ch IA 4A

Q: G₂/ 0011100110 Q2/ (manchester 27 polar NRZ.L 3) unipolar RZ

A: Given,  Binary data = 0011100110; We need to represent the given data in the following line coding…

Q: Diiferentiate open loop system and close loop system

A: The desired output in an open loop system is independent of the control action, which is one of the…

Q: 2. Determine whether or not the following equalities corect: A+B.C+A C =BC h. B(AO) +B.C+ ACBO)%3D

A:

Q: 1. Determine the frequency of oscillation. Rf U1 C1 C2 C3 Vout 741 +1 1µF 1µF 1µF R1 10000 R2 10000…

A: Given, C = 1 micro Farad = 1×10-6 F R = 1000ohms

Q: In RG 59 coaxial cable RG term represents

A:

Q: 1) RB IB= 20μH Vcc Ic 2.2K-22 VCE = 7.2V ↓IE = 4MA Det. a) Ic b) Vcc c) B d) RB

A: Given:we need to find:a) IC,b) VCCc) d) RB

Q: Filter for power supply can be in fom of A.LC filter B.RC filter C.RL filter

A: In this question we will write about power supply filter.....

Q: The Energy of the signal 10 e-stu(t) in the frequency band [0] Hz is

A: To find the energy of the signal in the frequency band Hz, we can use Parseval's theorem, which…

Q: Q2) find the signal at each indicating point of figure 1. (a3-3-4) kHz, X X (3 BPF USB 10 Cos…

A:

Q: the duty cycle of the following circuit is equal to * Vcc (8) 10k 15k RESET Vcc (7) DISCH 555 (6)…

A: In the circuit Find the duty cycle of the given 555 IC. Duty cycle = RA /(RA +RB )

Q: Determine the frequency of an free running oscillator circuit given that R₁ = 3N, R₂ = 2.7 kN and C…

A:

Q: Given Vcc=100V, R₁-2002, ß-100, VBB-5V, flip the switch to close, 3. and Ic=0.4A, 1) Determine IB.…

A: Given that  Vcc =100 v RL = 200 ohms Beta = 100 VBB = 5 v Ic = 0.4 A

Q: If whole number ratio in Lissajous pattern is Nx:Ny=2:3 and fx=1kHz, then fy= 666.667 Hz O 1.5 kHz…

A:

Q: A frequency multiplier circuit must be operated in class AB

A: frequency multiplier circuit generates an output signal and its output frequency is a harmonic…

Q: R 10 kN 0.015 μ F R1 1.0 kN oVout IN914 2N5458 R2 1.0 k2 C2 0.015 µF R4 10 kN C3 1.0 μ 820 N

A:

Q: Complete the timing diagrams (Q starts as 0): Maste Slav Om D D Clk o Clk o Cloc Cloc Clock Om O -…

A: Please find the timing diagram in below image.

Q: = L e-2t 8 ( -5 00

A:

Q: what are the structural differences between reverberating and converging circuits

A: The converging circuit: The converging circuit diagram is shown in the following figure:

Q: 5. For a half-wave phase control circuit draw the output voltage and current waveforms when firing…

A: Y =15 so α= (60-15)°= 45° so the current & voltage figure are as follows:

Q: 2) Fill in the blanks with a letter corresponding to the pole placement plot below; arrows indicate…

A:

Q: Examples of Close loop versu open loop

A: We need to explain the examples of open loop and closed loop control systems. A system just contains…

Q: 0 Vm 72 T T {₁ R e +

A: We need to find out the output waveform for the given circuit.

Q: The overlapping angle may increases by

A: Need to find how overlapping angle may increases

Q: 2. A 500 Hz modulating voltage produces a frequency deviation of 2.25 kHz. What is the modulation…

A:

Q: The oscillation frequency for the oscillator below is 3.12 MHZ for c=150 PF, L1=L2= 2.2 mH and M=0.5…

A:

Q: Simplify Ā CB E +BC) Ā (BE

A: GivenA(B C+BC)

Q: et sin3t sin 3t

A: As per our guidelines we are supposed to be answer only the first question. Kindly repost the other…

Q: Determine the period and frequency of oscillation for an astable multivibrator with component values…

A: The astable multivibrator generate square wave. It doesn't require any external triggering pulse.…

Q: What is the cut-off frequency of the circuit below if R1 = 1664.61 , R2 = 1002.27 0, R3 = 11.69 02,…

A: The given circuit is a low pass filter and it is used to pass only the low-frequency signal and the…

Q: 14.The frequency of a note that is one octave higher than a note of 1024 Hz is

A:

Q: QUESTION 16 What is the TRACE on an Oscilliscop O Shape of the waveform O peak-to-peak voltage O…

A: The solution is given below

Q: x(t)=3cos 50.Tt +10sin 300.rr +3cos100.zr 1. Find sampling frequeney and 2. Find Nyquest rate

A:

Q: The crystal oscillator of Arduino UNO * is O 11.0592 MHz O 16 MHz O 14.7456 MHz 8 MHz

A: We need to select correct option for crystal oscillator .

Q: Determine the output waveform: 5V 10+ °R1 ´1k -10+ 10- 10+ 10- 5- -5- -10나 -10어 (A) (B) (C)

A:

Q: Q 2. Find the values of Rand C for the phase-shift oscillator in Figure 2 so that the oscillation…

A: According to question we have to find the value of R and C.

Q: 7. Draw the output waveform for a sinusoidal input Vin(pp) - 30V (Assuming D1 is Silicon diode & D2…

A: We need to find out the output voltage for given circuit

Q: er the eircutishewh below Clalek Ry2 lon 4=6

A:

Stator and Rotor Magnetic Field

The stator and rotor magnetic field is the resulting magnetic field generated by a system of coils that are symmetrically aligned. They are supplied with polyphase currents. The magnetic field is generated by poly-phase (two or more phases) current or single-phase current. In the latter case, two field stator windings are supplied and two resulting electromagnetic fields are generated beyond the stage.