Choose the converter which is used for converting Fixed bi-directional voltage to Variable alternating voltage? a. Bidirectional current converter O b. DC voltage controllers O c. AC voltage controllers O d. Bidirectional voltage converter

Q: choose the correct Statement a. if  the load of PV module  Decreases, then its Output current…

A: On PV module, voltage will be constant.  But load current depends on the light intensity, not load.

Q: Write the different types of circulators and explain its operation.

A: According to guidelines we need to solve only the first question. According to the question we need…

Q: User manual of the multimeter shows the errors of the meter as follows. The 3- instrument indicates…

A: Given that V=21.5V In 100 V DC voltage range, Error=±1.5%rdg+0.5%fs+2dgt 1.5% rdg=21.5×1.5100=0.322…

Q: 10. What are the range of values for IL(Load Current) for the given circuit below? 1ka 21 25V RL 12V

A: Here the properties of zener diode has been used. The zener voltage mentioned here is 12v. The load…

Q: 24V 623 82 20V

A:

Q: The value of Keq is not dependent on temperature. True False

A: For the given question identify the given statement true or false. The value of Keq is not…

Q: 23. The nucleus of an atom is made up to a. Proton and neutrons b. Electrons and protons c.…

A: 23.Answer-a protons and neutrons  The nucleus of an atom is positive charge which contains protons…

Q: 1. Four identical 200 cd lamps are suspended 8 m above the ground at the corners of a square of 3 m…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: If V1 = 22 V, V2 = -7 V, R1 = 1.2 kOhm, R2 = 4.7 kOhm, R3 = 2.4 kOhm, and all diodes are silicon for…

A:

Q: (a) A set of independent measurement of the resistance of a resistor was taken by ten observers and…

A:

Q: What is the stability factor of the circuit shown below? Show the details of your work. 16V 3.6ka…

A:

Q: Question 11 Power electronics devices are optional components for present day WECS, true or false?…

A: 11. Power electronics devices are optional components for present day WECS. Thus statement is true…

Q: the circuit shown below: NI 250v 100 120V 20Q N4

A:

Q: "If lab is equal to 290.9852320 and lb is 1682110, Ic should be

A:

Q: What is the susceptance (in Siemens) of a 0.051Fcapacitor at 593rad/sec? (Give answer in 2 decimal…

A: Capacitive susceptance, Bc= ωC  Where, C is capacitance in farad             ω is frequency in…

Q: Consider the circuit shown below and answer all of the following questions. t = 0 10Ω 40 %3D 20 V 20…

A: In this question we will find inductor current at steady state in transient circuit.....

Q: 5) Figure below shows an image, A with structuring element 1 and 2 that are denoted as SE1 and SE2…

A:

Q: 2.4

A: Detailed solution is peovided below.Explanation:

Q: 7) In the two circuits shown here, the probabilities for successful operation for the sub-elements…

A: According to the question, for the given circuit as shown belowthe probability of successful…

Q: For the following circuit find VL, IL, Iz and IR if RL = 180 , repeat for R₁ = 470 R$ 20 V 220 2 Vz=…

A: Given: Circuit diagram,

Q: in el Eocs) / Ei (s)

A: The solution can be achieved as follows.

Q: Discuss the types of Renewable Energy in 300

A:

Q: Hau/ Find the hansler lunchion Vs)NG) fr the Cireuit shown below e- 152 VO 1H 1H VICA

A: In this question,   We need to determine the transfer function of the given circuit.  We are solving…

Q: (f) Write down the readings for each of the test meters taking care to include their units.

A: The digital multimeter can be used to measure the voltage, current and resistance. Based on the knob…

Q: 3302 Ź2702

A:

Q: Determine Reg in Ohms at the (a,b) terminals for the following circuit. Round your answer to the…

A: We will use series and parallel combination to find out equivalent resistance between a and b

Q: 4. For 3 hours of pure music, determine the amount of storage needed to record based on 2 channels.…

A: For a pure music, given that: Time taken to play (t) = 3 hours = 3×60×60= 10800 seconds; Number of…

Q: (b) Complete the following Table Q.lb. Table Q.1b Q-format Value Decimal Value Q 3.4 DA16 Q7 0100…

A:

Q: 18. The melting point of magnesium is 650°C. Express the melting point in (a) °F, (b) °K.

A: given temperature

Q: Select in descending order based on percentage the primary energy use of the world O a. petroleum,…

A: There various of energy source in the world . Coal  Natural gas  Petroleum

Q: Write the ohms law and name all the units

A: Statement Ohms law

Q: Germanium Silicon Vo v2 V1 RL 1k 15 mi

A: The given circuit is,

Q: 1. Determine Rea GODSV Reo

A: In the question,  Find the equivalent resistance Req  If two resistances R1 and R2 are parallel then…

Q: b.1 Given an anc of 0.998, determine IC if IE = 4 mA. b.2 Determine ɑpc if IE = 2.8 mA, IC = 2.75 mA…

A: The solution can be achieved as follows.

Q: a Refersing to figureI, the voltaige reading at Rq was measured using a vo tom eter having a…

A: the percentage of errror for each reading obtained is determined as shown below

Q: QUESTION 1 (a) Table Q1(a) is given. Calculate the precision of the 9th measurement. The actual…

A:

Q: 2. a) Adjust Vab = 20 Vpp and the frequency as 100 Hz, 500 Hz, 1 KHz, 50 KHz, 100 KHz then measure…

A:

Q: R1 C1 1000 470pF 10% V1 2Vpk 60HZ 0°

A:

Q: a wind turbine converts wind energy to electrical energy if the turbine reads 1000 J of wind energy…

A: Since energy neither be created nor destroyed but it will change from one form to another form.

Q: PE 42. What is the difference in length of the bronze specimen if it measured 130cm after heating up…

A: We need to find out difference in length

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.