Carnot cycle is an imaginary cycle that gives the maximum possible efficiency between two…

Q: The following information were given for a single-stage, single-acting air compressor: Speed: 430…

A:

Q: The inflow mass diagram is a method used for calculating: Select one: O a, Equalization tank volume…

A: An inflow mass diagram or a mass curve is a plot between the accumulated stream flow and time.

Q: Deriye an expres sion for velocity

A: Consider a nozzle as shown below,

Q: Apply the steady flow energy equation to nozzle, compressor, turbine, boiler, and mixing  chamber.

A: During steady flow-process, the total energy of a control volume remain constant i.e., ECV=constant…

Q: Q.4 Explain pressure feed lubrication system in I. C. engines

A:

Q: 1. define the cutfof ratio and the compression ratio     2. air is compressed at a constant…

A: Define cutoff ratio and compression ratio

Q: as density decreases, mass flow rate: a. de

A:

Q: ck work ratio, Thermal Efficiency (% No Description Pressure ratio=B Ratio…

A: Given, T1 = 27oC = 273 + 27 = 300 K P1 = 100 kPa Compressor Ratio1  = 7 Compressor Ratio2  = 12 From…

Q: 2.2 An ideal ramjet engine is being designed for a Mach 3.2 aircraft at an altitude of 10000 m. The…

A: Given Data Mach number is: Mo=3.2 Exit temperature is Te=Tmax1+γ-12Mo2=18891+1.4-123.22=619.75 K…

Q: A The compression ratio of a diesel cycle is 15.5, and the cutoff occurs at 10% of the stroke. 14…

A: given; →compression ratio(r)=15.5→cutt off at…

Q: QUESTION 19 The following information were given for a single-stage, single-acting air compressor:…

A:

Q: ME. BOARD FEBRUARY, 1951 In a certain diesel- alactric power plant, dieset generator set has the…

A: Given Datadiesel fuel consumption =109495kgP=518000kWT=596hrsηg=90% ***As per our company policy we…

Q: too lean mixture is supplied to the engine and may be caused in:

A:

Q: Please add units.

A: Unit: It is used as a measure to quantify the quantity identical kind. Every physical quantity has…

Q: 2. Fuel in Combustion chamber Turbine Net Power Air in Out Axial compressor Centrifugal compressor…

A:

Q: onsideration in selecting of ideal type of compressor

A: we will  discuss the consideration in selecting of ideal type of compressor

Q: Project 2 Problem 1 (a) Apply and derive the Steady Flow Energy Equation from the first…

A:

Q: Fixed geometry jet engine inlet is not feasible for very low supersonic Mach no.

A: In order to achieve optimal operational efficiency, the air flow into the compressor should be…

Q: An automobile carburettor having its flost chamber vented to the atmosphere is tested. at sea level…

A: (a) The venturi/throat pressure with air cleaner is 0.815 bar. (b) Air-fuel ratio with air cleaner…

Q: 9. regulate flow or pressure to other valves. 10 are used to hold the air in bicycle tires. A fluid…

A: ________regulate flow or pressure to other valves. _________are used to hold the air in bicycle…

Q: A two-stroke direct injection diesel engine has a displacement of 23 liters. The engine has a…

A: a) for BP=880hp BP=880hp=880X746W=656480W displacement rate, Vs=0.023X2245/60=0.86m3/s Mean…

Q: Derive an eeporession for Gysoscopic Couple

A: The answer is given in next step

Q: Air undlergoes KoTnermai expansion in a Carnot cycle where the pressure 2-6 Mpa to l:5 upa. This…

A: Consider the diagram as shown below for the Carnot cycle.

Q: 4. An ideal Otto engine with 15% clearance (15% of the volume displacement) operates on 0.227kg/s of…

A: Given Data: The mass flow rate of air, m=0.227 Kg/s The heat released, Qin=110 kW

Q: "Heat and work are not mutually convertable in the system

A: Given: To define: Heat and work are not mutually convertible in the system it states: And the type…

Q: What is the desired nozzle tip output to the nearest hundredth to deliver 10 gpa with equipment that…

A: Given: The value of gallons per acre is GPA=10. The value of ground speed miles per hour MPH=12. The…