can you explain the operation and need for voltage regulators and tap changers

Q: 4. Figure shows a 1-0 system with power source that feeds a 120 kVA 12.47/2.4 kV transformer through...

A:

Q: A nonmagnetic medium has an intrinsic impedance of 250∠30 Ω. Find a) Loss tangent b) Dielectric cons...

A: Given, Non magnetic medium has  Intrinsic impedance η=250∠30° ΩFrequency f=1 MHz

Q: Practice Problem 3.3 Find v and i in the circuit of Fig. 3.11. 6 V 4Ω Answer:-400 mV, 2.8 A. ww 14V ...

A: Supernode If an independent voltage source or a dependent voltage source is connected between two no...

Q: Draw the complete phasor diagram of a single-phase transformer when [i] the load in the secondary is...

A:

Q: A 7-kg iron shot is thrown 18 m. What was its minimum initial kinetic energy?

A: Let m= Mass of the Iron shot u= velocity R=Distance K= Kinetic Energy K=12m u2

Q: (b) A balanced Y-connected load has phase voltage of 230 V and positive phase sequence. The impedanc...

A: By using basic three phase balanced circuit expressions

Q: Given the following Resistances in Series and Voltage Source: R1 = 8 ohms R2 = 5 ohms R3 = 8 ohms...

A: If the resistors are connected in series then the total resistance is sum of all the resistance. By ...

Q: Q1 (a) Based on electrical DC circuit as depicted in Figure Q1(a), (i) Determine the mesh currents I...

A:

Q: 3. By applying the final-value theorem, find the final value of f(t) whose Laplace transform is give...

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please su...

Q: (1) a 1.33-H inductor in series with a 3-F capacitor (2) a 1.33-H inductor in parallel with a 3-F ca...

A:

Q: (a) Give THREE (3) advantages of a three-phase system compared to a single-phase system.

A:

Q: ww ww ww Question 1 Solve for the Equivalent Resistance, if R = 75. R a o 08 O 09 లెట్ కో Question 2

A:

Q: Inductance is often described as . (circle all that apply) The ability of a component to oppose a ch...

A: 1) The ability of component to opposes a change in current

Q: 20. Given ddc=0.98, determine Pate' Pac=120 , determine the coresponding value of d. © iven © aiven ...

A: The solution is given below 

Q: you tell me how circuit breakers and diconnect switches are used to isolate equipmen

A:

Q: For the system described by v() - 블피(0) + 를c0s (()) 글피(1) + 을cos(x(4)) where x(t) is the input and y...

A:

Q: What is the 3rd and 5th overtone for a 25MHz signal? Show your solution.

A:

Q: A 2-pole d.c shunt motor operating from a 200 V supply takes a full-load current of 35 A, the noload...

A: Given: A 2-pole d.c shunt motor operating from a 200 V supply takes a full-load current of 35 A, the...

Q: A CE amplifier uses a BJT with B = 100 biased at IC = 0.5 mA and has a collector resistance RC = 15 ...

A:

Q: Find V1, V2 & V3 in the given circuit below using KVL. V. 24v(土 V3 V1 = V2 V2 = V3 = 12V

A:

Q: In a purely inductive circuit, the inductor voltage and inductor current are 90 degrees out of phase...

A:

Q: Electrical pulses can be varied to represent characteristics of an analog voice signal. Propose ONE ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: (i) Determine the mesh currents I, I, Is and I, by using mesh analysis. Then calculate the branch cu...

A:

Q: Compare the maximum conversion times of a 8-bit digital-ram p ADC and a 8-bit successive- approximat...

A:

Q: For R1 = 1,613 Find the voltage on the capacitor indicated as v1 %3D 10 V 40 k2 40 k2 20 k2 33 k2 3 ...

A:

Q: output voltage waveform of the circuit.

A: Ideal diodes working in a circuit Ideally, diode is when forward biased- short circuited and when re...

Q: Determine the values of the power supplied by each of the sources in the circuit shown. 10 Ω 24 V + ...

A:

Q: How do you identify the anode of an unmarked diode? When the forward current of a diode increases, i...

A: How do you identify the anode of an unmarked diode? When the forward current of a diode increases, i...

Q: Calculate the inverse Fourier transform of the function, f(t) if F(w) = 200(jw+1) jw(jw+10)(2jw+4)

A: solve the problem

Q: R1 L4 Cs 5.625 mH 0.5 kN 112.5 pF L2 C3 R6 112.5иН 5.625 nF 0.5 k2

A: Circuit diagram is given as,

Q: A 30 ohms resistor is connected in parallel with a variable resistor R. The parallel combination is ...

A: From the given information, the circuit diagram is given as follows, 

Q: 20: Given Ldc=0.98 determine Baci O Gjiven Pdc =120 , determine the coresponding valve of d. © Guen ...

A:

Q: determine Ic if IE= 4m A . 190 Given ddc= O Determine dde if IE=2· 8mA , Ic =275MA and IerO = 0,998 ...

A:

Q: Calculate the hole and electron densities in a N-type germanium semiconductor at room temperature. T...

A: Given , conductivity σ = 500 S/cm μn =3800cm2/Vsμp = 1800 cm2/Vsni = 2.5x1013 /cm3 Now for the conce...

Q: When checked with an ohmmeter, how should a properly functioning capacitor measure between it's term...

A:

Q: Q1/ Reduce the following blóčk diágram Y (s) R(s) G3 H3 H, H

A: Block Diagram- Block diagram is the diagrammatic representation of any system or process in form of ...

Q: Q2 (a) In each case below, sketch two AC signals, V(t) and Vs(t), which have the same frequency, aga...

A:

Q: Q5/ Using Kirchhoff Laws for the circuit below determine the value and the direction of the current ...

A: KCL and KVL- Kirchhoff's current law states that the incoming current is equal to the outgoing curre...

Q: 4. The silicon whose length is 20 cm is subjected to an electric field of 25 volts. The velocity of ...

A:

Q: V (s) the circuit shown below, what is the transfer function H (s) = - V, (s) R, ww V, L

A:

Q: 4. Find VAD, and give the color code for all the resistors.

A:

Q: Identical 6 µC charges are located on the x-axis at x = 4 m and x = -4 m. Point A is on the y-axis a...

A:

Q: A CE amplifier uses a BJT with ß = 100 biased at IC = 0.5 mA and has a collector resistance RC = 15 ...

A:

Q: For this class AB amplifier with an output resistance of 5 Ohms and quiescent collector current of 2...

A: Given -  Output resistance = 5 Ohms Quiescent collector current = 2.5 mA

Q: 82 I2 ww 20 100V 10 202 152 V2 102

A: Parameters to analyze two-port network Impedance parameter Admittance parameter h parameter g param...

Q: In an ideal pn junction with an ideality factor of 1 at T = 300 K, the magnitude of the reverse-bias...

A:

Q: Five batteries are connected in parallel to supply a certain load. Each battery consist od 12 cells ...

A: Resistance: The power dissipation in resistive material occurs in the form of heat.

Q: Discuss the results of Waste Electrical and Electronic Equipment (WPRS)

A: when electrical and electronic equipment is not in use or broken and kept in a storage facility for ...

Q: tate the principle of Ac generator.

A: AC generator -  An alternating current generator (AC generator) is a system that transforms mechanic...

Q: Compute the 8- point DFT of the sequence r(n] = (8,–1,2, –-1,3,2,1,3) %3D Using DIT FFT algorithm.

A: Given: The sequence: xn=8,-1,2,-1,3,2,1,3 To find: Find the DFT of the sequence using the DIT-FFT al...

Gear Motor

A gear motor is a combination of a gearbox and an electric motor. This combination of two systems is used for efficient usage of the motor. It makes a cost-effective solution for high torque, low-speed applications. These motors are used in our household as, garage door openers, alarm clocks. In commercial areas, hospital beds, cranes.