Complete the table and calculate for the area of the field of vision from the image. (provide complete solution)

Q: Refer to Fig. 2.4. The tension in the cable BD is 1 kN. As a result, cable BD exerts a 1-kN force on...

A:

Q: The graph below represents a snapshot at t =0 of a wave of frequency 10 Hz that travels in the posit...

A:

Q: Water at 60F is flowing through a 3-inch inside diameter smooth horizontal pipe. If the Reynolds num...

A: Given: T = 60 F d = 3 in. Re = 353000   To find: Ratio of maximum velocity to average velocity    

Q: ratio of external to internal diameter 2:1. Calculate (a) the hydraulic efficiency, (2) power, and (...

A: Given: Q=1500 l/s H=6.2 m D2/D1=2 D2=1.2 m N=210 rpm A=0.65 m^2 To determine:  (a) the hydraulic eff...

Q: Angular Holes                  1.  Principle of drilling Angular Holes                  2.  Basic ...

A:    When the motor is turned on, the spindle revolves, and the stepped pulley linked to it turns as w...

Q: a. What is the specific weight of air above at a room temperature of 30°C and a pressure of 470 kKPa...

A: Ideal gas equation PV = nRT is used to get the solution.

Q: d the frequency of transverse vibrations of a shaft which is simply supported at the ends and mm in ...

A:

Q: | In a certain device using water as the working fluid, superheated vapor at state 1 flows in, liqui...

A:

Q: 1. Natural gas at 23°C, 1 bar enters a furnace with the following molar analysis: 40% propane (C3H3)...

A: A). Partial pressure of components is given by the following formula, Pi=X*Pt Where X= mole fraction...

Q: In the assembly of the bronze tube and steel bolt shown in the figure, the pitch of the bolt thread ...

A: GIVEN DATA -  

Q: Find the degrees of freedom of the kinematic linkages below. (d)

A:

Q: Stream function: Y+coshx (a) Show if the function is incompressible. (b) Draw in Excel streamline pl...

A: The route of imaginary particles floating in the fluid and transported along with it is known as a s...

Q: The steel cylinder has a specific weight of 490 (0/f" and acts as a plug for the 1 ft long slot in t...

A:

Q: B FIGURE 1. Q;B =1 in: BC = 3 in.; wz = 1, constant. Find the absolute linear acceleration for point...

A: Answer: The absolute linear acceleration of point C is 0.7071 m/s2.

Q: Two steel sheets of 1.5 mm thickness are spot welded in a lap joint with a current of 10,000 A for 0...

A:

Q: The rigid bar ABC is supported by a pin at A and a steel rod at B. Determine the largest vertical lo...

A:

Q: A pudding mix is being formulated to achieve a total solids content of 20% in the fi nal product. Th...

A:

Q: Particle A lies on the xy plane and is acted on by the three forces shown. Find the  resultant of th...

A:

Q: The cylinder of a portable hydraulic riveter is 220 mm in diameter. The pressure of the fluid is 14 ...

A: GivenD=220mmP=14N/mm2=14MPaσp=105MPa

Q: The tailwater elevation and the headwater elevation of a hydroelectric plant are 80m and 140m respec...

A:

Q: A single plate clutch transmits 25 kW at 900 rpm. The maximum pressure intensity is 85 kN/m´. The ou...

A: Given that, Power transmitted by clutch,  P=25 kW=25×103 W Speed, N=900 rpm Maximum pressure intensi...

Q: In the diagram below, a force P of 750 N is applied to the 350 kg block. Find the acceleration of th...

A:

Q: 3. The pendulum consists of a 10-kg uniform disk and a 3-kg uniform slender rod. Determine the kinet...

A:

Q: Give an Example of a problem on Actual Reheat rankine cycle with complete solution and compare it wi...

A:

Q: Two concentric spheres of diameter D = 0.8 m and D2 = 1.2 m are separated by an air space and have s...

A:

Q: Two steel sheets of 1.5 mm thickness are spot welded in a lap joint with a current of 10,000 A for 0...

A: From the given data, Thicknesses of plates = T = 1.5 mm Current = I = 10,000 A Time during which cur...

Q: evaluate the irreversibility

A: Given; During expansion, heat transfer from air to the surrounding at 300 K  Or,Air expands steadily...

Q: A steam turbine rotor is 160 mm diameter below the blade ring and 25 mm thick. The turbine is runnin...

A: A steam turbine rotor has a diameter of 160 mm below the blade ring and is 25 mm thick.The turbine i...

Q: A particle undergoes a simple harmonic motion with an amplitude A and a total energy E. When the dis...

A:

Q: Determine the magnitude of the resultant R 600 N 400 N 60 O a 1000 N Ob 600 N O. 529 N Od. 400 N

A: As per given  Question  We have to find determine magnitude of 

Q: A helical gear has a normal diametral pitch of 24, a normal pressure angle of14 14,°. 72 teeth, a fa...

A:

Q: An experiment was conducted to determine the rheological properties of mango puree using a coaxial c...

A:

Q: The system shown below is released from rest. Determine the acceleration of mass A. (Hint: start by ...

A: Given: mass of the block A→mA=6.5 Kg Let block  A has acceleration a in downward direction. And angl...

Q: A capillary –tube viscometer is being selected to measure viscosity of a liquid food. The maximum vi...

A: capillary –tube viscometer is an apparatus for measuring the viscosity of a fluid by passing it thro...

Q: The diameter of the discharge pipe of pump is 15 cm and that of intake pipe is 20 cm. The pressure g...

A: In the hub stream siphon, the impeller cutting edges guide the liquid pivotally. In this siphon, the...

Q: A household refrigerator is maintained at a temperature of 2 degrees C. Every time the door is opene...

A:

Q: 5 Second conditional T82 Rewrite the sentences with the second 1 I can't take you to the airport bec...

A: Hi and thank you for the questions. We are authorized to answer three subparts at a time, since you ...

Q: Part A angular velocity of link AB is wAR = 6.5 rad/s. (Figure 1) Determine the velocity of block C ...

A:

Q: Two bodies radiate heat to each other. One body is at 30 C and the other at 300 C. The emissivity is...

A:

Q: As shown in the figure, a 300-ft³ tank contains 25 lb of H20 initially at 30 lbf/in². The tank is co...

A:

Q: As shown, two blocks, resting on different inclines, are connected by an inelastic cable that passes...

A:

Q: 2. The stresses shown in the figure act at a point in a stressed body. Using the equilibrium equatio...

A:

Q: Determine the correctness

A: Given; Assertion A:       In a power plant working on a Rankine cycle, the regenerative   feed water...

Q: The cylinder of a portable hydraulic riveter is 220 mm in diameter. The pressure of the fluid is 14 ...

A: From the given data, Diameter of the cylinder = d = 220 mm Gauge pressure of the fluid = P = 14 N/mm...

Q: Identify whether the following set of dimensions determines a Grashoff, Non-Grashoff or Special Case...

A:

Q: An elevator weighs 1000 pounds and is supported by a 5/16 inch diameter cable, 1500 feet long. When ...

A:

Q: A gas mixture at 350 K and 300 kPa has the following volumetric analysis: 65 % N2, 20 % O2, and 15 %...

A: GIVEN DATA- MIXTURE OF GAS GIVEN AT 350K AND 300KPa WITH FOLLOWING % GIVEN WE HAVE TO FIND MASS FRAC...

Q: Determine the magnitude of the acceleration of point A at the instant shown. Express your answer to ...

A: Given Dataα=7rad/s2ω=4rad/sr=0.1m

Q: b) A stably floating cuboid is shown in its initial state and in a deflected position. Define the lo...

A: Metacentre, furthermore spelled metacenter, in fluid mechanics, the theoretical spot where a whimsic...

Q: The shaft shown is machined from C1040, OQT (oil-quenched treatment) @ 1,000°F. It is subjected to a...

A:

Radiation

Radiation can be described as the energy in the form of a particular matter or electromagnetic waves traveling in the air and can be in the form of light, sound, and heat. Radiation can be detected through special instruments like X-rays. The radiation from a cooler object is less intense as compared to the radiation from hot objects.