Calculate the voltage and current of the inductance and the voltage and current for the capacitance and draw a graph between the current and the voltage for the capacitance and inductance and the angle for each.

Q: A resistance R, capacitance C, and inductance L are connectedin series to a voltage source with…

A:

Q: Calculate the value of the resistor in ohms that must be connected in parallel with a 6 µF capacitor…

A: The power factor in a parallel RC circuit:- Power factor=ZR Here, Z is the impedance of the parallel…

Q: Consider an AC circuit consisting of an AC voltage source, a 30-W resistor, a 450-mF capacitor, and…

A: Given, resistance = 30 ohms capacitance = 450 mF inductance = 0.35 H

Q: A capacitor is connected across the terminals of an ac generator that has a frequency of 440 Hz and…

A: Current across the capacitor 1 is

Q: nswer the question 11 .  ?

A: Given that the ratio of the energy stored in a capacitor to the total energy id 0.20= UcUtotal= 0.2

Q: Capacitors have the opposite effect on AC circuits that inductors have. Explain this statement.

A: The difference in the effect of capacitor and inductors on AC circuits are given below. (a)…

Q: purely resistive RLC series purely inductive purely capacitive

A: The current is in phase with voltage in this graph.

Q: Can a circuit element have both capacitance and inductance?

A: No, it is not possible that a circuit element has both capacitance and inductance.

Q: A 25.0 mH inductor, a 2.00 microFarad capacitor, and a certain resistor are connected in series…

A:

Q: The voltage difference between the two ends of an inductive circuit is 110 volts, what is the value…

A: Given that  V = 110 volt i = 9 amp f = 7Hz Question ? L = ?

Q: In an LC oscillator, the inductance of the inductor is 2.0 H and the capacitance of the capacitor is…

A: The maximum current through the inductor can be found out by using the law of conservation of…

Q: Consider an RLC circuit with resistance 2 ohms, inductance 0.05 henrys, capacitance 0.006 farads,…

A: Given that, For an RLC circuit the resistance of the resistor is R=2Ω The capacitance of the…

Q: An ac generator produces a peak voltage of 75 V. What is the rmsvoltage of this generator?

A: As we know , RMS voltage of the generator is : VRMS=ρeak voltage2

Q: In the given circuit, four identical resistors with resistance R= 3 ohm, one inductor with…

A: Given data: The resistance of resistor is R=3 Ω. The inductance of inductor is L=4 mH. The…

Q: In an alternating current circuit, the current amplitude versus the driving angular frequency wa is…

A:

Q: A üme plot of the voltages across an inductor (dashed), capacitor (dotted), and resistor (solid) of…

A:

Q: What is the capacitance of an oscillating LC circuit in nanofarads if the maximum charge on the…

A: Given that:Q=1.5 μCU=168 μJ

Q: A resistor, an inductor, and a capacitor are connected in series to an AC source.  What is the…

A: The question is asking for the condition under which resonance occurs in a series RLC circuit.…

Q: What is the impedance ZC of a 40microF capacitor at a frequency of 20kHz in an LRC circuit? How does…

A: C = 40 micro F f = 20 kHz

Q: A series LRC ac circuit  has a resistance of 4.0 kilo-Ohms, a capacitance of 33.0 mocroFarads, and…

A:

Q: In an LC oscillator, the inductance of the inductor is 2.0 H and the capacitance of the capacitor is…

A: Inductance (L) = 2 HC = 50×10-6 FVmax,C = 2 volts

Q: resistor, a 1.2-F capacitor and a 2.5-Henry inductor are connected in series with a 9.0 Hz voltage…

A: Given:- The resistance R = 4.1 ohm  The capacitance C = 1.2 F  The inductor L = 2.5 H  The…

Q: A series circuit contains a 20 ohm resistor and a capacitor with a capacitance of 110 5 uf if it has…

A: Impedence =R2+ X2where X represent the capacitive reactence.X=1ωC   ( the value of capacitance best…

Q: 69 : An A.C. voltage of 230 V, 50 Hz is oplied across a series combination of twa enry inductance…

A: Given Data The voltage is:E=230 V The frequency is:f=50 Hz The inductance is:L=2H To find: The…

Q: A 30V electromotive force is applied to an LR series circuit with .1 henrys of inductance and 50…

A: The expression for the LR series circuit is,

Q: The resonant frequency

A:

Q: PR (W) 4.0- 2.0- t (ms 10 20 30 in

A: Introduction: The frequency of the wave is defined as the number of cycles per unit time, and the…

Q: The total impedance of a circuit decreases when an inductor is added in series to an RC circuit…

A:

Q: The maximum voltage in  AC circuit is 100V . What is the effective voltage in circuit

A:

Q: For the coaxial line filled with two dielectric media as shown in figure below, a) Find the…

A: Given:inner radius of the conductor, adielectric 1, has permittivity, ε1it has a radius of…

Q: why does a capacitor block DC but pass AC?

A: The frequency of the direct current is zero.

Q: If an inductor and a capacitor are connected in parallel with each other, and then briefly energized…

A: A tank circuit's natural frequency, called the resonant frequency, is determined by the size of the…

Q: What kind of circuit is having a closed loop with inductor and a capacitor? Why is AC dangerous than…

A: Answer:-  (1) An LC circuit is a closed loop with just two elements: a capacitor and an inductor. An…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.