Claculate v ,i and conductance  g...

Q: d.) Average power e.) f.) Power when t=1/480 sec, 1/240 sec, 1/90 sec. Draw voltage, current and…

A: In this question,  We need to calculate the average power, power at different different time and…

Q: Q4: For the block diagram shown in figure (3). What is the value of K, and K; if: 0.1 10K₂ C(s)…

A: Solution- Given, CsNs =0.111s+6 .......................................1 If R(s) = 0, CsNs…

Q: how about on discharging how many volts is the maximum to discharge the battery?

A: Given  We need to find the Discharging voltage of TP4056. Please find the typed answer below.

Q: Q3/ Using Mesh analysis, find the current through each resistor for the networks in Fig. 3. The…

A:

Q: Q2) A DMS sends a message with alphabet size equal to 6 symbols at 100 symbols/secs. Symbol k is…

A: DMS Sends a message with alphabet size equal to 6 symbols at 100 symbols/sec. symbol k is repeated k…

Q: (d) (a)+(b)+(c) 3- The generation of electricity achieved by moving a conductor in a magnetic field…

A:

Q: The voltage between two phases in a balanced three phase-system (4 conductors) is U = 660V. The…

A:

Q: Find Laplace transformatio of the F(t) = 3 + ² + 5 sinhzt + lot² et

A: The given signal is,  f(t)=3t2+5sinh(2t)+10t2et On applying the Laplace transformation,…

Q: A 250kVA, single phase transformer is designed to have a resistance of 1.5% maximum efficiency…

A: In this question , we will find efficiency of single phase transformer with given data..

Q: Please send the Design of the tank as photo or PDF file  the Design sketch of the tank  is require…

A: The diagram of the tank is presented in the following section.

Q: for k = 0, 1, 2 for k = 3,4 h(k)= = elsewhere, where k is the time index or sample number, . sketch…

A:

Q: A SUBSTATION RATED 1250 KVA IS OPERATING AT FULL LOAD AT 0.8 PF LAGGING AND TO CARRY AN ADDITIONAL…

A: The substation is an electrical substation is a subsidiary station of energy technology,…

Q: nd the rms value of the full wave rectified sine wave in figure shown low. Calculate the average…

A:

Q: induction motor is rated 5 HP, 75% power factor and 220 V. What approximate size of capacitor (VAR)…

A: We need to find out VAR size for increased power factor

Q: An electron in a TV picture tube moves toward the front of the tube with a speed of V = 5.10 m/s.…

A: In the above given question we need to calculate the magnetic force on the electron. For the given…

Q: The displacement of a particle varies with time (t) as at^2-bt^3. the acceleration of the particle…

A: velocity v= ddtdisplacement. acceleration a= ddtvelocity. given displacement = at2-bt3

Q: A stone is released with zero velocity from the top of a tower, reaches the ground in 4 sec. The…

A:

Q: Using a A-Y or Y-A conversion, find the current I in each of the networks in Fig. 5. Μ 4km Α 6kΩ 400…

A: Circuit is given, Converting the delta to star and drawing the equivalent circuit,

Q: Find VTH, ZTH, and IN for the circuit shown below for R = 2 ohms. 3N j4 R 10/40° V 6 Ω 2/20° A go

A: In this question,  We need to determine the Thevenin voltage, Thevenin impedance and norton current…

Q: 12 V +t e 20.0 Ω E W 2.0 Ω w 10.0 Ω W 10.0 Ω w 6 How much current is in one of the 10 22 resistors…

A:

Q: A. Discuss the importance of power electronics interfaces in microgrid installations B. With the aid…

A: (A) Importance of power electronics in microgrid installation : The main power electronic device are…

Q: 91. Choose only seven for the following: 1) ******** ............of measurement is difference…

A: Given  Multiple choice questions based on measurement. Please find the below attachment for clear…

Q: If resonant frequency, wo = 1100 rad/s, find the following: a) L in mH; b) Quality factor Q; c)…

A: In this question parallel RLC resonance is given...We have to find out L, Q factor , bandwidth…

Q: Q5-A 800 KVA transformer During the day it is loaded as follows: For 4 hours 500 KW at 0.8 p.flag…

A:

Q: Find the source voltage Vs. the apparent power, complex power, average power, reactive power, and…

A: In this question we will find source voltage , power from source and capacitance connected in…

Q: (a) Find the Fourier Transform of the impulse response, h[n] = 8[n] + 28[n 1] + 28[n-2] +8[n-3]. (b)…

A:

Q: Q4. [14 Marks A DC shunt motor is supplied by 250-volt and 15kW at rated load, if the No-load speed…

A:

Q: 2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor…

A: We will find out RMS value for given waveform and power for given resistor

Q: Find VTH, ZTH, and IN for the circuit shown below for R = 2 ohms. 3 Ω j4 Ω 10/40° V 6 Ω 1) 2/20° A…

A: For the above given question by calculating open circuit voltage across the given terminal we need…

Q: E7.11 The voltage source in the network in Fig. E7.11a is shown in Fig. E7.11b. The initial current…

A:

Q: 11. *Design a bandpass filter of the form in the figure below, with a lower cutoff frequency of…

A:

Q: Which of the following pairs of quantity and unit are correct? Select one or more: a.…

A: It is given that: a.density-kilograms per square meters b. current-ohms c. pressure-pascals d.…

Q: Q5/ Using a A-Y or Y-A conversion, find the current / in each of the networks in Fig. 5. w 4 k www…

A: We need to find out current for given circuit

Q: (B) -Indicate whether the following statements are true or false and correct the false statements…

A: In this question we will write answers related to transformers , dc machines... Note :- as per our…

Q: Q2/ For the network in Fig. 2: 1. Find the currents I, and I,. 2. Find the voltages V, and V3. 10A…

A: In this question we need to find a current Is and I1 . And voltage Vs and V3

Q: Jse superposition to find the phasor current, I, for the circuit below. 13 Ω -js n ΤΩ 202 3/50° A…

A: In this question,  We need to determine the current I as shown the circuit using the super position…

Q: FIGURE 21: This conceptual model shows the basics of how a dryer works. electrical energy desired…

A: The given system is a closed loop control system of a dryer system.

Q: The difference equation is: y(n)-0.4y(n-1) + 0.29y(n-2) = x(n) +0.5x(n − 1) a. Find the impulse…

A: The Given Difference equation is yn-0.4yn-1+0.29yn-2=xn+0.5xn-1 To Find the impulse response…

Q: Q3/ Using Mesh analysis, find the current through each resistor for the networks in Fig. 3. The…

A: Given: Circuit

Q: A TRF receiver is to be designed with a single tuned circuit using 10 µH inductor. Calculate the…

A: Given data, Inductance L=10 μH fmin=540 kHzfmax=1600 kHz Quality factor Q = 110

Q: Q3-A)-Indicate whether the following statements are true or false and correct the false statements…

A:

Q: What is the impedance of purely inductive circuit at a frequency value approaching to zero?

A:

Q: By Nodal Analysis, obtain Io j4Ω 100/20° V 3Ω In ΖΩ ΑΛΛΑ 1431 ΤΩ -j2 Ω

A:

Q: For the circuit shown below, solve for Z₁ that draws the maximum average power and what is that…

A: In this question we need to find a maximum average power transfer to load and ZL for maximum power…

Q: First question: Distributor (AB) fed from one end Find the distribution of currents and voltages on…

A:

Q: The x-component of a force of 50N is 30N, then what will be the y- component of the same applied…

A: We need to find out y component of given force

Q: Q3-A)-Indicate whether the following statements are true or false and correct the false statements…

A:

Q: PZ 4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is…

A:

Q: The AVERAGE value of a half-wave rectified voltage (in V) with a peak value of 251.57V is

A:

Q: 1. Consider the LTI system with impulse response h[n] = u[n] (i) Can this system be implemented…

A: