Combustion gases contain CO2, CO, O2, N2 and water vapor. It is common practice to report the composition in volume % on a dry basis (water-free) called the ORSAT analysis and to indicate the water content by its partial pressure. A typical analysis is as follows: 12% CO2, 3% CO, 7%O2, 78%N2 with Pressure of water of 1.33 kPa at a total pressure of 101 kPa. What is the composition on a wet basis(inc1uding water).

Q: 10 m of cold air (measured at 287 K and 101.3 kN/m2 saturated with water vapor) is compressed to 330…

A:

Q: The normal boiling points of the two pure components, n-heptane and n-octane are given as 98.4°C and…

A: Given: The boiling point of n-heptane (1), T1 = 98.4°C The boiling point of n-octane (2), T2 =…

Q: Q3/ What weight of ethane is contained in a gas cylinder that is 1.0 ft' in volume if the gas is at…

A: Vanderwaal's Equation is a modified version of Ideal gas law which states that the gases consisted…

Q: A storage tank at 1000F is part full of a liquid mixture which contains 50 mole % n-butane and 50…

A:

Q: HW 4.2 What is AU of 1 mole of O2(g) when it is heated from 298 K to 500 K, if the volume of gas is…

A:

Q: 2. The absolute humidity at atmospheric pressure at 30 ° C is 0.011 kg water / kg dry air. Specify:…

A: Given: Absolute humidity y1 = 0.011 kg water / kg dry air Pressure = Atmospheric = 1 atm = 101.325…

Q: The normal boiling point of a metal (Me) is 1000 °C. Calculate its vapor pressure at 900 °C,…

A:

Q: 2. Using the steam tables (for water), find the specified property data at the indicated states. In…

A: a) from steam table at P=3 bar and v = 0.5 m3/Kg  now calculate quality v = vf + x(vg - vf)0.5…

Q: 1.11 Ethane at 10 MPa and 100°C is heated at constant pressure until its volume has increased by…

A: (a) Write the relation between temperature and volume at constant pressure process as follows: T1V1…

Q: 7 (b) A mixture containing 50 g water and 50 g ethyl aniline, which can be assumed to be essentially…

A: The problem involves a mixture of water and ethyl aniline, two substances that are assumed to be…

Q: The absolute humidity at atmospheric pressure at 40 °C is 0.015 kg water / kg dry air. Determine a…

A: Given: Absolute humidity y1 = 0.015 kg water / kg dry air Pressure = Atmospheric = 1 atm Temperature…

Q: A 5 kg/min stream of liquid ethanol-water at 40 °C containing 30% w/w of ethanol will be heated and…

A: To find:(a) What will be the composition  of the liquid at the bottom?(b) What will be the…

Q: A 1.75 mole of gas at temperature 330 K expands isothermally from an initial volume of 2.0 L to 8.0…

A:

Q: Calculate the enthalpy change for 1 kgmol of C0 gas which is heated at a constant pressure of 100kPa…

A:

Q: 3. A gasoline can be represented by the formula C,H16. a) Write the theoretical combustion equation…

A:

Q: find the ideal difference from the boiling points of a compound that can normally be distilled ( in…

A: The ideal difference from the boiling points of a compound that can be distilled is to be…

Q: 2. Find the boiling pressure of acetone (mmHg) at 45 °C using: (b) AHeap from Problem 1 (you may…

A: Given that, Temperature T = 45oC = 318 K Enthalpy of vaporization ∆Hvap = 32.4 kJ = 32.4×103 J It is…

Q: 2. Draw an appropriate process path diagram for each of the two chemical systems undergoing…

A: Step 1:Step 2:Step 3:

Q: 2- A wet gas has the composition given below at the reservoir conditions of 5709.0 psig and 293 °F.…

A: Given data: Properties of gas at reservoir conditions are, Pressure = 5709 psig Temperature = 293 0F…

Q: The vapor pressures of ethanol (C,H,OH) and 1-propanol (C,H,OH) at 35 °C are 100. mmHg and 37.6…

A: Let,Component 1 is ethanol and component 2 is propanol.As per Raoults law.Here P is the total…

Q: The enthalpy of vaporization of a certain liquid is found to be 14.4 kJ mol-¹ at 180 K, its normal…

A:

Q: 11.7-2. Boiling Point, Dew Point, and Flash Vaporization. Following is the composition of a liquid…

A: The boiling point is where the vapor composition pressure is equal to the surrounding pressure of…

Q: Determine the Low Heating Value (LHV) and High Heating Value (HHV) of carbon monoxide gas in units…

A: Given that, The standard formation enthalpy of H2O(g) ∆HH2Ogo = -241.8 kJmol The standard formation…

Q: A sample consisting of 3 of Ar at 101 kPa is expanded isothermally at 5°C from 22dm to 177dm against…

A: Hi and thanks for the question. Since you have not mentioned whether 3 is the number of moles of Ar…

Q: The vapor pressure of a single component, 2 phase system (vapor is assumed to be ideal gas) was…

A: Given Data : The temperature-pressure data of the single-component two-phase system is given as:…

Q: Using the following data of heats of combustion in cal/g mole, calculate the following: (a) Heat of…

A:

Q: ) A 3.0 L flask containing 2.0 mol O2 and 1.0 mol N2 is in a room that is at 22.0° What is the total…

A: The volume of the flask = 3 L Moles of O2 in the flask = 2 mol Moles of N2 in the flask = 1 mol The…

Q: 5. A tank contains a liquid composed of 60 mol% toluene and 40 mol% benzene in equilibrium with the…

A: Given: x1 = 0.6, x2 = 0.4, P = 1 atm, T = 80 0F To calculate the composition of the gaseous phase…

Q: Estimate the heat of vaporization of benzene and of toluene at 85 °C and at 105 °C using the highest…

A:

Q: Estimate the freezing point (solidification temperature) of benzene at a pressure of 115 bar given…

A: Given data: Pressure = 115 bar Enthalpy of fusion = 9.94 kJ/mol Density of liquid benzene = 876…

Q: The following table shows the boiling pressure of pure acetone at different temperatures: T (C) P…

A: Temperature and vapor pressure of pure acetone is given.

Q: It is a fact that the normal boiling point of water is 100°C 2a. What is the enthalpy of…

A: (2a) Normal boiling point of water, T1=100°C=373.15 K From the property table, obtain the enthalpy…

Q: A 0.5 m3 tank will be used to store CO2 at 20 °C. Using the peng-robinson equation answer the…

A: Given that, The volume of the tank V = 0.5 m3 Temperature T = 20oC = 293.15 K Properties of CO2:…

Q: You closed the mouth of the 5 liter empty PLASTIC bottle at 20oC, when you took the PLASTIC bottle…

A: The initial volume of the empty plastic bottle, V1 = 5 L Initial temperature of the plastic bottle,…

Q: A gaseous mixture has the following composition by mass: Gas Mass fraction (%) Molar constant…

A: "Since you have posted multiple questions, we will provide the solution only to the first question…

Q: For a liquid mixture of 10mol% ammonia in water, calculate the partial pressure of ammonia in the…

A: Given: The mole fractions of ammonia in solution is xNH3 = 0.1 or 10 mol% Thus, the remaining is the…

Q: The following temperature / composition data are obtained for a mixture of octane (O) and toluene…

A:

Q: The "normal boiling point" is the temperature that a liquid will boil at 1 atm pressure. Most…

A:

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.